Dipartimento della Protezione Civile, Rome, Italy
7 results
Filters
Settings
The search returned 7 results
Now showing 1 - 7 of 7
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Testing Tsunami Inundation Maps for Evacuation Planning in Italy
(2021-03-11); ; ; ;Selva, JacopoInundation maps are a fundamental tool for coastal risk management and in particular for designing evacuation maps and evacuation planning. These in turn are a necessary component of the tsunami warning systems’ last-mile. In Italy inundation maps are informed by a probabilistic tsunami hazard model. Based on a given level of acceptable risk, Italian authorities in charge for this task recommended to consider, as design hazard intensity, the average return period of 2500 years and the 84th percentile of the hazard model uncertainty. An available, regional-scale tsunami hazard model was used that covers the entire Italian coastline. Safety factors based on analysis of run-up variability and an empirical coastal dissipation law on a digital terrain model (DTM) were applied to convert the regional hazard into the design run-up and the corresponding evacuation maps with a GIS-based approach. Since the regional hazard cannot fully capture the local-scale variability, this simplified and conservative approach is considered a viable and feasible practice to inform local coastal risk management in the absence of high-resolution hazard models. The present work is a first attempt to quantify the uncertainty stemming from such procedure. We compare the GIS-based inundation maps informed by a regional model with those obtained from a local high-resolution hazard model. Two locations on the coast of eastern Sicily were considered, and the local hazard was addressed with the same seismic model as the regional one, but using a higher-resolution DTM and massive numerical inundation calculations with the GPU-based Tsunami-HySEA nonlinear shallow water code. This study shows that the GIS-based inundation maps used for planning deal conservatively with potential hazard underestimation at the local scale, stemming from typically unmodeled uncertainties in the numerical source and tsunami evolution models. The GIS-based maps used for planning fall within the estimated “error-bar” due to such uncertainties. The analysis also demonstrates the need to develop local assessments to serve very specific risk mitigation actions to reduce the uncertainty. More in general, the presented case-studies highlight the importance to explore ways of dealing with uncertainty hidden within the high-resolution numerical inundation models, e.g., related to the crude parameterization of the bottom friction, or the inaccuracy of the DTM.831 192 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , RETRACE-3D project: a multidisciplinary collaboration to build a crustal model for the 2016-2018 central Italy seismic sequence
The RETRACE-3D project (centRal italy EarThquakes integRAted Crustal model) focused on the revision of all the available geological and geophysical data in the area interested by the 2016-2018 seismic sequence of central Italy, with the final aim to reconstruct a reliable and consistent 3D geological model of that area. It is based on a collaboration, which was framed into a formal agreement, between Dipartimento della Protezione Civile (the Italian Civil Protection Department), Istituto di Geologia Ambientale e Geoingegneria, and Istituto per il Rilevamento Elettromagnetico of the Consiglio Nazionale delle Ricerche, Istituto Nazionale di Geofisica e Vulcanologia, and Istituto Superiore per la Protezione e la Ricerca Ambientale. The agreement purpose was to develop a project aimed at the geological and seismotectonic characterisation of the crustal volume hosting that seismic sequence. We present and discuss the approach, methodology and results of the project. The 3D geological model of the study area is developed in detail down to a depth of about 12 km, and extended to the Moho based on available regional-scale information. The model is available on the RETRACE-3D project website (www.retrace3d.it).3102 359 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The Deep Bedrock in Rome, Italy: A New Constraint Based on Passive Seismic Data Analysis
(2019-02-19); ; ; ; Seismic resonance inside sedimentary basins severely influences ground shaking at the free surface in case of earthquakes. Starting from few observations of a low-frequency resonance in the historical center of Rome, Italy, we performed several single-station ambient vibration measures to verify and estimate the resonance frequency in a wide area of the city by Horizontal-to-Vertical spectral ratio method. We verified a stable low-frequency peak in the range 0.3–0.4 Hz. Recordings of August 24th 2016, Mw 6.0 Amatrice earthquake, available both inside and outside the basin of Rome, confirm the presence of high-energy components at frequencies of 0.2–0.4 Hz within the basin. These observations support the hypothesis of a deep seismic impedance contrast responsible for the low frequency resonance. To infer the depth range of subsoil deposits related to this impedance contrast, we analyzed ambient vibration data recorded by 2-D seismic arrays aiming at retrieving the shear-wave velocity structure up to relevant depths. To increase the investigation depth (up to 2000 m), we jointly inverted for Rayleigh-waves dispersion and ellipticity curves and resonance frequency. The shear-wave velocity profile shows two main discontinuities at depths of about 500 m and 1800 m that can be related to the bottom of the Plio-Pleistocene filling of the Rome basin and to the top of the basal limestone formation, respectively. These results fill a gap of knowledge about the deep velocity structure in the city that may be helpful for ground-motion scenario studies.308 18 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , New insights into fault activation and stress transfer between en echelon thrusts: The 2012 Emilia, Northern Italy, earthquake sequence
Here we present the results of the inversion of a new geodetic data set covering the 2012 Emilia seismic sequence and the following 1 year of postseismic deformation. Modeling of the geodetic data together with the use of a catalog of 3-D relocated aftershocks allows us to constrain the rupture geometries and the coseismic and postseismic slip distributions for the two main events (Mw 6.1 and 6.0) of the sequence and to explore how these thrust events have interacted with each other. Dislocation modeling reveals that the first event ruptured a slip patch located in the center of the Middle Ferrara thrust with up to 1 m of reverse slip. The modeling of the second event, located about 15 km to the southwest, indicates a main patch with up to 60 cm of slip initiated in the deeper and flatter portion of the Mirandola thrust and progressively propagated postseismically toward the top section of the rupture plane, where most of the aftershocks and afterslip occurred. Our results also indicate that between the two main events, a third thrust segment was activated releasing a pulse of aseismic slip equivalent to a Mw 5.8 event. Coulomb stress changes suggest that the aseismic event was likely triggered by the preceding main shock and that the aseismic slip event probably brought the second fault closer to failure. Our findings show significant correlations between static stress changes and seismicity and suggest that stress interaction between earthquakes plays a significant role among continental en echelon thrusts.346 5 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Tectonic evidence for the ongoing Africa-Eurasia convergence in central Mediterranean foreland areas: A journey among long-lived shear zones, large earthquakes, and elusive fault motions.
