Dipartimento di Geoscienze, Università di Padova
8 results
Filters
Settings
The search returned 8 results
Now showing 1 - 8 of 8
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , An integrated platform for thermal maturity assessment of polyphase, long-lasting sedimentary basins, from classical to brand-new thermal parameters and models: An example from the on-shore Baltic Basin (Poland)
Paleo-thermometers in sedimentary basins often drive to misleading thermal modelling when applied alone or only on potentially productive Paleozoic source rocks. Different paleo-thermal and thermo-chronological data have been used as constraints to model the Silurian to Cenozoic succession of a recently drilled well in the onshore portion of the Baltic Basin, in northern Poland. This dataset provides an integrated platform for thermal maturity assessment contributing to the highly debated reconstruction of the thermal history of the Baltic Basin in the last decade. The well stratigraphy consists of a Lower Paleozoic marine clayey and arenaceous/calcareous succession, about 1000 m thick that is unconformably overlain by a 2000 m thick Permian to Cenozoic sequence, developed in a continental to shallow marine environment. Optical microscopy, FT-IR and Raman spectroscopy analysis of organic matter have been coupled with (U–Th)/He data to produce a robust vitrinite reflectance profile and constrain the 1D thermal modelling of the well. In addition, such a thermal maturity profile was validated by an independent thermal modelling calibrated by the smectite illitization kinetics. Both models identify high heat flow conditions (up to 1.7 HFU) at the end of Mesozoic. The Lower Paleozoic succession entered the late oil window of HC generation during this last heating event.233 3 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Mechanical behaviour of fluid-lubricated faults
Fluids are pervasive in fault zones cutting the Earth's crust; however, the effect of fluid viscosity on fault mechanics is mainly conjectured by theoretical models. We present friction experiments performed on both dry and fluid-permeated silicate and carbonate bearing-rocks, at normal effective stresses up to 20 MPa, with a slip-rate ranging between 10 μm/s and 1 m/s. Four different fluid viscosities were tested. We show that both static and dynamic friction coefficients decrease with viscosity and that dynamic friction depends on the dimensionless Sommerfeld number (S) as predicted by the elastohydrodynamic-lubrication theory (EHD).Under favourable conditions (depending on the fluid viscosity (η), co-seismic slip-rate (V), fault geometry (L/H02) and earthquake nucleation depth (∝σeff)), EHD might be an effective weakening mechanism during natural and induced earthquakes. However, at seismic slip-rate, the slip weakening distance (Dc) increases markedly for a range of fluid viscosities expected in the Earth, potentially favouring slow-slip rather than rupture propagation for small to moderate earthquakes.132 118 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The lower to Middle Pleistocene Valle di Manche section (Calabria, Southern Italy): State of the art and current advances
(2015-01-02); ; ; ; Capraro, L.; Dipartimento di Geoscienze, Università di PadovaThe Valle di Manche (VdM) section represents one of the best-documented on-land marine records of the Early to Middle (E/M) Pleistocene transition available to date. Accordingly, the VdM succession is among the few appropriate candidates to host the GSSP of the Middle Pleistocene (“Ionian”) Stage. In particular, the VdM section uniquely documents the Matuyama-Brunhes magnetic reversal (mid-MIS 19), which is agreed to be the main criterion for defining the chronostratigraphic position of the base of the Middle Pleistocene. The section also yields a wide range of chronological, paleoclimatic and stratigraphic data sets that allow long-distance correlation with both marine and terrestrial reference records. Notably, the stratigraphy across the MIS 19 interglacial is greatly expanded, permitting a precise and detailed investigation of this critical interval. The section is also easy to reach, and fortunately the exposure is destined to persist. Therefore, the section fulfills the essential requirements to host the GSSP for the “Ionian” Stage and Middle Pleistocene Subseries. We suggest that the GSSP be placed at the base of the “Pitagora ash”, a prominent bed that occurs in mid-MIS 19, close to the MatuyamaeBrunhes magnetic reversal. Here, we present and discuss scientific information gathered in the past two decades, and give a preliminary account of the work to which we are presently committed, that aims at improving our knowledge on the VdM section.360 81 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , A major change in the sedimentation regime in the Crotone Basin (Southern Italy) around 3.7-3.6 Ma
