Skip to main content
The search returned 89 results
Now showing 1 - 10 of 89
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Inundation and evacuation of shoreline populations during landslide-triggered tsunamis: an integrated numerical and statistical hazard assessment

    ([Göttingen] : Copernicus Publ., 2024-11-07)
    Bonilauri, Emmie Malika
    ;
    Aaron, Catherine
    ;
    ; ;
    The volcanic island of Stromboli (southern Tyrrhenian Sea, Italy) is renowned for its persistent, periodic, low-intensity explosive activity, whose spectacular manifestations attract tens of thousands of tourists every year. However, sporadic more intense major explosive and effusive eruptions and paroxysms pose serious threats to the island. In addition to direct hazards, granular slides of volcanic debris and pyroclastic avalanches, which can rapidly reach the sea and potentially generate tsunamis, are often associated with such unpredictable eruptive activity. Due to the very fast propagation of the tsunami around the island and the consequent short tsunami warning time (ranging from less than a minute to only a few minutes), mitigation efforts and evacuation from the Strombolian coast must be carefully planned. In this paper, we describe a new GIS-assisted procedure that allows us to combine the outputs of an ensemble of 156 pre-computed landslide-generated tsunami hazard scenarios (with variable landslide volume, position, and density), statistical exposure data (i.e. the number of inhabitants and tourists), and digital geographic information to obtain a quantitative (scenario-based) risk analysis. By means of the analysis of the road network and coastal morphology, we develop a model with routes and times to reach a safe area from every pixel in the inundated area and an appraisal of the time needed to escape versus the wave arrival time. This allows us to evaluate and quantify the effectiveness of potential risk mitigation by means of evacuation. The creation of an impact score linking the predicted inundation extent and the tsunami warning signals is intended, in the long term, to be used to predict the intensity of future tsunamis and to adapt evacuation plans accordingly. The model, here applied to Stromboli, is general and can be applied to other volcanic islands. Evacuating an island hosting several thousand tourists every summer with very little warning time underlines the absolute necessity for such mitigation efforts, aimed at informing hazard planners and managers and all other stakeholders.
      2  19
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Multiphase-flow numerical modeling of the 18 May 1980 lateral blast at Mount St. Helens, USA

    Volcanic lateral blasts are among the most spectacular and devastating of natural phenomena, but their dynamics are still poorly understood. Here we investigate the best documented and most controversial blast at Mount St. Helens (Washington State, United States), on 18 May 1980. By means of three-dimensional multiphase numerical simulations we demonstrate that the blast front propagation, final runout, and damage can be explained by the emplacement of an unsteady, stratified pyroclastic density current, controlled by gravity and terrain morphology. Such an interpretation is quantitatively supported by large-scale observations at Mount St. Helens and will influence the definition and predictive mapping of hazards on blast-dangerous volcanoes worldwide.
      182  24
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    A fast, calibrated model for pyroclastic density currents kinematics and hazard

    Multiphase flow models represent valuable tools for the study of the complex, non-equilibrium dynamics of pyroclastic density currents. Particle sedimentation, flow stratification and rheological changes, depending on the flow regime, interaction with topographic obstacles, turbulent air entrainment, buoyancy reversal, and other complex features of pyroclastic currents can be simulated in two and three dimensions, by exploiting efficient numerical solvers and the improved computational capability of modern supercomputers. However, numerical simulations of polydisperse gas-particle mixtures are quite computationally expensive, so that their use in hazard assessment studies (where there is the need of evaluating the probability of hazardous actions over hundreds of possible scenarios) is still challenging. To this aim, a simplified integral (box) model can be used, under the appropriate hypotheses, to describe the kinematics of pyroclastic density currents over a flat topography, their scaling properties and their depositional features. In this work, multiphase flow simulations are used to evaluate integral model approximations, to calibrate its free parameters and to assess the influence of the input data on the results. Two-dimensional numerical simulations describe the generation and decoupling of a dense, basal layer (formed by progressive particle sedimentation) from the dilute transport system. In the Boussinesq regime (i.e., for solid mass fractions below about 0.1), the current Froude number (i.e., the ratio between the current inertia and buoyancy) does not strongly depend on initial conditions and it is consistent to that measured in laboratory experiments (i.e., between 1.05 and 1.2). For higher density ratios (solid mass fraction in the range 0.1–0.9) but still in a relatively dilute regime (particle volume fraction lower than 0.01), numerical simulations demonstrate that the box model is still applicable, but the Froude number depends on the reduced gravity. When the box model is opportunely calibrated with the numerical simulation results, the prediction of the flow runout is fairly accurate and the model predicts a rapid, non-linear decay of the flow kinetic energy (or dynamic pressure) with the distance from the source. The capability of PDC to overcome topographic obstacles can thus be analysed in the framework of the energy-conoid approach, in which the predicted kinetic energy of the flow front is compared with the potential energy jump associated with the elevated topography to derive a condition for blocking. Model results show that, although preferable to the energy-cone, the energy-conoid approach still has some serious limitations, mostly associated with the behaviour of the flow head. Implications of these outcomes are discussed in the context of probabilistic hazard assessment studies, in which a calibrated box model can be used as a fast pyroclastic density current emulator for Monte Carlo simulations.
      212  9
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    An immersed boundary method for compressible multiphase flows: application to the dynamics of pyroclastic density currents

