Marcucci, Sandro
Preferred name
Marcucci, Sandro
Main Affiliation
14 results
Filters
Settings
The search returned 14 results
Now showing 1 - 10 of 14
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The Deep Bedrock in Rome, Italy: A New Constraint Based on Passive Seismic Data Analysis
(2019-02-19); ; ; ; Seismic resonance inside sedimentary basins severely influences ground shaking at the free surface in case of earthquakes. Starting from few observations of a low-frequency resonance in the historical center of Rome, Italy, we performed several single-station ambient vibration measures to verify and estimate the resonance frequency in a wide area of the city by Horizontal-to-Vertical spectral ratio method. We verified a stable low-frequency peak in the range 0.3–0.4 Hz. Recordings of August 24th 2016, Mw 6.0 Amatrice earthquake, available both inside and outside the basin of Rome, confirm the presence of high-energy components at frequencies of 0.2–0.4 Hz within the basin. These observations support the hypothesis of a deep seismic impedance contrast responsible for the low frequency resonance. To infer the depth range of subsoil deposits related to this impedance contrast, we analyzed ambient vibration data recorded by 2-D seismic arrays aiming at retrieving the shear-wave velocity structure up to relevant depths. To increase the investigation depth (up to 2000 m), we jointly inverted for Rayleigh-waves dispersion and ellipticity curves and resonance frequency. The shear-wave velocity profile shows two main discontinuities at depths of about 500 m and 1800 m that can be related to the bottom of the Plio-Pleistocene filling of the Rome basin and to the top of the basal limestone formation, respectively. These results fill a gap of knowledge about the deep velocity structure in the city that may be helpful for ground-motion scenario studies.308 18 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Extensive characterization of Italian accelerometric stations from single-station ambient-vibration measurements
(2011-12); ; ; ; This paper describes the analyses of the single-station ambient-vibration measurements performed on the Italian accelerometric network to detect site resonance phenomena potentially affecting earthquake recordings. The use of low cost, high quality microtremor measurement can be helpful to discriminate among soil classes, since several classification schemes based on resonance frequencies were proposed in the last decades. Operatively, in the framework of the Italian Strong Motion Database project (DPC-INGV 2007–2009 S4; http://esse4.mi.ingv.it), soil resonance frequencies have been evaluated from more than 200 ambient vibration measurements in correspondence of accelerometric stations included in ITACA (http://itaca.mi.ingv.it/ItacaNet/). The noise recordings have been analyzed using the same numerical protocol in order to standardize the results. Particular attention has been paid to evaluate the quality of measurements and to develop an on-purpose mathematical tool to automatically estimate the peaks in the horizontal-to-vertical spectral ratio (HVSR) curve. The reliability of the resonance frequencies from HVSR has been tested by comparing estimates provided by independent methods (modeling or earthquake recordings). The test confirmed the reliability of the microtremor HVSR for assessing the resonance frequencies of the examined sites.170 552 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Overview of the Italian strong Motion database ITACA 1.0
(2011-12); ; ; ; The Italian Strong Motion Database, ITACA, was developed within projects 2 S6 and S4, funded in the framework of the agreements between the Italian Department of 3 Civil Protection (Dipartimento della Protezione Civile, DPC) and the Istituto Nazionale di 4 Geofisica e Vulcanologia (INGV), starting from 2005. The alpha version of the database 5 was released in 2007 and subsequently upgraded to version 1.0 after: (i) including the most 6 recent strongmotion data (from2005 to 2007) recorded in Italy, in addition to the 2008 Parma 7 earthquake, M 5.4, and the M 4.0, 2009 Abruzzo seismic events; (ii) processing the raw 8 strong motion data using an updated procedure; (iii) increasing the number of stations with a 9 measured shear wave velocity profile; (iv) improving the utilities to retrieve time series and 10 ground motion parameters; (v) implementing a tool for selecting time series in agreement 11 with design-response spectra; (vi) compiling detailed station reports containing miscella12 neous information such as photo, maps and site parameters; (vii) developing procedures for 13 the automatic generation of station reports and for the updating of the header files. After such 14 improvements, ITACA 1.0 was published at the web site http://itaca.mi.ingv.it, in 2010. It 15 presently contains 3,955 three-component waveforms, comprising the most complete cata16 logue of the Italian accelerometric records in the period 1972–2007 (3,562 records) and the 17 strongest events in the period 2008–2009. Records were mainly acquired by DPC through its 18 Accelerometric National Network (RAN) and, in few cases, by local networks and temporary 19 stations or networks. This paper introduces the published version of the Italian StrongMotion 20 database (ITACA version 1.0) together with main improvements and new functionalities.249 2053 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The contribution of seismic data in microzonation studiesfor downtown L’Aquila
(2011-06); ; ; ; After the 2009 April 6th Mw 6.3 L’Aquila earthquake (Central Italy) the Italian Civil Defense Department promoted the microzoning study in the ten zones in the epicentral area that suffered major damage. In this paper we present the activities and the results concerning a temporary seismic network installed in the historical L’Aquila city center indicated as “macroarea 1” in the microzoning project. Seismic data were collected to investigate the amplification effects in the city and to support the microzoning activities in verifying both geological profiles and 1D numerical modeling of the seismic response of the city. The conventional spectral approaches using both microtremor and earthquake data allowed to determine the fundamental resonance frequencies and the amplification factors within the city respectively. The spatial variability of these quantities can be related to the geological and geomorphologic characteristics of the investigated area. A comparison between the network data and the data recorded by the two strong motion instruments installed in the city was also made. This allows verifying the relative response of the accelerometric stations that recorded in the city the major events of the sequence.845 52 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Seismic response of L’Aquila downtown from comparison between 2D synthetics spectral ratios of SH, P-SV and Rayleigh waves and observations of the 2009 earthquake sequence