(2013-09-27); ; ; ; The Lower Pliocene succession of the Crotone Basin (Calabrian Arc, Southern Italy) is mainly comprised of blue-grey marly clay with good magnetic properties. Here the bio-magnetostratigraphic data indicate a mean sedimentation rate of about 12–15 cm/kyr. Around 3.7–3.6 Ma a major change in the sedimentation regime occurred: the blue-grey hemipelagic marls grade rapidly into silty marls with a significant increase in the terrigenous fraction and with abundant siliceous remains throughout the whole interval. Magnetic properties of these sediments are very poor, but an integrated calcareous plankton biostratigraphy (foraminifera and nannofossils) infers a high average sedimentation rate (about 50–60 cm/kyr). The abrupt onset of this sedimentation regime in the Crotone Basin is contemporaneous with a major unconformity already recognized in the northern sector of the basin, part of amajor reorganization phase in the whole Apenninic–Maghrebid Chain known as “Globorotalia puncticulata event”. Reports of coeval siliceous sediments in other marginal basins of the Apennines (Southern Calabria, Southern and Northern Apennines) suggest that this “siliceous event” might have been regionally extensive, having important palaeoceanographical implications.We infer that the “siliceous event” is characterized by a combined tectonic- and climate-induced change in palaeoceanographic conditions. The tectonic triggering factors may have been linked to two synchronous events in the Tyrrhenian–Apennine system: 1) the shortening event also known as “G. puncticulata event”, and 2) the coeval opening of the Vavilov Basin in the Tyrrhenian Sea which yielded profound influences in terms of physiography and characteristics of the Crotone Basin. The consequent uplift of the Southern Apennines would have increased sediment supply and availability of silica, resulting in eutrophication and enhanced silica preservation. Strong winter mixing and possibly upwelling conditions could have increased primary productivity during heavy isotope stages Gi4, Gi2 and MG8, at the onset of the “siliceous event”. This important event, lasting from ca. 3.6 Ma to ca. 3.2 Ma, would have recorded a peculiar transitional period before further climatic deterioration and more drastic palaeoceanographic changes occurred around 3.1 Ma, leading to cyclic sapropel deposition in the whole of the Mediterranean sea.276 45 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Remote Sensing and Geodetic Measurements for Volcanic Slope Monitoring: Surface Variations Measured at Northern Flank of La Fossa Cone (Vulcano Island, Italy)
(2013-05-13); ; ; ; Abstract: Results of recent monitoring activities on potentially unstable areas of the NW volcano flank of La Fossa cone (Vulcano Island, Italy) are shown here. They are obtained by integration of data by aerial photogrammetry, terrestrial laser scanning (TLS) and GPS taken in the 1996–2011 time span. A comparison between multi-temporal models built from remote sensing data (photogrammetry and TLS) highlights areas characterized by ~7–10 cm/y positive differences (i.e., elevation increase) in the upper crown of the slope. The GPS measurements confirm these results. Areas characterized by negative differences, related to both mass collapses or small surface lowering, also exist. The higher differences, positive and negative, are always observed in zones affected by higher fumarolic activity. In the 2010–2012 time span, ground motions in the northern part of the crater rim, immediately above the upper part of observed area, are also observed. The results show different trends for both vertical and horizontal displacements of points distributed along the rim, with a magnitude of some centimeters, thus revealing a complex kinematics. A slope stability analysis shows that the safety factors estimated from these data do not OPEN ACCESS Remote Sens. 2013, 5 2239 indicate evidence of possible imminent failures. Nevertheless, new time series are needed to detect possible changes with the time of the stability conditions, and the monitoring has to go on.542 210 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , A laser scanning-based method for fast estimation of seismic-induced building deformations
(2013-02-28); ; ; ; Monitoring damaged buildings in an area where an earthquake has occurred requires the use of techniques which provide rapid and safe measurements even in emergency conditions. In particular, remote sensing techniques like terrestrial laser scanning (TLS) can satisfy these requirements, since they produce very dense point clouds in little time and also allow an accurate geometric modeling of observed buildings. Nevertheless, strong constraints on TLS data acquisition geometry, such as acquisition distance and incidence angles, typically characterize an area in seismic emergency conditions. In order to correctly interpret the data, it is necessary to estimate errors affecting TLS measurements in these critical conditions. A reliable estimation can be achieved by means of experiments and numerical simulations aimed at quantifying a realistic noise level, with emphasis on reduction of artifacts due to data acquisition, registration and modeling. This paper proposes a data analysis strategy in which TLS-based morphological maps computed as point-to-primitive differences are created. The method can be easily used for accurate surveying in emergency conditions. In order to demonstrate the proposed method in very diverse situations, it was applied to rapidly detect deformation traces in the San Giacomo Roncole Campanile (Modena), the Asinelli tower (Bologna) and the Cantalovo Church (Verona), three buildings damaged by the Mw 5.9 Emilia Romagna 2012 earthquake (Italy). 2013 International Society for Photogrammetry and Remote Sensing, Inc. (ISPRS) Published by Elsevier543 27 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , The survey and mapping of sand-boil landforms related to the Emilia 2012 earthquakes: preliminary results
