Skip to main content
The search returned 32 results
Now showing 1 - 10 of 32
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    First evidence of a geodetic anomaly in the Campi Flegrei caldera (Italy) ground deformation pattern revealed by DInSAR and GNSS measurements during the 2021–2023 escalating unrest phase

    Campi Flegrei caldera is an Italian high-risk volcano experiencing a progressively more intense long-term uplift, accompanied by increasing seismicity and geochemical emissions over the last two decades. Ground deformation shows an axisymmetric bell-shaped pattern, with a maximum uplift of about 120 cm, from 2005, in the caldera central area. We analyzed Sentinel-1 and COSMO-SkyMed Multi-Temporal DInSAR measurements and GNSS data to reveal and investigate a geodetic anomaly that has clearly manifested since 2021, locally deviating from the typical bell-shaped deformation pattern. This anomaly is located east of Pozzuoli town, in the Mt. Olibano-–Accademia area, covers an area of about 1.3 km and shows, in comparison to surrounding areas, a maximum uplift deficit of about 9 cm between 2021 and 2023. To investigate the anomaly causes, we analyzed the caldera seismicity and inverted the DInSAR data to determine the primary source of the ground deformation pattern, which is consistent with a penny-shaped source located approximately 3800 m beneath the Pozzuoli town, with a radius of about 1200 m. We also found that the time evolution of the uplift deficit in the geodetic anomaly area correlates well with the earthquake occurrence, with the greater magnitude events clustering in this area. These considerations suggest the geodetic anomaly is a local response to the tensile stress regime produced by the inflating primary deformation source. This phenomenon can be influenced by the Mt. Olibano–Accademia lava domes lithological heterogeneities that may induce a localized reaction to ground deformation during the in flationary phase. Our interpretation aligns with the concentration of earthquakes and hydrothermal fluid emissions in this area, indicating the presence of faults, fractures, and fluid circulation. Accordingly, the geodetic anomaly area represents a zone of crustal weakness that requires careful monitoring and study.
      23  144
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    The 2004–2006 uplift episode at Campi Flegrei caldera (Italy): Constraints from SBAS-DInSAR ENVISAT data and Bayesian source inference

    We investigate the 2004–2006 uplift phase of Campi Flegrei caldera (Italy) by exploiting the archive of ascending and descending ENVISAT SAR data acquired from November 2002 to November 2006. The SBAS-DInSAR technique is applied to generate displacement mean velocity maps and time series. An appropriate post-processing step is subsequently applied to map the areas whose temporal deformation behavior is correlated with that of the maximum uplift zone. Our results show that the deformation also extends outside the volcanological limits of the Neapolitan Yellow Tuff caldera, without significant discontinuities. The DInSAR data are inverted by considering a finite spheroid and an isotropic pointsource. The inversion results suggest that the new uplift is characterized by a source location similar to the previous small uplift event of 2000 and to the long term subsidence of the 1990’s. In particular, the source is located at a depth of about 3.2 km and very close to the city of Pozzuoli (about 800 m offshore, to the SW); the associated volume variation is about 1.1 106 m3/year.
      368  37
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Bayesian source inference of the 1993–1997 deformation atMount Etna (Italy) by numerical solutions

    Deformation data collected at Mount Etna from 1993 to 1997 show that the inflation of the volcano edifice is accompanied by instability of the eastern flank. We propose a 3-D finite element model including topography and lateral variations of elastic constants. Source parameters of the inflating source are constrained by a direct search followed by an appraisal stage of the sampled solutions. The instability of the eastern flank is addressed using a kinematic approach, consisting of a rigid-body translation over a prescribed area. The aim is to evaluate how source parameters are affected by sliding of the eastern flank. When sliding is accounted for, the inferred source location shifts ∼1 km SE and its strength decreases by ∼20 per cent.
      493  29
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Volcanic structures investigation through SAR and seismic interferometric methods: The 2011–2013 Campi Flegrei unrest episode

