Skip to main content
The search returned 6 results
Now showing 1 - 6 of 6
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    A meta-analysis of fault slip rates across the central Apennines

    Several methods such as paleoseismic trenching, mapping of offset geomorphic markers, and dating of scarp profiles have been used to determine slip rates of normal faults in the central Apennines. Combining measurements obtained with different methods remains challenging because non-tectonic processes can introduce noise or spurious signals that are elusive to quantify, and these influence slip rate estimates. To this end, we meta-analyzed throw measurements with associated ages collected in the central Apennines with several methods to quantify such erratic fluctuations and method-related variances. We show that throw rates are overdispersed with respect to nominal uncertainties in throw and age; therefore, they are commonly affected by unmodeled noise processes. After comparing throw rate distributions sampling the same faults with different techniques, no clear spatiotemporal patterns appear, but only quasi-random noise. Assuming that field investigators sampled real tectonic features (i.e., fault scarps), we find that such erratic throw rates indicate total uncertainties are two to three times greater than the stated observation uncertainties. In this situation, a simple and robust null hypothesis is appropriate. We propose that most faults should be assumed to have uniform throw rate along their traces, except for possible tapering near unconnected ends. We also propose that models in which throw rates are time-dependent (within the last 25 ka) are not yet justified. Then, relying on the estimated total uncertainties, we determine the most probable long-term fault throw rate for each active fault by combining different throw-rate probability density functions.
      146  135
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Earthquake Rupture Forecasts for the MPS19 Seismic Hazard Model of Italy

    In recent years, new approaches for developing earthquake rupture forecasts (ERFs) have been proposed to be used as an input for probabilistic seismic hazard assessment (PSHA). Zone- based approaches with seismicity rates derived from earthquake catalogs are commonly used in many countries as the standard for national seismic hazard models. In Italy, a single zone- based ERF is currently the basis for the official seismic hazard model. In this contribution, we present eleven new ERFs, including five zone-based, two smoothed seismicity-based, two fault- based, and two geodetic-based, used for a new PSH model in Italy. The ERFs were tested against observed seismicity and were subject to an elicitation procedure by a panel of PSHA experts to verify the scientific robustness and consistency of the forecasts with respect to the observations. Tests and elicitation were finalized to weight the ERFs. The results show a good response to the new inputs to observed seismicity in the last few centuries. The entire approach was a first attempt to build a community-based set of ERFs for an Italian PSHA model. The project involved a large number of seismic hazard practitioners, with their knowledge and experience, and the development of different models to capture and explore a large range of epistemic uncertainties in building ERFs, and represents an important step forward for the new national seismic hazard model.
      3092  170
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Partitioning the Ongoing Extension of the Central Apennines (Italy): Fault Slip Rates and Bulk Deformation Rates From Geodetic and Stress Data

    We investigated whether the joint inversion of geodetic and stress direction data can constrain long‐term fault slip rates in the central Apennines, and ultimately how extension is partitioned among fault slip and bulk lithosphere permanent strain. Geodetic velocities are collected in the fault interseismic stage with steady secular deformation; thus, long‐term estimates can be derived with a model of elastically unloading seismogenic faults within a viscously deforming lithosphere. As the average spacing of permanent Global Navigation Satellite Systems (GNSS) stations is similar to the average length of seismogenic faults (25–35 km), if not larger, we decided to merge permanent and temporary GNSS measurements, resulting in a denser geodetic data set. Given that most normal faults in the Apennines have slip rates around or below 1 mm/a, and most campaign GNSS velocities carry similar uncertainties, simple local back slip models cannot be applied. More sophisticated modeling is required to extract reasonable bulk deformation rates and long‐term fault slip rates at signal‐to‐noise ratio of order unity. Given the spatial distribution of the GNSS network, we estimated the long‐term slip rate of seven major fault systems that are in satisfactory agreement with available geological slip rates. The resulting spatial distribution of bulk deformation rates locally fits short‐term transients; in other cases, they represent the currently unclear signature of tectonic processes like upper‐crustal viscoplastic deformation and aseismic slip, or indicate missing faults in the adopted database. We conclude that the time is ripe for determining fault slip rates using geodetic and stress direction data, particularly where fault activity rates are hard to determine geologically.
      479  400
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    A “Geodetic Gap” in the Calabrian Arc: Evidence for a Locked Subduction Megathrust?

