Skip to main content
The search returned 6 results
Now showing 1 - 6 of 6
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Explosive Paroxysmal Events at Etna Volcano of Different Magnitude and Intensity Explored through a Multidisciplinary Monitoring System

    Between 13 December 2020 and 21 February 2022, Etna volcano produced a sequence of 66 paroxysmal explosive eruptions, with Strombolian activity at the summit craters climaxing in lava fountains and eruption columns extending several kilometers above the craters, accompanied by minor and short-lasting lava flows from the crater rim. We selected three of these episodes that occurred within a short space of time, between 13 December 2020 and 12 March 2021, of different magnitude (i.e., erupted volume) and intensity (i.e., mass eruption rate or instantaneous eruption rate), and analyzed them from a multidisciplinary perspective. The aim was to gain insights into those parameters that mostly reveal the eruptive process for hazard assessment purposes. The multidisciplinary data consist of calibrated visible images, thermal images, seismic and infrasound data, ground deformation detected from the strainmeters, as well as satellite SEVIRI images. From these data, we obtained the timing of each paroxysmal event, the erupted volume in terms of tephra and lava flows, and the corresponding deflation of the source region, together with the development of the lava fountains and eruption columns with time. The results enabled determining that the smallest episode was that of 13 December 2020, which comprised three distinctive pulses but did not produce an eruptive column detectable from either monitoring cameras or satellites. The 28 February 2021 episode was remarkable for the short amount of time required to reach the climax, and was the most intense, whereas the 12 March 2021 event showed the longest duration but with an intensity between that of the previous two. Our results show that these three paroxysmal events display a typical trend, with the first event also being the smallest in terms of both erupted volume and intensity, the second being the most intense, and the third the one of greatest magnitude but less intense than the second. This is coherent with the end of the first paroxysmal phase on 1 April 2021, which was followed by 48 days of eruptive pause before starting again. In this context, the end of the paroxysmal phase was anticipated by a more effusive episode, thus heralding a temporary decline in the gas content within the feeding magma batch.
      928  199
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Understanding the drivers of volcano deformation through geodetic model verification and validation

    Volcano geodesy often involves the use of models to explain observed surface deformation. A variety of forward models are used, from analytical point sources to numerical simulations that consider complex magma system geometries, topography, and material properties. Various inversion methods can then be used to relate observed volcano data to models. Ideally, forward models should be verified through intercomparison, to check for implementation errors and quantify the error induced by any approximations used. Additionally, forward models and inversion methods should be validated through tests with synthetic and/or real data, to determine their ability to match data and estimate parameter values within uncertainty. However, to date, there have not been comprehensive verification and validation efforts in volcano geodesy. Here, we report on the first phase of the Drivers of Volcano Deformation (DVD) exercises, which were designed to build community involvement through web-based exercises involving calculations of static elastic displacement around pressurized magma reservoirs. The forward model exercises begin with a spherical reservoir in a homogeneous half space, then introduce topography, heterogeneous elastic properties, and spheroidal geometries. The inversion exercises provide synthetic noisy surface displacement data for a spherical reservoir in a homogeneous half space and assess consistency in estimates of reservoir location and volume/pressure change. There is variability in the results from both forward modeling and inversions, which highlights the strengths and limitations of different forward models, as well as the importance of inversion method choice and uncertainty quantification. This first phase of the DVD exercises serves as a community resource and will facilitate further efforts to develop standards of reproducibility.
      233  275
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    The influence of volcano topographic changes on infrasound amplitude: lava fountains at Mt. Etna in 2021

    Infrasound signals are used to investigate and monitor active volcanoes during eruptive and degassing activity. Infrasound amplitude information has been used to estimate eruptive parameters such as plume height, magma discharge rate, and lava fountain height. Active volcanoes are characterized by pronounced topography and, during eruptive activity, the topography can change rapidly, affecting the observed infrasound amplitudes. While the interaction of infrasonic signals with topography has been widely investigated over the past decade, there has been limited work on the impact of changing topography on the infrasonic amplitudes. In this work, the infrasonic signals accompanying 57 lava fountain paroxysms at Mt. Etna (Italy) during 2021 were analyzed. In particular, the temporal and spatial variations of the infrasound amplitudes were investigated. During 2021, significant changes in the topography around the most active crater (the South East Crater) took place and were reconstructed in detail using high resolution imagery from unoccupied aerial system surveys. Through analysis of the observed infrasound signals and numerical simulations of the acoustic wavefield, we demonstrate that the observed spatial and temporal variation in the infrasound signal amplitudes can largely be explained by the combined effects of changes in the location of the acoustic source and changes in the near-vent topography, together with source acoustic amplitude variations. This work demonstrates the importance of accurate source locations and high-resolution topographic information, particularly in the near-vent region where the topography is most likely to change rapidly and illustrates that changing topography should be considered when interpreting local infrasound observations over long time scales.
      342  46
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Repeating earthquakes and ground deformation reveal the structure and triggering mechanisms of the Pernicana fault, Mt. Etna