    Observations from satellites provide high-resolution images of ground deformation allowing to infer deformation sources by developing advanced modeling of magma ascent and intrusion processes. Nevertheless, such models can be strongly biased without a precise model of the internal structure of the volcano. In this study, we jointly exploited two interferometric techniques to interpret the 2011–2013 unrest at Campi Flegrei caldera (CFc). The first is the Interferometric Synthetic Aperture Radar (InSAR) technique, which provides highly-resolved spatial and temporal images of ground deformation. The second is the Ambient Noise Tomography (ANT), which images subsurface structures, providing the constraints necessary to infer the depth of the shallow source at CFc (between 0.8 and 1.2 km). We applied for the first time a tool to delineate the deformation source boundaries from the observed deformation maps: the Total Horizontal Derivative (THD) technique. The THD processes the vertical component of the ground deformation field detected through InSAR applied to COSMO-SkyMed data. The patterns retrieved by applying the THD technique show consistent spatial correlations with (1) the seismic group-velocity maps achieved through the ANT and (2) the distribution of the earthquakes nucleated during the unrest at ~1 km. High-velocity anomalies, the retrieved geometrical features of the deformation field, and the spatial distribution of seismicity coincide with extinct volcanic vents in the eastern part of the caldera (Solfatara/ Pisciarelli and Astroni). Such a coincidence hints at a significant role of the extinct plumbing system in either constraining or channeling the eastward propagation of magmatic fluids. Here, we demonstrated that a joint analysis of the InSAR patterns, seismic structures, and seismicity allows us to model in space and time the characteristics and nature of the shallow deformation source at CFc. Using published literature, we show that the effects of structural heterogeneities at shallow depths may have a more significant early-stage impact on the evolution of the surface displacement signals than deeper magmatic sources: these secondary structural effects may produce local amplification in the deformation records which can be mistakenly interpreted as early signals of impending eruptions. The achieved results are particularly relevant for the understanding of the origin of deformation signal at volcanoes where magma propagation within sills is expected, as at CFc.
      404  154
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Deformation and eruptions at Mt. Etna (Italy): A lesson from 15 years of observations

    (2009-01-28) ; ; ; ;
    Volcanoes deform as a consequence of the rise and storage of magma; once magma reaches a critical pressure, an eruption occurs. However, how the edifice deformation relates to its eruptive behavior is poorly known. Here, we produce a joint interpretation of spaceborne InSAR deformation measurements and volcanic activity at Mt. Etna (Italy), between 1992 and 2006. We distinguish two volcano-tectonic behaviors. Between 1993 and 2000, Etna inflated with a starting deformation rate of 1 cm yr 1 that progressively reduced with time, nearly vanishing between 1998 and 2000; moreover, low-eruptive rate summit eruptions occurred, punctuated by lava fountains. Between 2001 and 2005, Etna deflated, feeding higher-eruptive rate flank eruptions, along with large displacements of the entire East-flank. These two behaviors, we suggest, result from the higher rate of magma stored between 1993 and June 2001, which triggered the emplacement of the dike responsible for the 2001 and 2002–2003 eruptions. Our results clearly show that the joint interpretation of volcano deformation and stored magma rates may be crucial in identifying impending volcanic eruptions.
      308  147
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Ground deformation of Long Valley caldera and Mono Basin, eastern California, mapped by satellite radar interferometry

    We have illustrated the key results of the Differential SAR Interferometry (DInSAR) analysis focused on the ground deformation of Long Valley caldera and Mono Basin, eastern California. In particular, we have applied the DInSAR algorithm referred to as Small BAseline Subset (SBAS) approach and processed 21 SAR images, spanning the time interval from 1992 to 2000, acquired from descending arbits by the ERS-1 and ERS-2 sensors of the European Space Agency (ESA). The deformation affecting the resurgent dome of Long Valley caldera has been highlighted as well as the previously unreported subsidence of the Pahoa island, located in Mono Lake.
      193  27
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Volcanic spreading of Vesuvius, a new paradigm for interpreting its volcanic activity

