Emolo, Antonio
Preferred name
Emolo, Antonio
ORCID
35 results
Filters
Settings
The search returned 35 results
Now showing 1 - 10 of 35
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Investigating Rupture Direction for Three 2012 Moderate Earthquakes in Northern Italy from Inversion of Peak Ground-Motion Parameters
(2012-12); ; ;Convertito, V.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione OV, Napoli, Italia ;Emolo, A.; Università di Napoli, Federico II, Dip. Scienze FisicheWe investigate the possibility of inferring the dominant horizontalrupture direction for moderate earthquakes from the inversion of peak ground-motion parameters. To this aim, we adopt a technique that was devised and applied to large earthquakes for retrieving both the dominant rupture direction and the surface fault projection to be used with a proper distance metric to refine the ShakeMap computation. In the present paper, the procedure was applied to three moderate earthquakes that occurred in 2012 in Northern Italy three days apart: the M 4.2 Pre-Alpi Venete earthquake on 24 January, the M 4.9 Reggio Emilia earthquake on 25 January, and the M 5.4 Parma earthquake on 27 January. For two of the three analyzed events, the technique identifies a dominant horizontal-rupture direction, which is consistent with the strike directions inferred from the focal mechanisms. For theM 5.4 event, which is a deep (about 61 km) thrust-faulting mechanism earthquake, the inferred dominant rupture direction allows identification of the northeast-dipping plane as the fault plane in accordance with the aftershocks distribution.182 31 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Development and Testing of an Advanced Monitoring Infrastructure (ISNet) for Seismic Early-warning Applications in the Campania Region of Southern Italy
(2007); ; ; ; In the framework of an ongoing project financed by the Campania Region, a prototype system for seismic early and post-event warning is being developed and tested, based on a dense, wide dynamic seismic network (ISNet) and under installation in the Apennine belt region. This paper reports the characteristics of the seismic network, focussing on the required technological innovation of the different seismic network components (data-logger, sensors and data communication). To ensure a highly dynamic recording range, each station is equipped with two types of sensors: a strong-motion accelerometer and a velocimeter. Data acquisition at the seismic stations is performed using Osiris-6 model data-loggers made by Agecodagis. Each station is supplied with two (120 W) solar panels and two 130 Ah gel cell batteries, ensuring 72-h autonomy for the seismic and radio communication equipment. The site is also equipped with a GSM/GPRS programmable control/alarm system connected to several environmental sensors (door forcing, solar panel controller, battery, fire, etc) and through which the site status is known in real time. The data are stored locally on the hard-disk and, at the same time, continuously transmitted by the SeedLink protocol to local acquisition/analysis nodes (Local Control Center) via Wireless LAN bridge. At each LCC site runs a linux Earthworm system which stores and manages the acquired data stream. The real-time analysis system will perform event detection and localization based on triggers coming from data-loggers and parametric information coming from the other LCCs. Once an event is detected, the system will performs automatic magnitude and focal mechanism estimations. In the immediate post-event period, the RISSC performs shaking map calculations using parameters from the LCCs and/or data from the event database. The recorded earthquake data are stored into an event database, to be available for distribution and visualization for further off-line analyses. The seismic network will be completed in two stages: • Deployment of 30 seismic stations along the southern Apennine chain (to date almost completed) • Setting up a carrier-class radio communication system for fast and reliable data transmission, and installation of 10 additional seismic stations.239 70 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , 234 26 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The Effectiveness of a Distant Accelerometer Array to Compute Seismic Source Parameters: The April 2009 L'Aquila Earthquake Case History