(2010-12-02); ; ; ; Di Bucci, D.; Dipartimento della Protezione Civile, Rome, ItalyWe investigate the role of the Africa-Eurasia convergence in the recent tectonic evolution of the central Mediterranean. To this end we focused on two sectors of the Adriatic-Hyblean foreland of the Apennine-Maghrebian chain as they allow tectonic evidence for relative plate motions to be analyzed aside from the masking effect of other more local tectonic phenomena (e.g., subduction, chain building, etc.). We present a thorough review of data and interpretations on two major shear zones cutting these foreland sectors: the E-W Molise-Gondola in central Adriatic and the N-S Vizzini-Scicli in southern Sicily. The selected foreland areas exhibit remarkable similarities, including an unexpectedly high level of seismicity and the presence of the investigated shear zones since the Mesozoic. We analyze the tectonic framework, active tectonics, and seismicity of each of the foreland areas, highlighting the evolution of the tectonic understanding. In both areas, we find that current strains at midcrustal levels seem to respond to the same far-field force oriented NNW-SSE to NW-SE, similar to the orientation of the Africa-Eurasia convergence. We conclude that this convergence plays a primary role in the seismotectonics of the central Mediterranean and is partly accommodated by the reactivation of large Mesozoic shear zones.1188 1171 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Using the ERT method in tectonically active areas: hints from Southern Apennine (Italy)
(2008-11); ; ; ; Electrical Resistivity Tomography (ERT) method has been used to study two tectonically active areas of southern Apennine (Caggiano Faults and Ufita Basin). The main aim of this job was to study the structural setting of the investigated areas, i.e. the geometry of the basins at depth, the location of active faults at surface, and their geometrical characterization. The comparison between ERT and trench/drilling data allowed us to evaluate the efficacy of the ERT method in studying active faults and the structural setting of seismogenic areas. In the Timpa del Vento intermontane basin, high resolution ERT across the Caggiano Fault scarps, with different arrays, electrode spacing (from 1 to 10 m) and penetration depth (from about 5 to 40 m) was carried out. The obtained resistivity models allowed us to locate the fault planes along the hillslope and to gather information at depth, as later con-firmed by paleoseismological trenches excavated across the fault trace. In the Ufita River Valley a 3560-m-long ERT was carried out across the basin, joining 11 roll-along multi-channel acquisition system with an electrode spacing of 20mand reaching an investigation depth of about 170 m. The ERT allowed us to reconstruct the geometry and thickness of the Quaternary deposits filling the Ufita Valley. Our reconstruction of the depositional setting is in agreement with an interpretative geological section based on borehole data.328 333 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Volcanic Risk System (SRV): ASI Pilot Project to Support The Monitoring of Volcanic Risk In Italy by Means of EO Data
(2008-11); ; ; ; The ASI-SRV(Sistema Rischio Vulcanico) project started at the beginning of the 2007 is funded by the Italian Space Agency (ASI) in the frame of the National Space Plan 2003-2005 under the Earth Observations section for natural risks management. Coordinated by the Istituto Nazionale di Geofisica e Vulcanologia (INGV), which is responsible at national level for the volcanic monitoring, the project has as main objective to develop a pre-operative system based on EO data and ground measurements integration to support the volcanic risk monitoring of the Italian Civil Protection Department. The project philosophy is to implement specific modules which allow to process, store and visualize through Web GIS tools EO derived parameters considering three activity phases: 1) knowledge and prevention; 2) crisis; 3) post crisis. In order to combine effectively the EO data and the ground networks measurements the system will implement a multi-parametric analysis tool, which represents and unique tool to analyze contemporaneously a large data set of data in “near real time”. The SRV project will be tested his operational capabilities on three Italian Volcanoes: Etna,Vesuvio and Campi Flegrei.190 578
