4 results
Filters
Settings
The search returned 4 results
Now showing 1 - 4 of 4
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Adjoint Tomography of the Italian Lithosphere
The evolution and state of geological structure at Earth's surface is best understood with an accurate characterization of the subsurface. Here we present seismic tomographic images of the Italian lithosphere based on ground motion recordings and characterized by compressional and shear wavespeed structure at remarkable resolution, corresponding to a minimum period of ∼10 s. Enhanced accuracy is enabled by state-of-the-art three-dimensional wavefield simulations in combination with an adjoint-state method. We focus on three primary findings of our model Im25. It highlights the distribution of fluids and gas (CO2) within the Italian subsurface and their correlation with seismicity. It illuminates Mt. Etna volcano and supports the hypothesis of a deep reservoir (∼30 km) feeding a shallower magma-filled intrusive body. Offshore of the eastern Italian coast, it reveals that the Adriatic plate is made of two distinct microplates, separated by the Gargano deformation zone, indicating a complex lithosphere and tectonic evolution.408 158 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Determination of the critical state of granular materials with triaxial tests
While the Critical State Locus (CSL) determined from triaxial compression tests is commonly adopted for the constitutive modelling of soil, the validity of the locus for other stress paths needs to be proved. Several authors have tried to experimentally verify whether the classical CSL representation in the stress invariants - void ratio space could be considered as unique or should depend on the loading direction, but the question is still being debated and a unique conclusion has not been convincingly drawn. In order to clarify this issue, compression and extension triaxial tests are performed on granular materials with different characteristics, namely, two homogeneously distributed sands and an assembly of steel spheres prepared under different initial conditions. The procedure for identifying the CSL is reviewed and indicates the limitations arising from strain localization (shear bands and necking). All the tests show that the materials head to systematically different traces in the e-p' and p'. -q planes when sheared under triaxial compression and extension. Searching for the reasons for this phenomenon, small samples of sand are subjected to the same tests quantifying the whole strain field with X-ray tomography and a digital image correlation. This analysis reveals an inhomogeneous pattern of deformation that is strongly affected by the presence of the two rigid frictional bases and the flexible side membrane, even for the samples deforming in an apparently uniform manner. The different localization observed for the compression and extension tests justifies the dependence of the CSL on the stress path seen on the global scale. On the other hand, a unique trace of the CSL is obtained in the volumetric e-p' plane when the void ratio is measured limitedly to the zones affected by the largest distortion.84 8 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Magmas near the critical degassing pressure drive volcanic unrest towards a critical state
(2016-07); ; ; ; During the reawaking of a volcano, magmas migrating through the shallow crust have to pass through hydrothermal fluids and rocks. The resulting magma–hydrothermal interactions are still poorly understood, which impairs the ability to interpret volcano monitoring signals and perform hazard assessments. Here we use the results of physical and volatile saturation models to demonstrate that magmatic volatiles released by decompressing magmas at a critical degassing pressure (CDP) can drive volcanic unrest towards a critical state. We show that, at the CDP, the abrupt and voluminous release of H2O-rich magmatic gases can heat hydrothermal fluids and rocks, triggering an accelerating deformation that can ultimately culminate in rock failure and eruption. We propose that magma could be approaching the CDP at Campi Flegrei, a volcano in the metropolitan area of Naples, one of the most densely inhabited areas in the world, and where accelerating deformation and heating are currently being observed.396 15 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Volcanic edifice weakening via decarbonation: A self-limiting process?
(2012); ; ; ; The inherent instability of volcanic edifices, and their resultant propensity for catastrophic collapse, is a constant source of volcanic risk. Structural instability of volcanic edifices may be amplified by the presence of carbonate rocks in the sub-volcanic strata, due to the debilitating response of carbonates to thermally-induced alteration. Nonetheless, decarbonation reactions (the primary weakening mechanism), may stall when the system becomes buffered by rising levels of a reaction product, carbon dioxide. Such thermodynamic stalling might be inferred to serve to circumvent the weakness of volcanic structures. However, the present study shows that, even when decarbonation is halted, rock physical properties continue to degrade due to thermal microcracking. Furthermore, as a result, the pathways for the escape of carbon dioxide are numerous within a volcanic edifice. Therefore, in the case of an edifice with a subvolcanic sedimentary basement, the generation of carbon dioxide via decarbonation is unlikely to hinder its impact on instability, and thus potentially devastating flank collapse.175 16