(2011); ; ; ; The seismic sequence that occurred in the Abruzzo Apennines near L’Aquila (Italy) in April 2009 caused extensive damage and a large number of casual- ties (more than 300). The earthquake struck an area in the Italian Apennines chain where several faults, belonging to adjacent seismotectonic domains, create a complex tectonic regime resulting from the interaction among regional stress buildup, local stress changes caused by individual earthquakes, and viscous-elastic stress relaxation. Understanding such complex interaction in the Apennines can lead to a large step for- ward in the seismic risk mitigation in Italy. The Abruzzo earthquake has been very well recorded by interferometric synthetic aperture radar (InSAR) data, much better than the first Italian earthquake ever recorded by satellites, namely, the 1997 Umbria–Marche earthquake. ENVISAT (ENVIronmental SATellite) data for the Abruzzo earthquake are, in fact, very clear and allow an accurate reconstruction of the faulting mechanism. We present here an accurate inversion of vertical deformation data obtained by ENVISAT images, aimed to give a detailed reconstruction of the fault geometry and slip distribu- tion. The resulting fault models are then used to compute, by a suitable theoretical model based on the elastic dislocation theory, the stress changes induced on the neigh- boring faults. The correlation of the subsequent mainshocks and aftershocks of the Abruzzo sequence with the volumes undergoing increasing Coulomb stress clearly evidence the triggering effect of coseismic stress changes on further seismicity. More- over, this analysis put in evidence which seismotectonic domains have been more heav- ily charged by stress released by the Abruzzo mainshocks. The most important faults significantly charged by the Abruzzo sequence belong to the Sulmona and Avezzano tectonic domains. Taking into account the average regional stress buildup in the area, the positive Coulomb stress changes caused by this earthquake can be seen as antici- pating the next earthquakes in the neighboring domains of 15–20 yr.295 22 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Insights into Mechanical Properties of the 1980 Irpinia Fault System from the Analysis of a Seismic Sequence
Seismic sequences are a powerful tool to locally infer geometrical and mechanical properties of faults and fault systems. In this study, we provided detailed location and characterization of events of the 3–7 July 2020 Irpinia sequence (southern Italy) that occurred at the northern tip of the main segment that ruptured during the 1980 Irpinia earthquake. Using an autocorrelation technique, we detected more than 340 events within the sequence, with local magnitude ranging between −0.5 and 3.0. We thus provided double difference locations, source parameter estimation, and focal mechanisms determination for the largest quality events. We found that the sequence ruptured an asperity with a size of about 800 m, along a fault structure having a strike compatible with the one of the main segments of the 1980 Irpinia earthquake, and a dip of 50–55° at depth of 10.5–12 km and 60–65° at shallower depths (7.5–9 km). Low stress drop release (average of 0.64 MPa) indicates a fluid-driven initiation mechanism of the sequence. We also evaluated the performance of the earthquake early warning systems running in real-time during the sequence, retrieving a minimum size for the blind zone in the area of about 15 km.43 95 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Ground-motion simulations within ShakeMap methodology: application to the 2008 Iwate-Miyagi Nairiku (Japan) and 1980 Irpinia (Italy) earthquakes
(2013); ; ; ; ShakeMap package uses empirical Ground Motion Prediction Equations (GMPEs) to estimate the ground motion where recorded data are not available. Recorded and estimated values are then interpolated in order to produce a shaking map associated with the seismic event of interest. The ShakeMap approach better works in regions with dense stations coverage, where the observed ground motions adequately constrain the interpolation. In poorly instrumented regions, the ground motion estimate mainly relies on the GMPE, that account only for average characteristics of source and wave propagation processes. In this study we investigated the improvement of ShakeMap in the near fault area when including synthetic estimates. We focus on the 2008, Mw 7.0, Iwate-Miyagi Nairiku (Japan) earthquake as a case study because recorded by a huge number of stations. As first we calculated the shakemaps to be used as reference maps and then removed several subsets of stations from the original data-set, replacing them with: (i) the estimations of the ground motion obtained by using a specific GMPE valid for that area, using simple source information such as the earthquake magnitude and fault geometry; (ii) the peak values from synthetic time-histories computed with a hybrid deterministic-stochastic method for extended fault, using the rupture fault model obtained from the kinematic source inversion of strong-motion records. We evaluate the deviations from the reference map and the sensitivity to the number of sites where recordings are not available. Our results show that shakemaps are more and more reliable as the coverage of stations is dense and uniformly distributed in the near-source area. Moreover, the synthetics account for propagation and source properties in a more correct way than GMPE, and largely improve the results. The hybrid maps reach good fitting levels especially when synthetics are used to integrate real data and for particular strong-motion parameters and stations’ distribution.326 639 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Inferences on the source mechanisms of the 1930 Irpinia (Southern Italy) earthquake from simulations of the kinematic rupture process
