Skip to main content
The search returned 11 results
Now showing 1 - 10 of 11
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Rapid response seismic networks in Europe: the lesson learned from L’Aquila earthquake emergency.

    The largest dataset ever recorded during a normal fault seismic sequence was acquired during the 2009 seismic emergency triggered by the damaging earthquake in L'Aquila (Italy). This was possible through the coordination of different rapid-response seismic networks in Italy, France and Germany. A seismic network of more than 60 stations recorded up to 70,000 earthquakes. Here, we describe the different open-data archives where it is possible to find this unique set of data for studies related to hazard, seismotectonics and earthquake physics. Moreover, we briefly describe some immediate and direct applications of emergency seismic networks. At the same time, we note the absence of communication platforms between the different European networks. Rapid-response networks need to agree on common strategies for network operations. Hopefully, over the next few years, the European Rapid-Response Seismic Network will became a reality.
      1025  250
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Macroarea 1 (L’Aquila Centro).

    (Regione Abruzzo- Presidenza del Consiglio dei Ministri, Dipartimento della Protezione Civile, L’Aquila, 2010) ; ; ; ;
    Microzonazione della macroarea 1 (L’Aquila Centro)
      197  307
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Evaluation of the influence of experimental conditions on H/V results from ambient noise recordings

    The H/V-noise technique is now widely used to estimate site effect parameters (fundamental frequency and sometimes the associated soil amplification), and many surveys using this technique have provided convincing results. However, a general agreement on a methodology for data acquisition, data processing and result interpretation has yet to be found. H/V measurements from ambient noise recordings imply both reliability of the results and rapidity of data collection. It is therefore important to understand which experimental conditions (1) influence data quality and reliability, and (2) can help speeding up the recording process. Within the framework of the SESAME European project, a specific task was defined to investigate the reliability of the H/V spectral ratio technique in assessing the site effects. The aim of WP02, one specific Work Package of the SESAME project, is to study the effects of experimental conditions on both stability and reproducibility of H/V results. This study has been conducted in a purely experimental way, by testing the possible influence of various experimental conditions on H/V results both on the frequency peak value and on its amplitude. WP02 results help setting up the experimental conditions under which ambient noise recordings have to be performed in order to provide reproducible, reliable and meaningful H/V results. In this paper we present the results of the WP02 SESAME project concerning the evaluation of the influence of experimental conditions of ambient noise recording on H/V results.
      196  30
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Macroarea 2 (L’Aquila Ovest, Cansatessa, Pettino, Coppito).

    (Regione Abruzzo- Presidenza del Consiglio dei Ministri, Dipartimento della Protezione Civile, 2010) ; ; ; ;
    Indagini geofisiche per la microzonazione sismica della Macroarea 2 L'Aquila ovest
      182  330
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    The contribution of seismic data in microzonation studiesfor downtown L’Aquila

    After the 2009 April 6th Mw 6.3 L’Aquila earthquake (Central Italy) the Italian Civil Defense Department promoted the microzoning study in the ten zones in the epicentral area that suffered major damage. In this paper we present the activities and the results concerning a temporary seismic network installed in the historical L’Aquila city center indicated as “macroarea 1” in the microzoning project. Seismic data were collected to investigate the amplification effects in the city and to support the microzoning activities in verifying both geological profiles and 1D numerical modeling of the seismic response of the city. The conventional spectral approaches using both microtremor and earthquake data allowed to determine the fundamental resonance frequencies and the amplification factors within the city respectively. The spatial variability of these quantities can be related to the geological and geomorphologic characteristics of the investigated area. A comparison between the network data and the data recorded by the two strong motion instruments installed in the city was also made. This allows verifying the relative response of the accelerometric stations that recorded in the city the major events of the sequence.
      845  52
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Influence of instruments on the H/V spectral ratios of ambient vibrations