(2011-02); ; ; ; We have studied two velocity-depth models with the aim of outlining the behavior of a velocity reversal in the top layer, which is associated with the stiff Brecce de L’Aquila unit (BrA). In this setting, the SMTH model is topped by a layer with about 2:1 impedance contrast with the underlying layer while the NORV model has no velocity reversal. We have simulated the propagation of SH and P-SV wavefields in the range 0–10 Hz for incidence 0◦ –90◦ . Earthquake spectral ratios of the horizontal and vertical components at six sites in L’Aquila downtown are compared to corresponding syn- thetics spectral ratios. The vertical component of P-SV synthetics enables us to investigate a remarkable amplification effect seen in the vertical component of the recorded strong motion. Sites AQ04 and AQ05 are best matched by synthetics from the NORV model while FAQ5 and AQ06 have a better match with synthetics spectral ratios from the SMTH model. All simulations show this behavior systematically, with horizontal and near-horizontal incident waves predicting the overall pattern of matches more clearly than vertical and near-vertical incidence. The model inferences are in agreement with new geological data reporting lateral passages in the top layer from the stiff BrA to softer sediments. Matches are good in terms of frequency of the first amplification peak and of spectral amplitude: the horizontal compo-nents have spectral ratio peaks predominantly at 0.5 Hz in the simulations and at 0.7 Hz in the data, both with amplitudes of 4, while the vertical component spectral ratios reach values of 6 at frequencies of about 1 Hz in both data and simulations. The vertical component spectral ratios are very well matched using Rayleigh waves with incidence at 90◦ . The NORV model without the velocity reversal predicts spectral ratio peaks for the horizontal components at frequencies up to 6 Hz. The reversal of velocity acts as a low-pass frequency filter on the horizontal components reducing the amplification effect of the sediment filled valley.276 32 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Macroarea 1 (L’Aquila Centro).
(Regione Abruzzo- Presidenza del Consiglio dei Ministri, Dipartimento della Protezione Civile, L’Aquila, 2010); ; ; ; Microzonazione della macroarea 1 (L’Aquila Centro)197 307 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Macroarea 2 (L’Aquila Ovest, Cansatessa, Pettino, Coppito).
(Regione Abruzzo- Presidenza del Consiglio dei Ministri, Dipartimento della Protezione Civile, 2010); ; ; ; Indagini geofisiche per la microzonazione sismica della Macroarea 2 L'Aquila ovest183 333 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Recorded Motions of the Mw6.3 April 6, 2009 L’Aquila (Italy) Earthquake and Implications for Building Structural Damage: Overview.
(2010); ; ; ; The normal-faulting earthquake of 6 April 2009 in the Abruzzo Region of central Italy caused heavy losses of life and substantial damage to centuriesold buildings of significant cultural importance and to modern reinforcedconcrete- framed buildings with hollow masonry infill walls. Although structural deficiencies were significant and widespread, the study of the characteristics of strong motion data from the heavily affected area indicated that the short duration of strong shaking may have spared many more damaged buildings from collapsing. It is recognized that, with this caveat of shortduration shaking, the infill walls may have played a very important role in preventing further deterioration or collapse of many buildings. It is concluded that better new or retrofit construction practices that include reinforcedconcrete shear walls may prove helpful in reducing risks in such seismic areas of Italy, other Mediterranean countries, and even in United States, where there are large inventories of deficient structures.252 27 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Integration of geological and macroseismic data to define probable seismic scenarios in terms of macroseismic intensity and related seismogenic source models. The Maiella 1706 earthquake (Abruzzo, Italy)
(2007-11-13); ; ; ; Integration of geological and macroseismic data to define probable seismic scenarios in terms of macroseismic intensity and related seismogenic source models. The Maiella 1706 earthquake (Abruzzo, Italy)175 305 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , ITACA (ITalian ACcelerometric Archive): un sito web per la disseminazione dei dati accelerometrici italiani
(2007-11-13); ; ; ; La creazione del data base dei dati accelerometrici italiani è un’iniziativa nata nell’ambito della convenzione tra il Dipartimento della Protezione Civile e l’Istituto Nazionale di Geofisica e Vulcanologia nel biennio 2004-2006 (progetto di interesse sismologico S6 denominato Data base dei dati accelerometrici italiani relativi al periodo 1972-2004), in risposta alla crescente richiesta da parte della comunità scientifica di dati strong motion per diverse applicazioni (leggi di attenuazione, verifica di scenari di scuotimento e mappe di pericolosità, shake maps, ecc.). Scopo del progetto è stata la raccolta e l’omogeneizzazione delle forme d’onda acquisite nel corso degli anni dall’Ente Nazionale per l’Energia Elettrica (ENEL), dall’Ente per le Nuove tecnologie, l’Energia e l’Ambiente (ENEA) e dal Dipartimento della Protezione Civile. In aggiunta, le registrazioni sono state qualificate attraverso l’inserimento di metadati relativi agli eventi, ai siti di registrazione e agli strumenti. Un notevole sforzo è stato compiuto per garantire la disseminazione dei dati attraverso un portale web e una serie di strumenti per la consultazione interattiva della banca dati.203 230