(2004); ; ; ; Emolo, A.; Dipartimento di Scienze Fisiche, Università degli Studi di Napoli «Federico II», Napoli, ItalyWe examine here a number of parameters that define the source of the earthquake that occurred on 23rd July 1930 in Southern Italy (in the Irpinia region). Starting from the source models proposed in different studies, we have simulated the acceleration field for each hypothesized model, and compared it with the macroseismic data. We then used the hybrid stochastic-deterministic technique proposed by Zollo et al. (1997) for the simulation of the ground motion associated with the rupture of an extended fault. The accelerations simulated for several sites were associated with the intensities using the empirical relationship proposed by Trifunac and Brady (1975), before being compared with the available data from the macroseismic catalogue. A good reproduction of the macroseismic field is provided by a normal fault striking in Apenninic direction (approximately NW-SE) and dipping 55° toward the SW.154 413 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Accelerometric radiation simulation for the September 26, 1997 Umbria-Marche (Central Italy) main shocks
(2001-06); ; ;Emolo, A.; Dipartimento di Scienze Fisiche, Università "Federico II", Napoli, Italy ;Zollo, A.; Dipartimento di Scienze Fisiche, Università "Federico II", Napoli, ItalyWe applied a hybrid stochastic-deterministic method to simulate the strong ground motion characteristics associated with the September 26, 1997 Umbria-Marche main shocks. One hundred different rupture processes on previously inferred fault planes were simulated. The maps of computed PGA (mean values from 100 simulations) show a SE alignment for the 00:33 event and a NW alignment for the 09:40 event, in accordance with the macroseismic data. Moreover, we found a good agreement between the predicted 1ó interval for the PGA values and the data recorded at several accelerometric stations. As a further test, we computed the response spectra at the station Cerreto di Spoleto and found a satisfactory agreement with the synthetic results.157 608 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , An Empirical Formula to Classify the Quality of Earthquake Locations
Providing a quantitative estimate of earthquake location quality is not a simple task. Traditional methods, used in literature, are not exhaustive and depend on a subjective point of view, because they consist of empirical choice of quality thresh- olds of different estimators of location uncertainty. However, we notice that these estimators are correlated with one another, implying the need to combine them to obtain a numerical and impartial estimate of the quality of a seismic location. Therefore, we provide a formula that associates a quality factor (q f ) value with a seismic location, which is based on the combination of a set of uncertainty estimators, suitably normalized. We apply the criterion to two different-type and different-scale earthquake catalogs, located by two different methods, obtaining encouraging results. The q f parameter definition is a fast, simple, and objective instrument to provide a user-friendly classification of location quality. Thus, the q f could represent a powerful tool for routine monitoring location computation.250 281 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Directivity effects for moderate-magnitude earthquakes (Mw 5.6–6.0) during the 1997 Umbria–Marche sequence, central Italy
(2009-10-15); ; ; ; The Colfiorito Mw 6.0 (September 26, 1997, 09:40 UTC) and the Sellano Mw 5.6 (October 14, 1997) normal faulting earthquakes are the two strongest events of the 1997–1998 Umbria–Marche seismic sequence (central Italy). They provided accelerograms recorded at epicentral distances within nearly two fault lengths. Previous studies on these events revealed clear evidence of unilateral rupture propagation and directivity effects on the source time functions We developed an approximate procedure to correct the observed peak ground motion for the site effects, and we found a systematic increase of peak ground acceleration (PGA) and peak ground velocity (PGV) at sites located in the direction of the rupture propagation respect to the stations located to the backward. In particularwe showed that, for the Colfiorito earthquake, the average PGV at the north-west sites is 2.8 times larger than the PGV at south-east sites (2.1 for PGA); an opposite behaviour is found during the Sellano earthquake, with an amplification factor of about 1.9 for PGV (1.5 for PGA) recorded at south-east sites respect to the north-west stations.We explained these behaviours in terms of directivity effect, by comparing recorded ground accelerations with synthetics simulated by a deterministic–stochastic technique. This method computes high-frequency ground motions (fN0.5 Hz) from extended faults, generalizing the point-source stochastic method to capture the essence of near-source effects. The synthetic PGAs decrease with distance in agreement with the ground-motion empirical predictive model available for the area and describe the azimuthal variation of recorded data in terms of source effects.185 27
