Skip to main content
The search returned 5 results
Now showing 1 - 5 of 5
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Atmospheric sources and sinks of volcanogenic elements in a basaltic volcano (Etna, Italy)

    This study reports on the first quantitative assessment of the geochemical cycling of volcanogenic elements, from their atmospheric release to their deposition back to the ground. Etna’s emissions and atmospheric depositions were characterised for more than 2 years, providing data on major and trace element abundance in both volcanic aerosols and bulk depositions. Volcanic aerosols were collected from 2004 to 2007, at the summit vents by conventional filtration techniques. Precipitation was collected, from 2006 to 2007, in five rain gauges, at various altitudes around the summit craters. Analytical results for volcanic aerosols showed that the dominant anions were S, Cl, and F, and that the most abundant metals were K, Ca, Mg, Al, Fe, and Ti (1.5–50 lg m 3). Minor and trace element concentrations ranged from about 0.001 to 1 lg m 3. From such analysis, we derived an aerosol mass flux ranging from 3000 to 8000 t a 1. Most analysed elements had higher concentrations close to the emission vent, confirming the prevailing volcanic contribution to bulk deposition. Calculated deposition rates were integrated over the whole Etna area, to provide a first estimate of the total deposition fluxes for several major and trace elements. These calculated deposition fluxes ranged from 20 to 80 t a 1 (Al, Fe, Si) to 0.01–0.1 t a 1 (Bi, Cs, Sc, Th, Tl, and U). Comparison between volcanic emissions and atmospheric deposition showed that the amount of trace elements scavenged from the plume in the surrounding of the volcano ranged from 0.1% to 1% for volatile elements such as As, Bi, Cd, Cs, Cu, Tl, and from 1% to 5% for refractory elements such as Al, Ba, Co, Fe, Ti, Th, U, and V. Consequently, more than 90% of volcanogenic trace elements were dispersed further away, and may cause a regional scale impact. Such a large difference between deposition and emission fluxes at Mt. Etna pointed to relatively high stability and long residence time of aerosols in the plume.
      573  41
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    The impact of volcanic emissions on Etna’s snow cover

    Volcanoes are one of the major natural sources of several trace elements to the atmosphere: They contribute to atmospheric pollution by increasing the amount of reactive and greenhouse gases and aerosols. In particular, Mt. Etna is considered to be, on long-term average, the major global atmospheric point source of many environmental harmful compounds. Their emission occurs either through continuous passive degassing from open-conduit activity or through sporadic paroxysmal eruptive activity, in the form of gases, aerosols or particulate. For several months during the year (generally December-May), the summit of Mt. Etna is under a thick blanket of snow. This huge reservoir of frozen water, interacting with the volcanic plume, accumulates a great quantity of volcanogenic elements during the winter. Samples of snow were collected at different distances from summit craters along an 8 km radial transects, in the 2006 and 2007 winters. Each snow sample was analyzed for 37 elements in the laboratory using IC, ICP-OES and ICP-MS techniques. The impact of volcanic emissions is clearly detectable considering the opposite trends of pH and TDS (total dissolved solid) measured in snow samples with increasing distance from their “source”. The pH values range from 1.7 on the rim of the summit craters up to 7.6 at a distance of about 8 km, and TDS ranges from diluted samples (few mg/l) at distal sites, up to extremely concentrated samples (500 - 3500 mg/l) close to the emission vents. The acidity in precipitation around the volcano depends mainly on the concentrations of volcanogenic acid forming ions (SO2, HCl and HF), as well as on concentrations of mainly geogenic alkaline species, which may eventually neutralize the acidity. Regarding metals concentrations, there are orders of magnitude of difference between the different sites with decreasing values from the crater’s rim up to the farthest sites (5-8 km from craters). In particular three groups of elements were extremely enriched (many orders of magnitude higher) at the summit craters with respect to the distal samples: Halogens (Br, Cl, F, I) and S ascribable to volcanic gas contribution; Al, Fe and Ti deriving from magmatic silicate particulate; and elements such as Se, Cu, As, Bi, Cd, Tl, Pb and Hg which are highly mobile in the high temperature volcanic environment.
      486  253
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Chemical and mineralogical characterization of Etnean volcanic emissions using active biomonitoring technique (moss-bags)