    Structure and dynamics of fault systems can be investigated using repeating earthquakes as repeatable seismic sources, alongside ground deformation measurements. Here we utilise a dataset of repeating earthquakes which occurred between 2000 and 2019 along the transtensive Pernicana fault system on the northeast flank of Mount Etna, Italy, to investigate the fault structure, as well as the triggering mechanisms of the seismicity. By grouping the repeating earthquakes into families and integrating the seismic data with GPS measurements of ground deformation, we identify four distinct portions of the fault. Each portion shows a different behaviour in terms of seismicity, repeating earthquakes and ground deformation, which we attribute to structural differences including a segmentation of the fault plane at depth. The recurrence intervals of repeating earthquake families display a low degree of regularity which suggests an episodic triggering mechanism, such as magma intrusion, rather than displacement under a constant stress.
      878  29
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Changing magma recharge/discharge dynamics during the 2020–22 lava fountaining activity at Mt. Etna revealed by tilt deformation and volcanic tremor

    Mt. Etna exhibited 62 lava fountaining events between December 13, 2020 and February 21, 2022. We analyzed tilt deformations and volcanic tremor amplitude time series, to characterize both eruptions and the preceding preparatory phases in terms of magnitude and speed of development of the volcanic phenomena, as well as to reconstruct the processes that took place inside the plumbing system and drove this intense period of activity. Based on deflation amplitudes associated with lava fountains and according with other retrieved parameters (i.e., magnitude of inflations, inflation and deflation velocities and volcanic tremor amplitudes), three periods have been distinguished. Period I displays higher values of all the aforementioned parameters, interpreted as conspicuous volumes of volatile-rich magma transferred towards the surface. Period II shows lower values evidencing lack of important new injections of magma from depth, whereas period III reveals a general increasing trend possibly related to gas flushing from magma residing in deeper portions of the plumbing system. Detailed elaborations of tilt signals allowed the identification of short-lived inflations accompanying the early stages of lava fountains during period II. Our results reveal significant correlations between amplitude and velocity of tilt and volcanic tremor signals associated with lava fountains and evidence the crucial role of gas in the inflation-deflation cycles.
      24  128
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Mechanically Consistent Model of the 2018 Christmas Volcano-Tectonic Event at Etna

    (Washington, DC: American Geophysical Union, 2024-07-12) ; ; ; ;
    The interaction between volcanic activity and flank instability during the Christmas Eve eruption at Mount Etna in 2018 is explored, using a mechanically consistent inverse model fitting high spatial resolution SAR data. Inversions search for fractures that may be curved and can accommodate co-eval pressure and shear stress changes. Displacements associated with the eruption result from the interaction between two intrusion sources: a buried dyke and a curved sheared intrusion that fed the eruption. Moreover, we identify that the sheared magmatic intrusion induced the observed eastward slip on the Pernicana fault, while the Fiandaca fault was undergoing stress accumulation, which was suddenly released during a M5.0 seismic event. The Fiandaca fault is determined to be listric, rooting beneath the mobile eastern flank of the volcano. This study highlights the role of curved fractures, acting as sheared intrusions or as faults, in volcanoes exhibiting flank instabilities. In this study, we thoroughly examine how volcanic activity and flank dynamics interacted during the 2018 eruption of Mount Etna. We use high-resolution satellite SAR data and a model considering complex mechanical aspects of the volcano's behavior. Formal inversions reveal that the eruption is triggered by the interplay between two intrusion sources: a buried dyke and a curved sheared intrusion, consistent with the earthquake pattern. This study emphasizes the significant role of curved sheared intrusions and faults at volcanoes prone to flank instabilities. Furthermore, we quantify how summit magmatic intrusions promote fault slip in the eastern flank of Etna. These findings differ from previous research that used simpler approaches. In summary, our study provides a new insight into how volcanoes like Etna can erupt and trigger flank slip, shedding light on the complex interactions between magma and tectonics.
      1  11