Jousset, Philippe
Preferred name
Jousset, Philippe
ORCID
8 results
Filters
Settings
The search returned 8 results
Now showing 1 - 8 of 8
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , On the Comparison of Records from Standard and Engineered Fiber Optic Cables at Etna Volcano (Italy)
Distributed Dynamic Strain Sensing (DDSS), also known as Distributed Acoustic Sensing (DAS), is becoming a popular tool in array seismology. A new generation of engineered fibers is being developed to improve sensitivity and reduce the noise floor in comparison to standard fibers, which are conventionally used in telecommunication networks. Nevertheless, standard fibers already have extensive coverage around the Earth's surface, so it motivates the use of the existing infrastructure in DDSS surveys to avoid costs and logistics. In this study, we compare DDSS data from stack instances of standard multi-fiber cable with DDSS data from a co-located single-fiber engineered cable. Both cables were buried in an area located 2.5 km NE from the craters of Mt. Etna. We analyze how stacking can improve signal quality. Our findings indicate that the stack of DDSS records from five standard fiber instances, each 1.5 km long, can reduce optical noise of up to 20%. We also present an algorithm to correct artifacts in the time series that stem from dynamic range saturation. Although stacking is able to reduce optical noise, it is not sufficient for restoring the strain-rate amplitude from saturated signals in standard fiber DDSS. Nevertheless, the algorithm can restore the strain-rate amplitude from saturated DDSS signals of the engineered fiber, allowing us to exceed the dynamic range of the record. We present measurement strategies to increase the dynamic range and avoid saturation.135 118 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Distributed dynamic strain sensing of very long period and long period events on telecom fiber-optic cables at Vulcano, Italy
Volcano-seismic signals can help for volcanic hazard estimation and eruption forecasting. However, the underlying mechanism for their low frequency components is still a matter of debate. Here, we show signatures of dynamic strain records from Distributed Acoustic Sensing in the low frequencies of volcanic signals at Vulcano Island, Italy. Signs of unrest have been observed since September 2021, with CO2 degassing and occurrence of long period and very long period events. We interrogated a fiber-optic telecommunication cable on-shore and off-shore linking Vulcano Island to Sicily. We explore various approaches to automatically detect seismo-volcanic events both adapting conventional algorithms and using machine learning techniques. During one month of acquisition, we found 1488 events with a great variety of waveforms composed of two main frequency bands (from 0.1 to 0.2 Hz and from 3 to 5 Hz) with various relative amplitudes. On the basis of spectral signature and family classification, we propose a model in which gas accumulates in the hydrothermal system and is released through a series of resonating fractures until the surface. Our findings demonstrate that fiber optic telecom cables in association with cutting-edge machine learning algorithms contribute to a better understanding and monitoring of volcanic hydrothermal systems.386 115 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Performance of a Rotational Sensor to Decipher Volcano Seismic Signals on Etna, Italy
Volcano-seismic signals such as long-period events and tremor are important indicators for volcanic activity and unrest. However, their wavefield is complex and characterization and location using traditional seismological instrumentation is often difficult. In 2019 we recorded the full seismic wavefield using a newly developed 3C rotational sensor co-located with a 3C traditional seismometer on Etna, Italy. We compare the performance of the rotational sensor, the seismometer and the Istituto Nazionale di Geofisica e Vulcanologia-Osservatorio Etneo (INGV-OE) seismic network with respect to the analysis of complex volcano-seismic signals. We create event catalogs for volcano-tectonic (VT) and long-period (LP) events combining a STA/LTA algorithm and cross-correlations. The event detection based on the rotational sensor is as reliable as the seismometer-based detection. The LP events are dominated by SH-type waves. Derived SH phase velocities range from 500 to 1,000 m/s for LP events and 300–400 m/s for volcanic tremor. SH-waves compose the tremor during weak volcanic activity and SH- and SV-waves during sustained strombolian activity. We derive back azimuths using (a) horizontal rotational components and (b) vertical rotation rate and transverse acceleration. The estimated back azimuths are consistent with the INGV-OE event location for (a) VT events with an epicentral distance larger than 3 km and some closer events, (b) LP events and tremor in the main crater area. Measuring the full wavefield we can reliably analyze the back azimuths, phase velocities and wavefield composition for VT, LP events and tremor in regions that are difficult to access such as volcanoes.315 91 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Fibre optic distributed acoustic sensing of volcanic events
Understanding physical processes prior to and during volcanic eruptions has improved significantly in recent years. However, uncertainties about subsurface structures distorting observed signals and undetected processes within the volcano prevent volcanologists to infer subtle triggering mechanisms of volcanic phenomena. Here, we demonstrate that distributed acoustic sensing (DAS) with optical fibres allows us to identify volcanic events remotely and image hidden near-surface volcanic structural features. We detect and characterize strain signals associated with explosions and locate their origin using a 2D-template matching between picked and theoretical wave arrival times. We find evidence for non-linear grain interactions in a scoria layer of spatially variable thickness. We demonstrate that wavefield separation allows us to incrementally investigate the ground response to various excitation mechanisms. We identify very small volcanic events, which we relate to fluid migration and degassing. Those results provide the basis for improved volcano monitoring and hazard assessment using DAS.413 51 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , On the comparison of strain measurements from fibre optics with a dense seismometer array at Etna volcano (Italy)
