Corti, Noemi
Preferred name
Corti, Noemi
ORCID
The search returned 7 results
Now showing 1 - 7 of 7
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , 3D study of dyke-induced asymmetric graben: The 1971 Mt. Etna (Italy) case by structural data and numerical modelling
(Elsevier BV, 2024-08-15); ; ; ; In this work, we have integrated field data and numerical models to characterise a unique dyke-induced graben system, exposed both in section and plan view, with an unexpected asymmetric fault geometry. This volcanotectonic feature is related to the 1971 eruption of Mt. Etna (southern Italy) and is located near the northern wall of the Valle del Bove, a huge depression carved into the eastern flank of the edifice. A new structural map and quantitative data were obtained from the analysis of aerial stereophotos collected before the onset of the 1971 eruption and after, high-resolution drone-derived models and field surveys carried out in the summer of 2022. In plan view, the graben is 2-km-long and its width ranges 27-143 m from the bottom to the upper part of the section view, with about 82 m of difference in elevation from top to bottom. Graben faults clearly show an asymmetric setting in terms of attitude, with one fault that dips 70 • to the south, and the other one that dips 50 • to the north. Vertical offset values are greater at higher elevations. We also ran a set of numerical models, aimed at investigating the distribution and orientation of stresses around the inferred dyke tip and in the host rock. The comparison between field data and numerical models suggests a key role of the inclined topography, as shown in section view, in determining the orientation of dyke-induced σ 1 and σ 3 in the host rock. This, in turn, controls the geometry of the graben faults, resulting in the observed asymmetric setting. Additionally, dyke-induced stress concentrations and vertical offset values support the hypothesis of a downward propagation of the graben faults, from the surface down to the dyke tip.9 18 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , A New Way to Explore Volcanic Areas: QR-Code-Based Virtual Geotrail at Mt. Etna Volcano, Italy
In this body of work, we showcase a historic virtual geotrail on the eastern flank of the iconic Mt. Etna volcano (Italy), along a series of outstanding geological sites and features subsequent to an important eruption that took place in 1928. A geohistoric account of such a major eruption, is of great interest, since it is the only event since 1669 to have caused the destruction of a town (Mascali) in the Etna region. Volcanologists, educators, the lay public, tourists and volcano explorers can now access a series of “virtual geostops” belonging to this virtual geotrail, such that “visitors” can virtually fly above these sites by scanning a QR code on the printed or electronic version of the present manuscript, as well as on the poster provided as additional material for this manuscript. The virtual geostops that comprise the virtual geotrail were developed using the structure-frommotion (SfM) photogrammetry technique from images captured by using unmanned aerial vehicles (UAVs). The main result of our work is the virtual geotrail, subdivided in two parts and composed of eight geostops, each showing outstanding examples of geological features resulting from volcanic phenomena that took place also during 1979. Our approach is designed to support classical field trips, and it can undoubtedly become complementary to traditional field teaching in earth sciences, both now and in the future.287 142 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , How Academics and the Public Experienced Immersive Virtual Reality for Geo-Education
Immersive virtual reality can potentially open up interesting geological sites to students, academics and others who may not have had the opportunity to visit such sites previously. We study how users perceive the usefulness of an immersive virtual reality approach applied to Earth Sciences teaching and communication. During nine immersive virtual reality-based events held in 2018 and 2019 in various locations (Vienna in Austria, Milan and Catania in Italy, Santorini in Greece), a large number of visitors had the opportunity to navigate, in immersive mode, across geological landscapes reconstructed by cutting-edge, unmanned aerial system-based photogrammetry techniques. The reconstructed virtual geological environments are specifically chosen virtual geosites, from Santorini (Greece), the North Volcanic Zone (Iceland), and Mt. Etna (Italy). Following the user experiences, we collected 459 questionnaires, with a large spread in participant age and cultural background. We find that the majority of respondents would be willing to repeat the immersive virtual reality experience, and importantly, most of the students and Earth Science academics who took part in the navigation confirmed the usefulness of this approach for geo-education purposes.243 127 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Surface deformation during the 1928 fissure eruption of Mt. Etna (Italy): Insights from field data and FEM numerical modelling
The 1928 CE volcanic activity on eastern Etna, Italy, produced wide surface deformation and high effusion rates along fissures, with excess volumes of about 50 million m3 of lavas. This, in conjunction with the low elevation of the main eruptive vents (1150 m a.s.l.), caused the destruction of the Mascali town. Our research focuses on a multidisciplinary study from field observations and Finite Element Method modelling through COMSOL Multiphysics ®, with the aim of reconstructing the geometry, kinematics and origin of the system of faults and fissures formed during the 1928 event. We collected quantitative measurements from 438 sites of azimuth values, opening direction and aperture amount of dry fissures, and attitude and vertical offsets of faults. From west to east, four volcanotectonic settings have been identified, related to dike propagation in the same direction: 1) a sequence of 8 eruptive vents, surrounded by a 385-m wide graben, 2) a 2.5-km long single eruptive fissure, 3) a half-graben as wide as 74 m and a symmetric, 39-m-wide graben without