(2012); ; ; ; Sand boils, which are also known as sand blows or sand volcanoes, are among the most common superficial effects induced by high-magnitude earthquakes. These generally occur in or close to alluvial plains when a strong earthquake (M >5) strikes on a lens of saturated and unconsolidated sand deposits that are constrained between silt-clay layers [Ambraseys 1988, Carter and Seed 1988, Galli 2000, Tuttle 2001, Obermeier et al. 2005], where the sediments are converted into a fluid suspension. The liquefaction phenomena requires the presence of saturated and uncompacted sand, and a groundwater table near the ground surface. This geological– geomorphological setting is common and widespread for the Po Plain (Italy) [Castiglioni et al. 1997]. The Po Plain (ca. 46,000 km2) represents 15% of the Italian territory. It hosts a population of about 20 million people (mean density of 450 people/km2) and many infrastructures. Thus, the Po Plain is an area of high vulnerability when considering the liquefaction potential in the case of a strong earthquake. Despite the potential, such phenomena are rarely observed in northern Italy [Cavallin et al. 1977, Galli 2000], because strong earthquakes are not frequent in this region; e.g., historical data report soil liquefaction near Ferrara in 1570 (M 5.3) and in Argenta 1624 (M 5.5) [Prestininzi and Romeo 2000, Galli 2000]. In the Emilia quakes of May 20 and 29, 2012, the most widespread coseismic effects were soil liquefaction and ground cracks, which occurred over wide areas in the Provinces of Modena, Ferrara, Bologna, Reggio Emilia and Mantova (Figure 1). These were the causes of considerable damage to buildings and the infrastructure. The soil liquefaction and ground cracks were accompanied by sand boils, which are described in this report. The spatial distribution and geomorphological setting of sand boils and ground cracks are also described here. A detailed three-dimensional (3D) reconstruction of these features is also presented, which was carried out using terrestrial photogrammetry. Since archeological times, fluvial ridges, and in general sandy deposits on low plains have been the preferred sites for human infrastructure, colonial houses, roads, etc. Therefore, it is very important to understand how the local topography/ morphology interacts in the liquefaction processes. Numerous distinctive seismic landforms were generated by the May 2012 strong earthquakes (seven with M >5), and in particular, sand boils and ground fractures. The sand-boil landforms, also known as sand craters or sand volcanoes, are formed by low mounds of sand that have been extruded from fractures [Tuttle 2001]. The cone is a generally shortlived structure that naturally collapses, starting from the center holes that mark the water retreat back into the fracture. Sand boils also occurred along larger cracks (with decimetric lateral and vertical displacements). Here, the upper scarps block the formation of craters and allow the deposition of a sandy layer several centimeters thick (e.g. ca. 4 cm in the San Carlo crack), on the lower side of the steep slope. These landforms are highly vulnerable to erosion. After a few weeks, they are washed out by rain, destroyed by human activity, or masked by growing crops. Thus, ground surveys that investigate these events have to be carried out as soon as possible [Panizza et al. 1981]. In this report, we present preliminary results using methods to map the detailed micro-morphology of some representative liquefaction features (Figure 2) that normally disappear for the aforementioned reasons, or that are recorded only in qualitative terms.174 4712 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , “Nanogranite” and glassy inclusions: The anatectic melt in migmatites and granulites
(2009-10-05); ; ; ; Using as a case study a granulite from the Kerala Khondalite Belt, India, we show that a former anatectic melt can be preserved as tiny (<25 μm) droplets within refractory minerals,in this case garnet. The melt is either fully crystallized as a Qtz-Ab-Kfs-Bt cryptocrystalline aggregate (“nanogranite”), or completely glassy in inclusions <15 μm. Both nanogranite and glassy inclusions have a peraluminous, ultrapotassic granitic composition that, in this case, does not correspond to a “minimum melt” and points to high melting temperatures, in agreement with the ultrahigh-temperature origin of the rock. This discovery indicates that peritectic minerals, growing during incongruent melting reactions, act as hosts for inclusions of anatectic melt, and that in the general case of slow cooling of the crust these inclusions will occur as nanogranite. Exceptionally, in the smallest inclusions, glass may be present due to inhibition of crystallization. Our results extend the frontiers of petrological and geochemical research in crustal melting, as the composition of natural anatectic melts can be directly analyzed rather than assumed.149 20