We demonstrate the capability of distributed acoustic sensing (DAS) to record volcano-related dynamic strain at Etna (Italy). In summer 2019, we gathered DAS measurements from a 1.5 km long fibre in a shallow trench and seismic records from a conventional dense array comprised of 26 broadband sensors that was deployed in Piano delle Concazze close to the summit area. Etna activity during the acquisition period gives the extraordinary opportunity to record dynamic strain changes ( 108 strain) in correspondence with volcanic events. To validate the DAS strain measurements, we explore array-derived methods to estimate strain changes from the seismic signals and to compare with strain DAS signals. A general good agreement is found between array-derived strain and DAS measurements along the fibre optic cable. Short wavelength discrepancies correspond with fault zones, showing the potential of DAS for mapping local perturbations of the strain field and thus site effect due to small-scale heterogeneities in volcanic settings.394 115 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Preface: Approaches and methods to improve risk management in volcanic areas
(2015-01); ; ; ; Active volcanoes can generate multiple types of geological hazards. Besides syneruptive threats (e.g., lava, pyroclastic flows or ash fall), other adverse events such as landslides or lahars can occur at any time. To manage these threats efficiently, three key objectives must be jointly addressed: (1) improving prevention tools, through the collection and acquisition of data on hazards and risks, and its dissemination as maps and scenarios; (2) improving crisis management capabilities, based on monitoring and early warning systems, but also reliable communications systems; and (3) reducing people’s vulnerability and developing recovery and resilience capabilities after an event has occurred. The special issue “Approaches and methods to improve risk management in volcanic areas” presents research results focusing on these three objectives. It demonstrates the utility of addressing them jointly, and particularly examines the case of volcanoes where little knowledge is available. These results were presented at the conference Integrated Approaches for Volcanic Risk Management (Hohenheim University, Stuttgart, 11/12 September 2012) of the European MIAVITA (MItigate and Assess risk from Volcanic Impact on Terrain and human Activities) project.425 249 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The 2010 explosive eruption of Java's Merapi volcano—A ‘100-year’ event
Merapi volcano (Indonesia) is one of the most active and hazardous volcanoes in the world. It is known for frequent small to moderate eruptions, pyroclastic flows produced by lava dome collapse, and the large population settled on and around the flanks of the volcano that is at risk. Its usual behavior for the last decades abruptly changed in late October and early November 2010, when the volcano produced its largest and most explosive eruptions in more than a century, displacing at least a third of a million people, and claiming nearly 400 lives. Despite the challenges involved in forecasting this ‘hundred year eruption’, we show that the magnitude of precursory signals (seismicity, ground deformation, gas emissions) was proportional to the large size and intensity of the eruption. In addition and for the first time, near-real-time satellite radar imagery played an equal role with seismic, geodetic, and gas observations in monitoring eruptive activity during a major volcanic crisis. The Indonesian Center of Volcanology and Geological Hazard Mitigation (CVGHM) issued timely forecasts of the magnitude of the eruption phases, saving 10,000–20,000 lives. In addition to reporting on aspects of the crisis management, we report the first synthesis of scientific observations of the eruption. Our monitoring and petrologic data show that the 2010 eruption was fed by rapid ascent of magma from depths ranging from 5 to 30km. Magma reached the surface with variable gas content resulting in alternating explosive and rapid effusive eruptions, and released a total of ~0.44Tg of SO2. The eruptive behavior seems also related to the seismicity along a tectonic fault more than 40km from the volcano, highlighting both the complex stress pattern of the Merapi region of Java and the role of magmatic pressurization in activating regional faults. We suggest a dynamic triggering of the main explosions on 3 and 4 November by the passing seismic waves generated by regional earthquakes on these days.363 71 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Gravity ‘‘steps’’ at Mt. Etna volcano (Italy): Instrumental effects or evidences of earthquake-triggered magma density changes?
(2009-01-06); ; ; ;Carbone, D.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Catania, Catania, ItaliaMusumeci, C.; Istituto Nazionale di Geofisica e Vulcanologia, Sezione Catania, Catania, ItaliaOn two occasions, sudden gravity changes occurred simultaneously at two summit Etna’s stations, during local low-magnitude earthquakes. A systematic coupling between earthquakes inducing comparable maximum acceleration and displacement at the observation points and gravity steps is missing, implying (1) the non-instrumental nature of the steps and (2) the need for particular underlying conditions for the triggering mechanism(s) to activate. We review some of the volcanological processes that could induce fast underground mass redistributions, resulting in gravity changes at the surface. These processes involve bubbles and crystals present in the magma and require particular conditions in order to be effective as mass-redistributing processes. The gravity steps could be a geophysical evidence of the dynamical stress transfer between tectonic and magmatic systems at a local scale. Given the implications that these transfers may have on the volcanic activity, routine volcano monitoring should include the observation of fast gravity changes.303 253
