Skip to main content
The search returned 9 results
Now showing 1 - 9 of 9
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Proximal Monitoring of the 2011–2015 Etna Lava Fountains Using MSG-SEVIRI Data

    From 2011 to 2015, 49 lava fountains occurred at Etna volcano. In this work, the measurements carried out from the Spinning Enhanced Visible and InfraRed Imager (SEVIRI) instrument, on board the Meteosat Second Generation (MSG) geostationary satellite, are processed to realize a proximal monitoring of the eruptive activity for each event. The SEVIRI measurements are managed to provide the time series of start and duration of eruption and fountains, Time Averaged Discharge Rate (TADR) and Volcanic Plume Top Height (VPTH). Due to its temperature responsivity, the eruptions start and duration, fountains start and duration and TADR are realized by exploiting the SEVIRI 3.9 m channel, while the VPTH is carried out by applying a simplified procedure based on the SEVIRI 10.8 m brightness temperature computation. For each event, the start, duration and TADR have been compared with ground-based observations. The VPTH time series is compared with the results obtained from a procedures-based on the volcanic cloud center of mass tracking in combination with the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) back-trajectories. The results indicate that SEVIRI is generally able to detect the start of the lava emission few hours before the ground measurements. A good agreement is found for both the start and the duration of the fountains and the VPTH with mean differences of about 1 h, 50 min and 1 km respectively.
      673  134
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Monitoring the December 2015 summit eruptions of Mt. Etna (Italy): Implications on eruptive dynamics

    A lengthy period of eruptive activity fromthe summit craters ofMt. Etna started in January 2011. It culminated in early December 2015 with a spectacular sequence of intense eruptive events involving all four summit craters (Voragine, Bocca Nuova,NewSoutheast Crater, and Northeast Crater). The activity consisted of high eruption columns, Strombolian explosions, lava flows andwidespread ash falls that repeatedly interferedwith air traffic. The most powerful episode occurred on 3 December 2015 from the Voragine. After three further potent episodes fromthe Voragine, activity shifted to the NewSoutheast Crater on 6 December 2015, where Strombolian activity and lava flow emission lasted for two days and were fed by the most primitive magma of the study period. Activity once more shifted to the Northeast Crater, where ash emission and weak Strombolian activity took place for several days. Sporadic ash emissions from all craters continued until 18 December, when all activity ceased. Although resembling the summit eruptions of 1998–1999, which also involved all four summit craters, thismultifaceted eruptive sequence occurred in an exceptionally short time window of less than three days, unprecedented in the recent activity of Mt. Etna. It also produced important morphostructural changes of the summit area with the coalescence of Voragine and Bocca Nuova in a single large crater, the “Central Crater”, reproducing themorphological setting of the summit cone before the formation of Bocca Nuova in 1968. The December 2015 volcanic crisis was followed closely by the staff of the Etna Observatory to monitor the on-going activity and forecast its evolution, in accordance with protocols agreed with the Italian Civil Protection Department.
      3113  7
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Improvement of ash plume monitoring, modeling and hazard assessment in the MED-SUV project

    Volcanic ash clouds produced by explosive eruptions represent a strong problem for civil aviation, road transportation and other human activities. Since Etna volcano produced in the last 35 years more the 200 explosive eruptions of small and medium size. The INGV, liable for its volcano monitoring, developed since 2006 a specific system for forecasting and monitoring Etna’s volcanic ash plumes in collaboration with several national and international institutions. Between 12 January 2011 and 31 December 2013 Etna produced forty-six basaltic lava fountains. Every paroxysm produced an eruption column ranging from a few up to eleven kilometers of height above sea level. The ash cloud contaminated the controlled airspace (CTR) of Catania and Reggio Calabria airports and caused tephra fallout on eastern Sicily sometime disrupting the operations of these airports. In order to give prompt and detailed warnings to the Aviation and Civil Protection authorities, ash plumes monitoring at Osservatorio Etneo, the INGV department in Catania, is carried out using multispectral (from visible to infrared) satellite and ground-based video-surveillance images; seismic and infrasound signals processed in real-time, a Doppler RADAR (Voldorad IIB) able to detect the eruption column in all weather conditions and a LIDAR (AMPLE) for retrieving backscattering and depolarization values of the ash clouds. Forecasting is performed running tephra dispersal models using weather forecast data, and then plotting results on maps published on a dedicated website. 24/7 Control Room operators were able to timely nform Aviation and Civil Protection operators for an effective aviation safety management. A variety of multidisciplinary activities are planned in the MED-SUV project with reference to volcanic ash observations and studies. These include: 1) physical and analogue laboratory experiments on ash dispersal and aggregation; 2) integration of satellite data (e.g. METEOSAT, MODIS) and ground- based measurements (e.g., RADAR, LIDAR) of Etna’s volcanic plumes to quantify mass eruption rate, grain-size distribution at source, and ash cloud concentration; 3) improvement of tools and automatic procedures for the short-term forecasting of volcanic ash dispersal by adopting a multi-model and multi-scenario approach; 4) development of short-term forecasting tools able to use direct measurements of the plume and ash cloud in almost real time (now-casting); 5) development of long-term probabilistic ash fallout maps at the supersite volcanoes.
      236  258
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Eruption column height: a comparison between ground and satellite measurements