    An immersed boundary technique suitable for the solution of multiphase compressible equations of gas–particle flows of volcanic origin over complex 2D and 3D topographies has been developed and applied. This procedure combines and extends different existing methods designed for incompressible flows. Furthermore, the extension to compressible multiphase flows is achieved through a flux correction term in the mass continuity equations of the immersed cells that accounts for density variations in the partial volumes. The technique is computationally accurate and inexpensive, if compared to the use and implementation of the finite-volume technique on unstructured meshes. The first applications that we consider are the simulations of pyroclastic density currents generated by the collapse of a volcanic column in 2D axisymmetric geometry and by a dome explosion in 3D. Results show that the immersed boundary technique can significantly improve the description of the no-slip flow condition on an irregular topography even with relatively coarse meshes. Although the net effect of the present technique on the results is difficult to quantify in general terms, its adoption is recommended any time that cartesian grids are used to describe the large-scale dynamics of pyroclastic density currents over volcano topographies.
      141  19
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Real-time probabilistic assessment of volcanic hazard for tephra dispersal and fallout at Mt. Etna: the 2021 lava fountain episodes

    Starting from February 2021, Mt. Etna (Italy) experienced a period of intense explosive activity with 17 lava fountain episodes between 16 February and 1 April 2021. During the eruptive cycle, the Istituto Nazionale di Geofisica e Vulcanologia-Osservatorio Etneo (INGV-OE) issued 62 alert notifications known as VONAs (Volcano Observatory Notice for Aviation) to inform the aeronautical authorities about the volcanic activity. We present an automated VONA-based workflow aimed at real-time assessment of the volcanic hazard due to tephra fallout at Mt. Etna. When a VONA reporting tephra emission is issued by INGV-OE, numerical simulations accounting for atmospheric and eruptive uncertainties are automatically initialized to produce probabilistic hazard maps of tephra fallout and atmospheric dispersal. We applied the workflow to three lava fountains that occurred during the 2021 eruptive cycle. To test the modelling results, we compared the simulated ground load with field data, and the extent and position of the simulated volcanic cloud with the observed or estimated volcanic cloud from the Toulouse Volcanic Ash Advisory Center. Overall, we found a good match between simulated and observed quantities (tephra loads and volcanic cloud position), especially when accurate information on eruptive conditions (column height and duration) are supplied by the VONAs. Finally, through a statistical analysis, we found that column height and wind field are fundamental in determining tephra ground accumulation. For this reason, these parameters should be constrained by observational data as accurately as possible when performing numerical simulations, especially in the line of developing operational workflows.
      315  202
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Destructiveness of pyroclastic surges controlled by turbulent fluctuations

    Pyroclastic surges are lethal hazards from volcanoes that exhibit enormous destructiveness through dynamic pressures of 100–102 kPa inside flows capable of obliterating reinforced buildings. However, to date, there are no measurements inside these currents to quantify the dynamics of this important hazard process. Here we show, through large-scale experiments and the first field measurement of pressure inside pyroclastic surges, that dynamic pressure energy is mostly carried by large-scale coherent turbulent structures and gravity waves. These perpetuate as low-frequency high-pressure pulses downcurrent, form maxima in the flow energy spectra and drive a turbulent energy cascade. The pressure maxima exceed mean values, which are traditionally estimated for hazard assessments, manifold. The fre- quency of the most energetic coherent turbulent structures is bounded by a critical Strouhal number of ~0.3, allowing quantitative predictions. This explains the destructiveness of real- world flows through the development of c. 1–20 successive high-pressure pulses per minute. This discovery, which is also applicable to powder snow avalanches, necessitates a re- evaluation of hazard models that aim to forecast and mitigate volcanic hazard impacts globally.
      174  56
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Assessing volcanic hazard at Campi Flegrei caldera (Italy) with uncertainty quantification

