Bonci, L.
The search returned 7 results
Now showing 1 - 7 of 7
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Active crustal extension in the central Apennines (Italy)
(2001-03-06); ; ; ; D'Agostino, N.; Dip. Scienze Geologiche, Univ. Roma TreWe present the first GPS estimate of crustal extension in the central Apennines (Italy) through the analysis of the deformation of a sub-network of the National GPS Geodetic network IGM95 in the interval 1994–1999. The selected sub-network spans the entire active deformation belt perpendicularly to its axis and allows the evaluation of (1) the total extension rate absorbed in this sector of the Apennines and (2) the seismogenic potential of the normal faults active in the Late Pleistocene-Holocene interval within the network. Results of this reoccupation are consistent with an extensional strain rate of 0.18×10−6 yr−1 concentrated in an area of about 35 km width, giving an average extension rate of 6±2 mm/yr across the central Apennines. The pattern of active deformation suggests active elastic strain accumulation on the westernmost of the two fault systems active in the Late Pleistocene-Holocene interval and may also suggest the presence of another active fault system not recognized so far.178 27 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Coseismic and post-seismic slip of the 2009 L'Aquila (central Italy) MW 6.3 earthquake and implications for seismic potential along the Campotosto fault from joint inversion of high-precision levelling, InSAR and GPS data
(2014-03-15); ; ; ; After the April 6th 2009 MW 6.3 (ML 5.9) L'Aquila earthquake (central Italy), we re-measured more than 100 km of high-precision levelling lines in the epicentral area. The joint inversion of the levelling measurements with InSAR and GPS measurements, allowed us to derive new coseismic and post-seismic slip distributions and to de- scribe, with high resolution details on surface displacements, the activation and the slip distribution of a second- ary fault during the aftershock sequence that struck the Campotosto area (major event MW 5.2). Coseismic slip on the Paganica fault occurred on one main asperity, while the afterslip distribution shows a more complex pattern, occurring on three main patches, including both slips on the shallow portions and on the deeper parts of the rup- ture plane. The comparison between coseismic and post-seismic slip distributions strongly suggests that afterslip was triggered at the edges of the coseismic asperity. The activation of a segment of the Campotosto fault during the aftershock sequence, with a good correlation between the estimated slipping area, moment release and distribution of aftershocks, raises the opportunity to discuss the local seismic hazard following the occurrence of the 2009 L'Aquila mainshock. The Campotosto fault appears capable of generating earthquakes as large as his- torical events in the region (M N 6.5) or as small as the ones associated with the 2009 sequence. In the case that the Campotosto fault is accumulating a significant portion of the current interseismic deformation, the 2009 MW N 5 events will have released only a small amount of the accumulated elastic strain, and then a significant hazard still remains in the area. Continuing geodetic monitoring and a densification of the GPS networks in the region are therefore needed to estimate the tectonic loading across the different recognized active fault systems in this part of the Apennines.577 118 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Co-seismic displacements associated to the Molise (Southern Italy)earthquake sequence of October–November 2002 inferred from GPS measurements
(2007-01-23); ; ; ; The 2002 earthquake sequence of October 31 and November 1 (main shocks Mw=5.7) struck an area of the Molise region in Southern Italy. In this paper we analyzed the co-seismic deformation related to the Molise seismic sequence, inferred from GPS data collected before and after the earthquake, that ruptured a rather deep portion of crust releasing a moderate amount of seismic energy with no surface rupture. The GPS data have been reduced using two different processing strategies and softwares (Bernese and GIPSY) to have an increased control over the result accuracy, since the expected surface displacements induced by the Molise earthquake are in the order of the GPS reliability. The surface deformations obtained from the two approaches are statistically equivalent and show a displacement field consistent with the expected deformation mechanism and with no rupture at the surface. In order to relate this observation with the seismic source, an elastic modeling of fault dislocation rupture has been performed using seismological parameters as constraints to the model input and comparing calculated surface displacements with the observed ones. The sum of the seismic moments (8.9×1017 Nm) of the two main events have been used as a constraint for the size and amount of slip on the model fault while its geometry has been constrained using the focal mechanisms and aftershocks locations. Since the two main shocks exhibit the same fault parameters (strike of the plane, dip and co-seismic slip), we modelled a single square fault, size of 15 km×15 km, assumed to accommodate the whole rupture of both events of the seismic sequence. A vertical E–W trending fault (strike=266°) has been modeled, with a horizontal slip of 120 mm. Sensitivity tests have been performed to infer the slip distribution at depth. The comparison between GPS observations and displacement vectors predicted by the dislocation model is consistent with a source fault placed between 5 and 20 km of depth with a constant pure right-lateral strike-slip in agreement with fault slip distribution analyses using seismological information. The GPS strain field obtained doesn't require a geodetic moment release larger than the one inferred from the seismological information ruling out significant post-seismic deformation or geodetic deformation released at frequencies not detectable by seismic instruments. The Molise sequence has a critical seismotectonic significance because it occurred in an area where no historical seismicity or seismogenic faults are reported. The focal location of the sequence and the strike-slip kinematics of main shocks allow to distinguish it from the shallower and extensional seismicity of the southern Adriatic block from the northern one.221 37 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Implicazioni geodinamiche delle recenti misure geodetiche nello Stretto di Messina