    The eruption column height estimation is an essential parameter to evaluate the total mass eruption rate, the gas and aerosol plume dispersal and retrievals. The column height may be estimated using different systems (e.g. satellite, aircraft and ground observations) which may present marked differences. In this work we use the calibrated images collected by the video-surveillance system of the Istituto Nazionale di Geofisica e Vulcanologia, Osservatorio Etneo, from the visible camera located in Catania, 27 km from the vent. The analysis is carried out on twenty lava fountains from the New South East Crater during the recent Etna explosive activity. Firstly, we calibrated the camera to estimate its intrinsic parameters and the full camera model. Furthermore, we selected the images which recorded the maximum phase of the eruptive activity. Hence, we applied an appropriate correction to take into account the wind effect. The column height was also evaluated using SEVIRI and MODIS satellite images collected at the same time of the video camera measurements. The satellite column height retrievals is realized by comparing the 11 m brightness temperature of the most opaque plume pixels with the atmospheric temperature profile measured at Trapani WMO Meteo station (the nearest WMO station to the Etnean area). The comparison between satellite and ground data show a good agreement and the column altitudes ranges between 7.5 and 9 km (upper limit of the camera system). For nine events we evaluated also the thickness of the volcanic plumes in the umbrella region (near the vent) which ranges between 2 and 3 km. The proposed approach help to quantitatively evaluate the column height that may be used by volcanic ash dispersal and sedimentation models for improving forecasts and reducing risks to aviation during volcanic crisis.
      167  233
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Eruption column height estimation of the 2011-2013 Etna lava fountains

    In this paper, we use calibrated images collected by the video-surveillance system of the Istituto Nazionale di Geofisica e Vulcanologia, Osservatorio Etneo, to retrieve the height of the eruption column during the recent Etna explosive activity. The analysis is carried out on nineteen lava fountains from the New South East Crater dataset. The novel procedure described in this work is achieved in three main steps: at first we calibrated the camera, then we selected the images which recorded the maximum phase of the eruptive activity, and finally we applied an appropriate correction to account for the plume projection on the camera line of sight due to the wind. The results show that the column altitudes range between 6 and 9 km (upper limit of the camera system). The comparison with the plume height values estimated from the analysis of several SEVIRI and MODIS satellite images, show a good agreement. Finally, for nine events we also evaluated the thickness of the volcanic plumes in the umbrella region which ranges between 2 and 3 km.
      476  297
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Radiosondaggi atmosferici nell’area etnea

    (2011-04-20) ; ; ; ;
    Coltelli, M.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Catania, Catania, Italia
    RADIOSONDAGGI ATMOSFERICI NELL’AREA ETNEA
      261  167
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    A statistical approach to evaluate the tephra deposit and ash concentration from PUFF model forecasts

    (2011-03-01) ; ; ; ;
    Scollo, S.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Catania, Catania, Italia
    In this paper we present a new statistical approach which provides tephra deposit load and ash concentration using PUFF, a Lagrangian model widely used to forecast volcanic ash dispersal during volcanic crisis. We perform a parametric study in order to analyze the influence of each input parameter on model outputs. For this test, we simulate two eruptive scenarios similar to the 2001 (Scenario 1) and 1998 (Scenario 2) Etna eruptions using high resolution weather data and a domain of 170×170 km. Results show that for both scenarios, we are able to calculate the tephra deposit load and ash concentration but the use of millions of particles is required. Specifically, up to 33 and 220 millions of particles were necessary to accurately predict the tephra deposit and ash concentration in air, respectively. This is approximately two orders of magnitude larger than the values typically considered running PUFF. The parametric study shows that the horizontal diffusion coefficient, the time step of the simulations, the topography and the standard deviation of the particle distribution greatly affect the model outputs. We also validate the model by best-fit procedures. Results show a good comparison between field data of the 2001 Etna eruption and PUFF simulations, being inside 5 and 1/5 times the observed data, comparable with results of Eulerian models. This work will allow to reliably outline the areas of contaminated airspace using PUFF or any other Lagrangian model in order to define the No Fly Zone and ensure the safety aviation operations as required after the Eyjafjallajökull eruption
      229  21
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Monitoring and forecasting Etna volcanic plumes

    In this paper we describe the results of a project ongoing at the Istituto Nazionale di Geofisica e Vulcanologia (INGV). The objective is to develop and implement a system for monitoring and forecasting volcanic plumes of Etna. Monitoring is based at present by multispectral infrared measurements from the Spin Enhanced Visible and Infrared Imager on board the Meteosat Second Generation geosynchronous satellite, visual and thermal cameras, and three radar disdrometers able to detect ash dispersal and fallout. Forecasting is performed by using automatic procedures for: i) downloading weather forecast data from meteorological mesoscale models; ii) running models of tephra dispersal, iii) plotting hazard maps of volcanic ash dispersal and deposition for certain scenarios and, iv) publishing the results on a web-site dedicated to the Italian Civil Protection. Simulations are based on eruptive scenarios obtained by analysing field data collected after the end of recent Etna eruptions. Forecasting is, hence, supported by plume observations carried out by the monitoring system. The system was tested on some explosive events occurred during 2006 and 2007 successfully. The potentiality use of monitoring and forecasting Etna volcanic plumes, in a way to prevent threats to aviation from volcanic ash, is finally discussed.
      502  539
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,
      193  194