    Subduction of old Ionian seafloor beneath the Calabrian Arc (southern Italy) is the geological process with the greatest mass flux in the central Mediterranean, yet its seismogenic behavior is largely obscured. No unambiguous evidence of subduction-related earthquakes exists in historical times, and local GPS velocities indicate very low strain rates. Nevertheless, the region hosted some of the deadliest normal-faulting earthquakes of the entire Mediterranean basin. We show that the low strain rates recorded in southern Calabria can be reconciled with the regional vigorous seismic moment release by assuming high interseismic coupling but low seismic coupling of the subduction interface. The alternative scenario of steadily creeping subduction cannot be ruled out but requires the historical seismicity record to be dismissed as unrepresentative. We refer to the peculiar spatial pattern of short-term strain rates in southern Calabria as a “geodetic gap” resulting from destructive interference between upper-plate extension and temporary compression due to locking along the subduction interface. Seismic hazard modelers must understand that within such gaps, the long-term seismic hazard is greater than that suggested by the low geodetic strain rates.
      552  187
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Assessing the seismic coupling of shallow continental faults and its impact on seismic hazard estimates: a case-study from Italy

    We propose an objective and reproducible algorithmic path to forecast seismicity in Italy from long-term deformation models. These models are appropriate for Italy and its neighbouring countries and seas thanks to the availability of rich, reliable and regularly updated historical earthquake and seismogenic fault databases, and to the density of permanent GPS stations. However, so far little has been done to assess the seismic coupling of Italian active faults, that is to quantify their ability to release earthquakes. This must be determined in order to use geodetic and active faulting observations in alternative seismicity models, to overcome possible limitations of the earthquake record for the assessment of seismic hazard. We use a probabilistic method to assign upper crustal earthquakes from the historical catalogue to their presumed causative faults, then collect all the events into three subcatalogues corresponding to the compressional, extensional and strike-slip faulting classes. We then determine the parameters of their Gutenberg–Richter frequency/magnitude relations using maximum-likelihood methods and integrate these distributions to estimate the long-term seismic moment rate for each class. Finally, we compare these seismicity rates to the long-term tectonic deformation based on GPS data, thus determining the coupled thickness (and estimating seismic coupling) for each fault class. We find that in our study region the seismic coupling and the related coupled thickness is on average two times larger for extensional than for compressional faults. As for the spatial distribution of earthquake rates, a larger number of events is predicted for the extensional settings of the Apennines chain, in agreement with the inferred seismic coupling but also with the long-term strain rates. We also find that the frequency/magnitude distributions indicate that the largest earthquakes occur in extensional settings, whereas compressional faults are expected to host comparatively smaller events.
      403  278
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Neotectonics and long-term seismicity in Europe and the Mediterranean region

    (2015) ; ; ;
    Carafa, M. M. C.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Roma1, Roma, Italia
    ;
    Barba, S.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Roma1, Roma, Italia
    We present a neotectonic model of ongoing lithosphere deformation and a corresponding estimate of long-term shallow seismicity across the Africa-Eurasia plate boundary, including the eastern Atlantic, Mediterranean region, and continental Europe. GPS and stress data are absent or inadequate for the part of the study area covered by water. Thus, we opt for a dynamic model based on the stress-equilibrium equation; this approach allows us to estimate the long-term behavior of the lithosphere (given certain assumptions about its structure and physics) for both land and sea areas. We first update the existing plate model by adding five quasi-rigid plates (the Ionian Sea, Adria, Northern Greece, Central Greece, and Marmara) to constrain the deformation pattern of the study area. We use the most recent datasets to estimate the lithospheric structure. The models are evaluated in comparison with updated datasets of geodetic velocities and the most compressive horizontal principal stress azimuths. We find that the side and basal strengths drive the present-day motion of the Adria and Aegean Sea plates, whereas lithostatic pressure plays a key role in driving Anatolia. These findings provide new insights into the neotectonics of the greater Mediterranean region. Finally, the preferred model is used to estimate long-term shallow seismicity, which we retrospectively test against historical seismicity. As an alternative to reliance on incomplete geologic data or historical seismic catalogs, these neotectonic models help to forecast long-term seismicity, although requiring additional tuning before seismicity rates are used for seismic hazard purposes.
      631  2887