Skip to main content
The search returned 11 results
Now showing 1 - 10 of 11
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Deep Sea Gravity Measurements: GEOSTAR-2 Mission Results

    (2006-03-24) ; ; ; ;
    Iafolla, V.; Istituto di Fisica dello Spazio Interplanetario, CNR - via del Fosso del Cavaliere - 00133 Roma, Italy
    A new concept gravity meter with sensitivity close to Hz ms / 10 2 8 − − in the range of 10 -5 −1Hz intended for observation of the vertical component of the Earth gravity and teleseismic waves was implemented at the Istituto di Fisica dello Spazio Interplanetario (IFSI), CNR and successfully operated during the GEOSTAR-2 mission. The gravimeter has demonstrated a capability to operate for long time in an autonomous regime and a good reliability for operation in extreme environments; at the same time the experimental measurements gave the information for the further gravimeter’s implementation. Results of observation and data analysis included the registration of seismic waves excited by global earthquakes and the evaluation of the low frequency modes of free oscillations of the Earth are reported.
      275  416
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Ambient Vibrations of Age-old Masonry Towers: Results of Long-term Dynamic Monitoring in the Historic Centre of Lucca

    The paper presents the results of an ambient vibration monitoring campaign conducted on the so-called “Clock Tower” (Torre delle Ore), one of the best known and most visited monuments in the historic centre of Lucca. The vibrations of the tower were continuously monitored from November 2017 to March 2018 using high-sensitivity instrumentation. In particular, four seismic stations provided by the Istituto Nazionale di Geofisica e Vulcanologia and two three-axial accelerometers developed by AGI S.r.l., spin-off of the National Institute for Astrophysics, were installed on the tower. The measured vibration level was generally very low, since the structure lies in the middle of a limited traffic area. Nevertheless, the availability of two different types of highly sensitive and accurate instruments allowed the authors to follow the dynamic behaviour of the tower during the entire monitoring period and has moreover provided cross-validation of the results.
      162  136
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Towards a permanent deep sea observatory,: the GEOSTAR European Experiment.

    GEOSTAR is the prototype of the first European long-term, multidisciplinary deep sea observatory for continuous monitoring of geophysical, geochemical and oceanographic parameters. Geostar is the example of a strong synergy between science and tecnology addressed to the development of new technological solutions for the observatory realisation and management. The GEOSTAR system is described outlining the enhancements introduced during five years of project activity. An example of data retrieved from the observatory being the deep sea mission running is also given.
      321  58
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    RICAMAR2013 - RIlievi per la Caratterizzazione dell’Ambiente MARino nel Golfo di Pozzuoli

    La caldera risorgente dei Campi Flegrei è, insieme ai vulcani Somma-Vesuvio, Ischia e Procida, uno degli elementi dominanti dell’assetto geologico e morfologico dell’area napoletana. Si tratta di un sistema vulcanico ancora attivo la cui persistente attività è testimoniata dall’ultima eruzione, avvenuta nel 1538, dall’intensa attività fumarolica e idrotermale che perdura da millenni e dai frequenti eventi bradisismici, con deformazione del suolo accompagnata da sismicità e variazioni delle caratteristiche chimico-fisiche dei fluidi emessi dalle fumarole. La caldera comprende la parte occidentale della città di Napoli e si estende nel Golfo di Pozzuoli. La caratteristica principale dell’attuale attività vulcanica della caldera è il movimento lento del suolo a carattere episodico e di grande ampiezza (bradisismo), accompagnato da un’intensa e superficiale attività sismica che si verifica in generale durante la fase di sollevamento......
      333  344
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    OS-IS® Sistema sismico per il monitoraggio e la previsione del moto ondoso

