Skip to main content
The search returned 4 results
Now showing 1 - 4 of 4
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Melting and metasomatism in West Eifel and Siebengebirge Sub-Continental Lithospheric Mantle: Evidence from concentrations of volatiles in fluid inclusions and petrology of ultramafic xenoliths

    The possibility of constraining the composition and evolution of specific portions of the Sub-Continental Lithospheric Mantle (SCLM) by means of an integrated study of petrography, mineral chemistry, and concentrations of volatiles in fluid inclusions (FI) is a novel approach that can provide clues on the recycling of volatiles within the lithosphere. This approach is even more important in active or dormant volcanic areas, where the signature of the gaseous emissions at the surface can be that of the underlying lithospheric mantle domains. In this respect, the ultramafic xenoliths brought to the surface in West Eifel (~0.5–0.01 Ma) and Siebengebirge (~30–6 Ma) volcanic fields (Germany) are ideal targets, as they provide direct information on one of the most intriguing portions of SCLM beneath the Central European Volcanic Province (CEVP). Five distinct populations from these localities were investigated using petrographic observations, mineral phase analyses and determination of He, Ne, Ar and CO2 contents in olivine-, orthopyroxene-, and clinopyroxene-hosted FI. The most refractory Siebengebirge rocks have highly forsteritic olivine, high-Mg#, low-Al pyroxene, and spinel with high Cr#, reflecting high extents (up to 30%) of melt extraction. In contrast, xenoliths from West Eifel are modally and compositionally heterogeneous, as indicated by the large forsterite range of olivine (Fo83–92), the Cr# range of spinel (0.1–0.6), and the variable Al and Ti contents of pyroxene. Equilibration temperatures vary from 870 ◦C to 1070 ◦C in Siebengebirge, and from ⁓900 ◦C to ⁓1190 ◦C in West Eifel xenoliths, at oxygen fugacity values generally between 􀀀 0.5 and + 1.3 ΔlogƒO2 [FMQ]. In both areas, the FI composition was dominated by CO2, with clinopyroxene, and most of the orthopyroxene had the highest concentrations of volatiles, while olivine was gas-poor. The noble gas and CO2 distributions suggest that olivine is representative of a residual mantle that experienced one or more melt extraction episodes. The 3He/4He ratio corrected for air contamination (Rc/Ra values) varied from 6.8 Ra in harzburgitic lithotypes to 5.5 Ra in lherzolites and cumulate rocks, indicating that the original MORB-like mantle signature was progressively modified by interaction with crustal-related components and melts having 3He/4He and 4He/40Ar* values consistent with those published for magmatic gaseous emissions. The Ne and Ar isotope systematics indicated that most of the data were consistent with mixing between a recycled atmospheric component and a MORB-like mantle, which does not necessarily require the involvement of a lower mantle plume beneath this portion of the CEVP. The major element distribution in mineral phases from West Eifel and Siebengebirge, together with the systematic variations in FI composition, the positive correlation between Al enrichment in pyroxene and equilibration temperatures, and the concomitant Rc/Ra decrease with increasing temperature, suggest that the SCLM beneath Siebengebirge represented the Variscan lithosphere in CEVP prior to the massive infiltration of melts/fluids belonging to the Quaternary Eifel volcanism. In contrast, West Eifel xenoliths reflect multiple heterogeneous metasomatism/refertilisation events that took place in the regional SCLM between ~6 and ~ 0.5 Ma.
      675  2
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    A semi-quantitative method to combine tectonic stress indicators: example from the Southern Calabrian Arc (Italy)

    Databases of tectonic stress indicators are commonly based on different types of observations at different spatial and temporal scales. Each single indicator can be variously representative of the real stress field and the relative importance of all the indicators should be accounted for before any following elaboration. We propose a semi-quantitative procedure which assigns weights to each indicator on the basis of its quality and its representative volume. In this way the indicators can be reliably combined to produce, for example, stress field maps or stress trajectories. The proposed weighting criterion has been applied to a dataset of 440 crustal stress indicators specifically compiled, gathering focal mechanisms and geological data from the literature, and original data from structural features derived from devoted fieldwork, for the southern part of the Calabrian Arc (Italy). This area represents an interesting case study because of its complex geodynamic and structural arrangement. Data were ranked and the orientation of the minimum horizontal stress (Sh) has been interpolated and smoothed on a regular grid. We drew maps of the principal stress axes and inferred the stress regimes over the investigated area. Results are in agreement with independent information from the literature and display the non-uniform orientation of the tectonic stresses and the occurrence of perturbations both at regional and local scale.
      142  89
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Blast-induced liquefaction in silty sands for full-scale testing of ground improvement methods: Insights from a multidisciplinary study