    We integrate geologic, structural, leveling and Differential SAR Interferometry data to show that Vesuvius began to spread onto its sedimentary substratum about 3,600 years ago. Moreover, we model the detected deformation with a solution of the lubrication approximation of the Navier-Stokes equations to show that spreading may continue for about 7,200 years more. Correlation of volcanic spreading with phases of the eruptive activity suggests that Plinian eruptions, which are thought to pose the major hazard, are less likely to occur in the near future.
      217  139
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Automatic seismic source modeling of InSAR displacements

    In this work we describe the implementation of a processing chain for a fully automatic modeling of the seismic source parameters and its slip distribution through the inversion of the InSAR displacements generated from the EPOSAR service. This processing chain consists of a suite of procedures and algorithms handling a sequence of steps: selection of the highest quality InSAR datasets, definition of the area of interest, image sampling, nonlinear and linear inversions to get, respectively, the source geometry and its slip distribution. A set of side procedures and interfaces also allows an interactive refinement and the publication of results, consisting of scientific data and graphical outputs. The whole procedure has been developed, tested and validated by considering 100 events with magnitudes between 5.5 and 8.2, worldwide distributed and covering an exhaustive range of mechanisms and tectonic contexts. Main aim of this work is describing the implementation of the automatic modeling procedures, used to produce solutions in real time, already during the emergency phase. These sources, validated by experts before their publication, can be a reference for operational purposes and initial scientific analyses. The creation of this repository sets also the framework to store, out of the emergency time, more sophisticated solutions, manually revised and/or with peer-review quality.
      45  91
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    A QUANTITATIVE ASSESSMENT OF DInSAR TIME SERIES ACCURACY IN VOLCANIC AREAS: FROM THE FIRST TO SECOND GENERATION SAR SENSORS

    (IEEE, 2012-07) ; ; ; ;
    We perform a quantitative assessment of the accuracy of Differential SAR Interferometry (DInSAR) time series in volcanic areas, retrieved through “first” and “second generation” SAR data. In particular, we analyze the impact that the wavelengths and looking geometries may have in the DInSAR measurement retrieval depending on the radar system. To this aim, we focus on the DInSAR algorithm referred to as Small BAseline Subset (SBAS) to generate mean deformation velocity maps and corresponding time series starting from sequences of SAR images. Moreover, we consider collections of SAR data acquired by the ERS-1/2 and ENVISAT (C-band), and COSMO-SkyMed (Xband) sensors over the volcanic area of the Campi Flegrei caldera, Southern Italy. We invert these SAR data sequences through the SBAS-DInSAR technique, thus obtaining C- and X- band deformation time series that we compare to continuous GPS measurements, the latter assumed as reference. The achieved results provide, in addition to a clear picture of the surface deformation phenomena already occurred and occurring in the selected case study, relevant indications for the analysis of the SBAS-DInSAR time series accuracies in volcanic areas passing from the first to second generation SAR sensors.
      180  16
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Geodetic model of the 2016 Central Italy earthquake sequence inferred from InSAR and GPS data

    We investigate a large geodetic data set of interferometric synthetic aperture radar (InSAR) and GPS measurements to determine the source parameters for the three main shocks of the 2016 Central Italy earthquake sequence on 24 August and 26 and 30 October (Mw 6.1, 5.9, and 6.5,respectively). Our preferred model is consistent with the activation of four main coseismic asperities belonging to the SW dipping normal fault system associated with the Mount Gorzano-Mount Vettore-Mount Bove alignment. Additional slip, equivalent to aMw~ 6.1–6.2 earthquake, on a secondary (1) NE dipping antithetic fault and/or (2) on a WNW dipping low-angle fault in the hanging wall of the main system is required to better reproduce the complex deformation pattern associated with the greatest seismic event (the Mw 6.5 earthquake). The recognition of ancillary faults involved in the sequence suggests a complex interaction in the activated crustal volume between the main normal faults and the secondary structures and a partitioning of strain release.
      2451  471