    Campi Flegrei (CF) is an example of an active, densely populated, caldera with very high risks associated with the occurrence of explosive eruptions. In particular, mapping of pyroclastic density currents (PDCs) hazard is challenging due to the large uncertainty on future vent location and eruption scale as well as the complex dynamics of flows over caldera topography. In this presentation we show how volcanological datasets of different type, mathematical modelling and expert elicitation techniques have been used to produce base-rate probabilistic vent opening and PDC inundation maps. The analysis particularly focused on the reconstruction of the location of past eruptive vents and it allowed the incorporation of additional volcanological datasets, such as the distribution of faults and surface fractures assumed to be representative of areas of crustal weaknesses in the caldera. One key objective was to directly incorporate some of the main sources of epistemic uncertainty relating to an understanding of the volcanic system. We used a formal and structured expert elicitation procedure to quantify uncertainties for the main parameters and evaluate the outcomes through different expert weighting models. A set of probabilistic PDC inundation hazard maps were then produced by the Monte Carlo approach based on a simplified inundation model and incorporating uncertainties on future vent location and event scale.
      69  78
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Quantifying volcanic hazard at Campi Flegrei caldera (Italy) with uncertainty assessment: 2. Pyroclastic density current invasion maps

    Campi Flegrei (CF) is an example of an active caldera containing densely populated settlements at very high risk of pyroclastic density currents (PDCs). We present here an innovative method for assessing background spatial PDC hazard in a caldera setting with probabilistic invasion maps conditional on the occurrence of an explosive event. The method encompasses the probabilistic assessment of potential vent opening positions, derived in the companion paper, combined with inferences about the spatial density distribution of PDC invasion areas from a simplified flow model, informed by reconstruction of deposits from eruptions in the last 15 ka. The flow model describes the PDC kinematics and accounts for main effects of topography on flow propagation. Structured expert elicitation is used to incorporate certain sources of epistemic uncertainty, and a Monte Carlo approach is adopted to produce a set of probabilistic hazard maps for the whole CF area. Our findings show that, in case of eruption, almost the entire caldera is exposed to invasion with a mean probability of at least 5%, with peaks greater than 50% in some central areas. Some areas outside the caldera are also exposed to this danger, with mean probabilities of invasion of the order of 5–10%. Our analysis suggests that these probability estimates have location-specific uncertainties which can be substantial. The results prove to be robust with respect to alternative elicitation models and allow the influence on hazard mapping of different sources of uncertainty, and of theoretical and numerical assumptions, to be quantified.
      586  123
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Ash plume properties retrieved from infrared images: a forward and inverse modeling approach

    (2015) ; ; ; ;
    Cerminara, M.; Scuola Normale Superiore, Pisa (Italy)
    We present a coupled fluid-dynamic and electromagnetic model for volcanic ash plumes. In a forward approach, the model is able to simulate the plume dynamics from prescribed input flow conditions and generate the corresponding synthetic thermal infrared (TIR) image, allowing a comparison with field-based observations. An inversion procedure is then developed to retrieve ash plume properties from TIR images. The adopted fluid-dynamic model is based on a one-dimensional, stationary description of a self-similar (top-hat) turbulent plume, for which an asymptotic analytical solution is obtained. The electromagnetic emission/absorption model is based on the Schwarzschild's equation and on Mie's theory for disperse particles, assuming that particles are coarser than the radiation wavelength and neglecting scattering. In the inversion procedure, model parameters space is sampled to find the optimal set of input conditions which minimizes the difference between the experimental and the synthetic image. Two complementary methods are discussed: the first is based on a fully two-dimensional fit of the TIR image, while the second only inverts axial data. Due to the top-hat assumption (which overestimates density and temperature at the plume margins), the one-dimensional fit results to be more accurate. However, it cannot be used to estimate the average plume opening angle. Therefore, the entrainment coefficient can only be derived from the two-dimensional fit. Application of the inversion procedure to an ash plume at Santiaguito volcano (Guatemala) has allowed us to retrieve the main plume input parameters, namely the initial radius $b_0$, velocity $U_0$, temperature $T_0$, gas mass ratio $n_0$, entrainment coefficient $k$ and their related uncertainty. Moreover, coupling with the electromagnetic model, we have been able to obtain a reliable estimate of the equivalent Sauter diameter $d_s$ of the total particle size distribution. The presented method is general and, in principle, can be applied to the spatial distribution of particle concentration and temperature obtained by any fluid-dynamic model, either integral or multidimensional, stationary or time-dependent, single or multiphase. The method discussed here is fast and robust, thus indicating potential for applications to real-time estimation of ash mass flux and particle size distribution, which is crucial for model-based forecasts of the volcanic ash dispersal process.
      406  377