    Biomonitoring may be defined as the use of organisms and biomaterials (biomonitors) to obtain informations on certain characteristics of a particular medium (atmosphere, hydrosphere etc.). In particular, mosses accumulate large amounts of trace metals, making them good bioaccumulators to estimate atmospheric pollution. The moss-bags technique, introduced in the early 1970’, has become very popular. Such active biomonitoring technique is particularly useful in highly polluted areas and has been extensively used in industrial and/or urban areas to examine deposition patterns and to recognize point sources of pollution. The main objective of this study, which represents the first application of the moss-bags technique in an active volcanic area, was to test its efficacy in such environment. Complementary objectives were: to determine the different behaviour and the areal dispersion of volcanogenic elements emitted from Mt. Etna; to characterize the morphology and mineralogy of particles transported in the plume-system, basing on microscopy investigation. A mixture of Sphagnum species was picked in a clean area, treated in laboratory (rinsed, dried and packed) and exposed in field for 1 month. Sites were chosen considering the prevailing wind at Mt. Etna’s summit. Milled samples were analyses for major and trace elements concentrations, after microwave digestion (HNO3 + H2O2), by ICP-MS and ICP-OES techniques. Morphology and mineralogy of volcanic particulate were investigated by using a SEM with EDS. Analyses clearly showed the efficacy of the moss-bags technique also in this peculiar environment. Several elements were strongly enriched in the mosses exposed to the volcanic emissions. The highest enrichment was measured close to the summit crater, but evidences of metals bioaccumulation were also found in down wind sites, at several km from the volcanic source. The accumulation factor (exposed/unexposed moss) allowed us to distinguish a group of elements (Tl, Bi, Se, Cu, As, Cd, S), which are highly mobile in the high temperature volcanic environment. Also alkali metals showed a significant increase in their concentrations, probably because of their affinity for the halide species carried by the volcanic plume. Microscopic observations evidenced sulphate and halide crystals on particles trapped by the mosses. Mosses exposed at sites directly fumigated by the volcanic plume showed crystal growth also directly on the moss surface.
      180  158
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    First application of active biomonitoring techniques (moss-bags) to map the dispersion of volcanic emissions

    Biomonitoring may be defined as the use of organisms and biomaterials (biomonitors) to obtain informations on certain characteristics of a particular medium (atmosphere, hydrosphere etc.). In particular, mosses accumulate large amounts of trace metals, making them good bioaccumulators to estimate atmospheric pollution. The moss-bags technique, introduced in the early 1970’, has become very popular. Such active biomonitoring technique is particularly useful in highly polluted areas and has been extensively used in industrial and/or urban areas to examine deposition patterns and to recognize point sources of pollution. The main objective of this study, which represents the first application of the moss-bags technique in an active volcanic area, was to test its efficacy in such environment. Complementary objectives were: to determine the different behavior and the geographic dispersion of volcanogenic elements emitted from Mt. Etna; to check the usefulness of a simpler analytical techniques (leaching instead of mineralization of the moss samples). A mixture of Sphagnum species was picked in a clean area, treated in laboratory (washed, dried and packed) and exposed in field for 1 month. Sites were chosen considering the prevailing wind at Mt. Etna’s summit. Milled samples were analyses for major and trace elements concentrations, after microwave digestion (HNO3 + H2O2), by ICP-MS and ICP-OES techniques. The same elements were also analyzed after simple leaching with deionized water (1/50 weight ratio for 4 hours). Leaching solutions were also analyzed by IC for F, Cl and SO4. Analyses clearly showed the efficacy of the moss-bags technique also in this peculiar environment. Several elements were strongly enriched in the mosses exposed to the volcanic emissions. The highest enrichment was measured close to the summit crater, but evidences of metals bioaccumulation were also found in down wind sites, at several km from the volcanic source. The accumulation factor (exposed/unexposed moss) allowed us to distinguish a group of elements (Tl, Bi, Se, Cu, As, Cd, S), which are highly mobile in the high temperature volcanic environment. Also alkali metals showed a significant increase in their concentrations, probably because of their affinity for the halide species carried by the volcanic plume. Also the simple and cheap leaching technique gave important indications on the plume dispersion pattern, especially for highly volatile elements (F, Cl, S, Tl).
      162  197
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    First 13C/12C isotopic characterisation of volcanic plume CO2

    We describe analytical details and uncertainty evaluation of a simple technique for the measurement of the carbon isotopic composition of CO2 in volcanic plumes. Data collected at Solfatara and Vulcano, where plumes are fed by fumaroles which are accessible for direct sampling, were first used to validate the technique. For both volcanoes, the plume-derived carbon isotopic compositions are in good agreement with the fumarolic compositions, thus providing confidence on the method, and allowing its application at volcanoes where the volcanic component is inaccessible to direct sampling. As a notable example, we applied the same method to Mount Etna where we derived a δ13C of volcanic CO2 between −0.9±0.27‰ and −1.41± 0.27‰ (Bocca Nuova and Voragine craters). The comparison of our measurements to data reported in previous work values of Etna CO2 from~ −4‰, in the 1970’s and the 1980’s, to~ −1‰ at the present time (2009). This shift toward more positive δ13C values matches a concurrent change in magma composition and an increase in the eruption frequency and energy. We discuss such variations in terms of two possible processes: magma carbonate assimilation and carbon isotopic fractionation due to magma degassing along the Etna plumbing system. Finally, our results highlight potential of systematic measurements of the carbon isotopic composition of the CO2 emitted by volcanic plumes for a better understanding of volcanic processes and for improved surveillance of volcanic activity.
      326  22