evidence of eruption, 4) alignment of lower vents along the pre-existing Ripe della Naca faults. Field data, along with historical aerial photos, became inputs to FEM numerical models. The latter allowed us to investigate the connection between diking and surface deformation during the 1928 event, subject to a range of overpressure values (1–20 MPa), host rock properties (1–30 GPa) and geometrical complexity (stratigraphic sequence, layer thickness). In addition, we studied the distribution of tensile and shear stresses above the dike tip and gained insights into dike-induced graben scenarios. Our multidisciplinary study reports that soft (e.g. tuff) layers can act as temporary stress barriers and control the surface deformation scenarios (dike-induced graben, single fracture or eruptive fissures) above a propagating dike by suppressing the distribution of shear stresses towards the surface.799 88 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Multidisciplinary analyses for mapping and evaluating kinematics and stress/strain field at active faults and fissures at NE Rift, Mt Etna (Italy)
Strategies for disaster risk reduction in volcanic areas are mostly driven by multidisciplinary analyses, which offer effective and complementary information on complex geomorphological and volcano-tectonic environments. For example, quantification of the offset at active faults and fissures is of paramount importance to shed light on the kinematics of zones prone to deformation and/or seismic activity. This provides key information for the assessment of seismic hazard, but also for the identification of conditions that may favor magma uprising and opening of eruptive fissures. Here we present the results of a study encompassing detailed geological, structural and seismological observations focusing on part of the NE Rift at Etna volcano (Italy). The area is situated at an elevation ranging between 2700 and 1900 m a.s.l. where harsh meteorological conditions and difficult logistics render classical field work a troublesome issue. In order to bypass these difficulties, high-resolution (2.8 cm) UAV survey has been recently completed. The survey highlights the presence of 250 extension fractures, 20 normal fault segments, and 54 eruptive fissures. The study allows us to quantify the kinematics at extensional fractures and normal faults, obtaining an extension rate of 1.9 cm/yr for the last 406 yr. With a total of 432 structural data collected by UAV along with SfM photogrammetry, this work also demonstrates the suitability of the application of such surveys for the monitoring of hazardous zone.59 84 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Massive data collection in volcanic areas owing to photogrammetryderived models: a key example from the NE Rift, Mt Etna (Italy).
The collection of a conspicuous amount of data in volcanic areas is a key for a deeper understanding of the relationships between faulting, diking and superficial volcanic processes. A way to quickly collect huge amounts of data is to analyse photogrammetry-derived models (Digital surface models, orthomosaics and 3D models) using Unmanned Aerial Vehicles (UAVs) to collect all necessary pictures obtaining final models with a texture ground resolution up to 2-3 cm/pix. In this work, we describe our approach to build up models of a broad area located in the NE Rift of Mt. Etna, which is affected by continuous ground deformation linked to gravity sliding of the eastern flank of the volcano and dyke injection. The area is characterized by the presence of eruptive craters and fissures, extension fractures, and normal faults, as well as by historical lava flows. The goal was to quantify the kinematics at extensional fractures and normal faults, integrating the latter with seismological data to reconstruct the stress field acting in this peculiar sector of the volcano. By the point of view of UAV surveying, the test area is challenging since it is located at an altitude ranging between 2700 and 1900 m a.s.l., and it is affected by extreme weather conditions, like a strong wind. Resulting models, in the form of DSM and orthomosaic, are characterised by a resolution of 11.86 and 2.97 cm/pix, respectively, obtained from the elaboration of 4018 photos and covering an area of 2.2 km2. Thanks to these models, we recognized the presence of 20 normal fault segments, 250 extension fractures, and 54 single eruptive fissures. Considering all the above mention data, we quantified the kinematics at extensional fractures and normal faults, obtaining an extension rate of 1.9 cm/yr for the last 406 yr.89 62 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Mapping and evaluating kinematics and the stress and strain field at active faults and fissures: a comparison between field and drone data at the NE rift, Mt Etna (Italy)
We collected drone data to quantify the kinematics at extensional fractures and normal faults, integrated this information with seismological data to reconstruct the stress field, and critically compared the results with previous fieldwork to assess the best practice. As a key site, we analyzed a sector of the northeast rift of Mt Etna, an area affected by continuous ground deformation linked to gravity sliding of the volcano’s eastern flank and dike injections. The studied sector is characterized also by the existence of eruptive craters and fissures and lava flows. This work shows that this rift segment is affected by a series of NNE- to NE-striking, parallel extensional fractures characterized by an opening mode along an average N105.7 vector. The stress field is characterized by a Hmin trending northwest–southeast. Normal faults strike parallel to the extensional fractures. The extensional strain obtained by cumulating the net offset at extensional fractures with the fault heave gives a stretching ratio of 1.003 in the northeastern part of the study area and 1.005 in the southwestern part. Given a maximum age of 1614 CE for the offset lavas, we obtained an extension rate of 1.9 cm yr1 for the last 406 years. This value is consistent with the slip along the Pernicana Fault system, confirming that the NE rift structures accommodate the sliding of the eastern flank of the volcano.885 140