    The European project “Wind, Ports, and Sea”, funded by the European Cross-border Programme “Italy–France Maritime 2007-2013”, aims to improve the safety conditions and to reduce the hazards by monitoring and forecasting the sea-state outside the main ports of the Northern Tyrrhenian and Ligurian Seas. The sea state forecast is done by using a numeric model specifically developed, while the used data are obtained by means of a monitoring system of stations installed in the coast of La Spezia harbor so to perform an inland remote monitoring. This remote monitoring system of the sea, called OSIS ® (Ocean Seismic - Integrated Solution), is a pilot project and will be presented in its main features. The main advantage of the OS-IS® is that it is installed inland and there are no parts in the sea. The key elements of the system are a high sensitivity accelerometers and apposite algorithms for the evaluation of the sea state using the micro-seismic signals on the basis of the mathematical models and the appropriate calibration factors. Actually, since the beginning of the 1900, is well known that the sea waves are sources of a microseismic noise and this phenomenon has been described with more and more precise models since the 1950 by Longuet-Higgins. The OS-IS® system used for "Wind, Ports and Sea" project is made of three micro-seismic stations installed near the La Spezia gulf: each accelerometric station is equipped with a weather station and a data logger that automatically transfers the data to a central server which runs the algorithm of the OS-IS®. In the following will be shortly described the installed systems focusing on its reliability and in the comparison with the traditional monitoring system using buoy. Finally the first measurements will be shown in comparison with those of the conventional method based on the buoys.
      381  94
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    A procedure to ensure a good quality of signals recorded by multidisciplinary seafloor observatories

    Important processes that affect the Earth, for example climate change and geohazards, are driven by phenomena that take place in the oceans. To better understand and mitigate the effects of these processes, an important international effort is taking place to deploy permanent and remotely controlled seafloor and water-column observatory systems. In Europe, large cabled systems with marine sensors are being developed for near real-time and real-time long-term monitoring of ocean processes. Many of these system are part of the EMSO (European Multidisciplinary Seafloor and water column Observatory www.emso-eu.org) Research Infrastructure. A multidisciplinary approach based on different types of sensors, is necessary to understand complex natural phenomena. In fact, given a signal of interest, by using several sensors recording simultaneously it is possible to identify the contribution of different sources to this signal. On the other hand, obtaining good quality long-term continuous data from a variety of sensors installed on a seafloor observatory can be a challenging technical task. We consider long-term time series acquired by GEOSTAR class seafloor observatories deployed at two European offshore sites (Western Ionian sea in the Mediterranean and Iberian Margin-Gulf of Cadiz in the Atlantic Ocean), where there are important sources of geohazard. The observatories are either standalone or cabled, each with its particular technological difficulties and features. The quality and reliability of a signal depends on a chain of events defined by the following aspects: the sensor itself, the installation procedure of the sensor, the possible interaction of the sensor with nearby electronics or with other sensors (e.g. active acoustic current meters signal is recorded from hydrophones), the time stamping procedure, the architecture of data acquisition and transmission (or storage in the standalone case) system, and finally data processing to improve signal to noise ratio. The definition of what is signal and what is noise depends on the study of interest. For example, a seismologist interested in the signals that are caused by earthquakes considers environmental and anthropic effects as noise which would be gladly removed. On the other hand, if one is trying to study the seasonal variations of the seismic signal, then this contribution becomes the signal of interest. To correlate time series coming from different sites, campaigns or instruments, absolute calibration of sensors is obviously a critical issue. A rigorous estimate of timestamp precision is needed to achieve reliable results from multidisciplinary studies. In the present work we focus on the quality of the signal recorded by a broadband seafloor seismometer (from 0.003 Hz to 50 Hz), by a prototype gravimeter and on signals recorded by auxiliary sensors that are helpful in discriminating different noise sources. We first illustrate the steps that were taken to obtain a good quality reliable signal and finally we focus on how, thanks to a multisensor approach, we can identify the main noise sources, such as sea currents and temperature variation in the long period part of the spectrum. It is possible, in principle, to reduce this noise through signal processing techniques. The improvement of the S/N with such procedures allows for a more efficient detection of interesting seismic signals. We show some examples of this signal improvement procedure.
      370  88
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    OS-IS a new method for the sea waves monitoring

    The European project “Wind, Ports, and Sea” (VPM), funded by the European Cross-border Programme “Italy-France Maritime 2007–2013”, aims to improve the safety conditions and to reduce the hazards by the development of a coupled monitoring and forecast system of the sea-state outside the main harbors of the Northern Tyrrhenian and Ligurian Seas. In particular, the sea and wind forecasts are evaluated by using a numerical model specifically implemented for this project and the monitoring system is made of measuring stations installed on the coast near the harbor areas. The Port Authority of La Spezia has implemented a pilot project based on a new method, called OS-IS (Ocean Seismic-Integrated Solution, [1]), for the inland remote monitoring of the sea. The key advantage of OS-IS is that is installed inland, inside a building, and there are no parts in the sea. The core elements of the system are high sensitivity accelerometers and specifically developed algorithms for the evaluation of the sea state using the micro-seismic signals on the basis of mathematical models and fitting calibration factors. After more than one year since the first installation, OS-IS has shown a high level of reliability and the validity of the measurements has been demonstrated by comparison with those of the buoys. In the following, the installed systems will be shortly described and compared with the conventional methods.
      29  182
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Multiparametric seafloor exploration: the Marsili Basin and Volcanic Seamount case (Tyrrhenian Sea, Italy)