    For an optimal analysis of the H/V curve, it appears necessary to check the instrument signal to noise ratio in the studied frequency band, to ensure that the signal from the ground noise is well above the internal noise. We assess the reliability and accuracy of various digitizers, sensors and/or digitizer-sensor couples. Although this study is of general interest for any kind of seismological study, we emphasize the influence of equipment on H/V analysis results. To display the impact of the instrumental part on the H/V behavior, some series of tests have been carried out following a step-by-step procedure: first, the digitizers have been tested in the lab (sensitivity, internal noise...), then the three components sensors, still in the lab, and finally the usual user digitizers-sensors couple in lab and outdoors. In general, the digitizer characteristics, verified during this test, correspond well to the manufacturer specifications, however, depending on the digitizer, the quality of the digitized waveform can be very good to very poor, with variation from a channel to another channel (gain, time difference etc.). It appears very clearly that digitizers need a warming up time before the recording to avoid problems in the low-frequency range. Regarding the sensors, we recommend strongly to avoid the use of “classical” accelerometers (i.e., usual force balance technology). The majority of tested seismometers (broadband and short period, even 4.5 Hz) can be used without problems from 0.4 to 25 Hz. In all cases, the instrumentation should be checked first to verify that it works well for the defined study aim, but also to define its limit of use (frequency, sensitivity...).
      173  21
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Site effects of the Roio basin, L’Aquila

    During the microzonation studies of the April 6th, 2009 L’Aquila earthquake, we observed local seismic amplifications in the Roio area—a plane separated from L’Aquila city center by mount Luco. Six portable, digital instruments were deployed across the plain from 15 April to mid-May 2009. This array recorded 152 aftershocks. We analyzed the ground motion from these events to determine relative site amplification within the plain and on surrounding ridges. Horizontal over vertical spectral ratio on noise data (HVSRN),aftershock recordings (HVEQ) and standard spectral ratio (SSR) showed amplifications at 1.3 and 4.0Hz on quaternary deposits. Seismic amplifications in the frequency range of 4 and 6Hz were also observed on a carbonate ridge of Colle di Roio, on the northwestern border of the plateau. A small amplification was noticed near the top of mount Luco, another rocky site. Large discrepancies in the amplification levels between methods have been observed for these sites, but the HVSRN, HVEQ and SSR gave similar results at the stations located in the Roio plain. On the rocky sites, the SSR was more reliable than the HVSRN at estimating the transfer function of the site, even if the resonance frequency seemed to be well detected by the latter method.
      393  32
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Seismic site response estimation in the near source region of the 2009 L'Aquila, Italy, Earthquake

    To better estimate the seismic ground motion during the April 6th, 2009 earthquake in L'Aquila, we deployed temporary arrays in the near-source region. Several arrays have been successively set up in the Aterno valley's epicentral area and have recorded the aftershocks that followed the main shock, between April and September. The data has been processed in order to study the spectral ratios of the horizontal component of ground motion at the soil site and at a reference site, as well as the spectral ratio of the horizontal and the vertical movement at a single recording site. The results obtained confirm the presence of large amplification effects in both L'Aquila's historic centre and in the suburban areas. The resonance frequency has been found to be close to 0.6 Hz in downtown L'Aquila whereas the suburban areas show amplification at frequencies ranging from 2 Hz to 5 Hz.
      202  308
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Sesame Project - Deliverable D04-04 - Report of the WP04 H/V Technique : Empirical Evaluation - Homogeneous Data Set of Noise and Earthquake Recordings at Many Sites

    In this Report the homogeneous data set of earthquake and noise recordings at many sites that is generated under the framework of the SESAME Project (Site Effects Assessment Using Ambient Excitations, EC- RGD, Project No. EVG1-CT-2000-00026 SESAME), Task A (H/V technique), Work Package 04 (WP04– H/V Technique: Empirical Evaluation), is presented. Three main topics are included in the Report: (a) The Standard Information Sheet (SIS) structure, (b) The SESAME Ascii Format (SAF) files, and (c) The SESAME SIS-database. The SIS compiled in this sub-task and SAF format adopted for all data, constitute a homogeneous data set to be processed for further scientific results in the framework of the WP04. In addition, the SIS-database is going to facilitate data selection and management.
      293  710
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Sesame Project - Deliverable D01-02 - WP02: Controlled Instrumental Specifications - Final report of the Instrument Workshop 22-26 October 2001, University of Bergen, Norway

    In the following we report the preliminary results from a workshop arranged at the Institute of Solid Earth Physics, University of Bergen, in the period 22-26 October 2001 in Bergen, Norway. The workshop was arranged under the framework of the SESAME Project (Site Effects Assessment Using Ambient Excitations, EC-RGD, Project No. EVG1-CT-2000-00026 SESAME), Task A (H/V technique), Work Package 02 (WP02 – Experimental conditions).
      219  712