(2001); ; ; ; Il 28 dicembre 1908 lo Stretto di Messina veniva colpito da un disastroso evento sismico di ms=7.5. L'evento è il più forte tra i terremoti italiani degli utimi 100 anni.175 22 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Active crustal extension and strain accumulation from GPS data in the Molise region (central-southern Apennines, Italy)
In this paper, we report new GPS measurements which indicate active NE-SW extension and strain accumulation in the Molise region (Apennines, Italy). The GPS observations were collected during campaigns on benchmarks of the dense IGM95 network (average distance 20 km), spanning a maximum observation interval of 13 years, and have been integrated with measurements from the available permanent GPS sites. Considering the differential motion of the GPS sites, located on the Tyrrhenian and Adriatic coasts, we can evaluate a 4-5 mm/yr extension accommodated across this part of the Apennines. The velocity field exhibits clusters of sites with homogeneous velocity vectors, outlining two main divergence areas, both characterized by the largest velocity gradients: one near Venafro and the other near Isernia where two primary active faults and several historical earthquakes have been documented. These results suggest that an active extension in this part of the Apennines can be currently distributed between the two faults systems associated with the largest earthquakes of this region.387 441 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Geodynamic implications of new geodetic measurements in the Messina Straits Area
(2001); ; ; ; Th Messina Straits (southern Italy) on December 28, 1908 was struck by a Ms=7.5, seismic event, that was the largest earthquake occurred in Italy during the last 100 years. The earthquake and the related tsunami caused thousands of victims and severe destruction in a wide area along the Sicilian and Calabrian coasts. After that time many geophysical and geological studies were developed to evaluate the seismic characteristics of the 1908 earthquake, the seismic risk and the geological evolution of the region in the framework of the Mediterranean geodynamics, characterized by the collision between the African and Eurasian plates. With the aim to evaluate the present crustal motion of this area, that undergone a recent tectonic evolution that produced an important uplift during the last 125 Kyears, since 1970 was started a geodetic research. A geodetic network was set up across the Straits and repeatedly measured with terrestrial techniques till 1980. In 1987, a 7 vertices network (4 vertices in common with the already existent network) was surveyed for the first time by the GPS space technique, improving the accuracy of the coordinate determinations. Finally, in 1994 a wider network was established and surveyed again to collect additional GPS observations about a larger area across the Straits. In this paper we provide a general geophysical description of the Area and the results obtained by the analysis of two GPS surveys (1987 and 1994) with respect to those achieved by the terrestrial surveys (from 1970 to 1980). Our analysis leads to exclude the occurrence of significant crustal horizontal deformations across the Straits in ha last 15 years; this conclusion is in agreement with current geophysical models that exclude any aseismic deformations acting in this area.207 165 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Evidence for localized active extension in the central Apennines (Italy) from global positioning system observations
(2011-04); ; ; ; To assess how contemporary crustal extension is accommodated in the central Apennines, we use a new continuous and survey-style global positioning system velocity solution and model the velocity field using a bicubic spline interpolation method. The partitioning of contempo- rary deformation over the ~100-km-wide central Apennines belt reveals a pattern of strain accumulation that largely reflects the spatial distribution of historic and recent seismicity. The highest gradients of horizontal velocities are observed across those faults associated with M > 6 historical earthquakes. Dislocation modeling shows that interseismic elastic loading, in which creep occurs below the seismogenic upper crust on the downdip extensions of histori- cally active faults, reproduces the observed velocity gradients. The current resolution level of Quaternary fault slip rates estimates hinders the comparison with past deformation patterns and, in particular, the discrimination between (1) migrating episodes of short-term focused activity, (2) a distributed pattern of simultaneous deformation on parallel fault systems, or (3) long-term localization of active extension. Taking into account geomorphological evidence, we propose that the geodetically observed deformation spatially corresponds with a long-term localization of strain along the long-wavelength (>100 km) topographic bulge caused by its highest gravitation potential energy relative to surrounding lowlands.255 38