    Exploration of ocean seafloor is of paramount importance for a better understanding of the geodynamic evolution of our Planet. The pilot experiment of ORION-GEOSTAR 3 EC project was the first long-term continuous geophysical and oceanographic experiment of an important seafloor area of Southern Tyrrhenian Sea, the Marsili abyssal plain. The latter hosts the Marsili Seamount which is Europe’s one of the largest underwater volcano of Plio-Pleistocenic age. In spite of its dimensions, it is rather unknown about the present characteristics and activity. For this reason, we deployed a deep-sea observatory network, composed by two bottom observatories, on the seafloor at the base of the seamount at 3320 m b.s.l., in the period December 2003-May 2005. Some of the instruments on board the observatory were: broad-band seismometers, hydrophones, gravity meter, two magnetometers (scalar and vectorial), 3D single-point current meter, ADCP, CTD, automatic pH analyser and off-line water sampler for laboratory analyses. The first successful scientific objective was to obtain long-term continuous recordings under a unique time reference. The data analysis shows that they are generally of good quality and really continuous (only a few gaps). As a first step we performed a classification of seismic waveforms, a first inversion of magnetic variational data, and a first analysis of gravity meter, chemical and oceanographic data. Analysis of individual time series has shown interesting results, i.e. depth of the magnetic Moho under the Marsili, attenuation of recorded seismic body waves and clues of hydrothermal circulation. We show examples of the preliminary data analysis together with first results and comparisons among data coming from different sensors.
      925  901
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Sea Wave Data Reconstruction Using Micro-Seismic Measurements and Machine Learning Methods

    Sea wave monitoring is key in many applications in oceanography such as the validation of weather and wave models. Conventional in situ solutions are based on moored buoys whose measurements are often recognized as a standard. However, being exposed to a harsh environment, they are not reliable, need frequent maintenance, and the datasets feature many gaps. To overcome the previous limitations, we propose a system including a buoy, a micro-seismic measuring station, and a machine learning algorithm. The working principle is based on measuring the micro-seismic signals generated by the sea waves. Thus, the machine learning algorithm will be trained to reconstruct the missing buoy data from the micro-seismic data. As the micro-seismic station can be installed indoor, it assures high reliability while the machine learning algorithm provides accurate reconstruction of the missing buoy data. In this work, we present the methods to process the data, develop and train the machine learning algorithm, and assess the reconstruction accuracy. As a case of study, we used experimental data collected in 2014 from the Northern Tyrrhenian Sea demonstrating that the data reconstruction can be done both for significant wave height and wave period. The proposed approach was inspired from Data Science, whose methods were the foundation for the new solutions presented in this work. For example, estimating the period of the sea waves, often not discussed in previous works, was relatively simple with machine learning. In conclusion, the experimental results demonstrated that the new system can overcome the reliability issues of the buoy keeping the same accuracy.
      131  212
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Characterization of the response of spring relative gravimeters during paroxysmal eruptions at Etna volcano

    Gravity time sequences collected at Etna volcano by continuously recording spring-based relative gravimeters showed significant variations in temporal correspondence with paroxysmal eruptions. Since the observed gravity variations can only be partially related to subsurface mass redistribution phenomena, we investigated on the instrumental effects due to the ground vibrations as those accompanying explosive activity. We simulated the performances of relative gravimeters through laboratory experiments to estimate their response to vertical and horizontal excitations. Laboratory tests were carried out using a vibrating platform capable of accelerating the instruments with intensities and frequencies, in both the vertical and horizontal directions, observed in the ground vibrations associated with paroxysmal events. The seismic signals recorded at Etna volcano during the 10 April 2011 lava fountain were analyzed to retrieve the parameters used to drive the vibration platform. We tested two gravimeters used for Etna volcano monitoring: the LaCoste & Romberg D#185 and the Scintrex CG-3M#9310234. The experimental results highlight that vibrations, resembling the seismic waves propagated during paroxysmal events, cause an amplitude response in the gravity readings of the order of several hundred of microGals. Generally the relationship between the vibrations and the gravimeter response is non-linear with a fairly complex dependence on the frequencies and amplitude of the signals acting on the gravimeters.
      602  153