    In the engineering geology field increased attention has been posed in recent years to potential liquefaction mitigation interventions in susceptible sand formations. In silty sands this is a major challenge because, as the fines content increases, vibratory methods for densification become progressively less effective. An alternative mitigation technique can be the installation of Rammed Aggregate Pier® (RAP) columns that can increase the resistance of the soil, accounting for its lateral stress increase and for the stiffness increase from soil and RAP composite response. To investigate the influence of these factors on liquefaction resistance, full-scale blast tests were performed at a silty sand site in Bondeno (Ferrara, Italy) where liquefaction was observed after the 2012 Emilia-Romagna earthquake. A multidisciplinary team of forty researchers carried out devoted experimental activities aimed at better understanding the liquefaction process at the field scale and the effectiveness of the treatment using inter-related methods. Both natural and improved areas were investigated by in-situ tests and later subjected to controlled blasting. The blast tests were monitored with geotechnical and geophysical instrumentation, topographical surveying and geological analyses on the sand boils. Results showed the RAP effectiveness due to the improvement of soil properties within the liquefiable layer and a consequent reduction of the blast-induced liquefaction settlements, likely due to soil densification and increased lateral stress. The applied multidisciplinary approach adopted for the study allowed better understanding of the mechanism involved in the liquefaction mitigation intervention and provided a better overall evaluation of mitigation effectiveness
      2078  132
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Helium and argon isotopic compositions of mantle xenoliths from Tallante and Calatrava, Spain.

    (2011-02-01) ; ; ; ;
    Martelli, M.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Palermo, Palermo, Italia
    We have analyzed by single-step crushing helium and argon isotopes in olivine and orthopyroxene from mantle xenoliths of Calatrava (CLV) in central Spain and Tallante (TL) in southeast Spain. The investigation focused on carefully selected samples previously characterized in terms of major and trace elements on both bulk rock and constituent minerals, and Sr and Nd isotopes on clinopyroxene separates. Six analyses were performed on protogranular spinel lherzolites from CLV, and 17 were performed on spinel harzburgites, lherzolites, and orthopyroxenites from TL. The 40Ar/36Ar ratio was between 296 and 622, indicating atmospheric contamination, which probably occurred during exposure to the surface. The helium-isotope ratio (3He/4He) ranged between 3.6 and 6.5 Ra in CLV samples and between 1.4 and 5.7 Ra in TL samples. There was a positive correlation between the 3He/4He and 4He/40Ar* ratios, possibly reflecting diffusive fractionation between 3He, 4He, and 40Ar within mantle sections interacting with ascending melts. However, the difference between the maximum 3He/4He ratios measured in CLV and TL appears to be related to significant differences in the metasomatic melts that affected the two sectors of the lithospheric mantle. In agreement with the findings of previous studies, the helium isotopes at CLV are compatible with metasomatism due to ascending HIMU-type asthenospheric melts. In contrast, the lower 3He/4He values recorded at TL suggest subduction-related metasomatic components that are possibly related to the Cenozoic subduction of the Betic system. Such event plausibly introduced crust-derived fluids that metasomatized the mantle wedge, slightly decreasing its 3He/4He value. Noble gases appear decoupled from other elements during these mantle processes, since comparatively low 3He/4He values have been recorded also in samples that are relatively unmetasomatized in terms of incompatible lithophile elements. We hypothesize a role for volatile-dominated, CO2-rich fluids progressively decoupling from the ascending metasomatic melts and migrating in the surrounding peridotite matrix to form a diffuse aureola enriched in noble gases.
      227  32