University of Durham (UK)
2 results
Filters
Settings
The search returned 2 results
Now showing 1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Viscous plugging can enhance and modulate explosivity of strombolian eruptions
(2015-08-01); ; ; ; Strombolian activity is common in low-viscosity volcanism. It is characterised by quasi-periodic, short-lived explosions, which, whilst typically weak, may vary greatly in magnitude. The current paradigm for a strombolian volcanic eruption postulates a large gas bubble (slug) bursting explosively after ascending a conduit filled with low-viscosity magma. However, recent studies of pyroclast textures suggest the formation of a region of cooler, degassed, more-viscous magma at the top of the conduit is a common feature of strombolian eruptions. Following the hypothesis that such a rheological impedance could act as a ‘viscous plug’, which modifies and complicates gas escape processes, we conduct the first experimental investigation of this scenario. We find that: 1) the presence of a viscous plug enhances slug burst vigour; 2) experiments that include a viscous plug reproduce, and offer an explanation for, key phenomena observed in natural strombolian eruptions; 3) the presence and extent of the plug must be considered for the interpretation of infrasonic measurements of strombolian eruptions. Our scaled analogue experiments show that, as the gas slug expands on ascent, it forces the underlying low-viscosity liquid into the plug, creating a low-viscosity channel within a high-viscosity annulus. The slug's diameter and ascent rate change as it enters the channel, generating instabilities and increasing slug overpressure. When the slug reaches the surface, a more energetic burst process is observed than would be the case for a slug rising through the low-viscosity liquid alone. Fluid-dynamic instabilities cause low and high viscosity magma analogues to intermingle, and cause the burst to become pulsatory. The observed phenomena are reproduced by numerical fluid dynamic simulations at the volcanic scale, and provide a plausible explanation for pulsations, and the ejection of mingled pyroclasts, observed at Stromboli and elsewhere.339 336 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The thickness of the falling film of liquid around a Taylor bubble
(2012-02-24); ; ; ; We present the results of laboratory experiments that quantify the physical controls on the thickness of the falling film of liquid around a Taylor bubble, when liquid–gas interfacial tension can be neglected. We find that the dimensionless film thickness l (the ratio of the film thickness to the pipe radius) is a function only of the dimensionless parameter Nf = rgD3/m, where r is the liquid density, g the gravitational acceleration, D the pipe diameter and m the dynamic viscosity of the liquid. For Nf 10, the dimensionless film thickness is independent of Nf with value l ≈ 0.33; in the interval 10 Nf 104, l decreases with increasing Nf; for Nf 104 film thickness is, again, independent of Nf with value l ≈ 0.08. We synthesize existing models for films falling down a plane surface and around a Taylor bubble, and develop a theoretical model for film thickness that encompasses the viscous, inertial and turbulent regimes. Based on our data, we also propose a single empirical correlation for l(Nf), which is valid in the range 10−1 < Nf < 105. Finally, we consider the thickness of the falling film when interfacial tension cannot be neglected, and find that film thickness decreases as interfacial tension becomes more important.474 83
