Mottese, Antonio Francesco
Preferred name
Mottese, Antonio Francesco
The search returned 7 results
Now showing 1 - 7 of 7
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , LEAD STANNATE AS COMPONENT OF ANTIQUE YELLOW GLASSY TESSERAE FROM SICILIAN MOSAICS
New investigations carried out on lead stannate (Pb2SnO4) and lead antimonate (Pb2Sb2O7) in yellow mosaic glassy tesserae from archaeological sites of Sicily (Taormina; Lipari, Tusa and Piazza Armerina), dated early than the 4th century AD, allow to confirm the presence of lead stannate in ancient glass dated before the 4th century. The two compounds have been used either as glass opacifiers and colorants. The different refractive index between fine crystals of these compounds and the amorphous glassy matrix, in which they are immerged, prevent the complete light transmittance, giving the typical opaque appearance to the glass. While lead antimonate was used to produce opaque yellow glass from the beginning of glass production up to the Roman period, it was replaced by lead stannate from about the 4th century AD up to the end of the Roman period. Although until today only Lahil et al. (2011) reported the presence of lead stannate in the glass tesserae dated before the 4th century AD, our new results confirm its presence in the investigated yellow tesserae from several mosaics of Sicily dated early than the 4th century AD61 159 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , New perspectives for the green economy in Sicily
Geopolymers are synthetic materials, which attract increasing interest because they represent a supplementary cementitious material as an alternative to Portland cement. Geopolymers are considered as environmentally friendly materials, due to the low processing temperature and the absence of CO2 gas emissions. These ecological features, linked to their technical properties, such as high strength, high acid resistance, and/or high-temperature resistance, make them very innovative technological materials. In addition, geopolymers show good performance if realized by the utilization of secondary raw materials (industrial wastes like fly ash or slag), thus improving strong interest in such technology from countries with growing industrialization. Here, in order to reduce global impacts and to stimulate the Sicilian green economy, we provide the evaluation of the Life Cycle Assessment (LCA) through the employ of local raw materials to produce geopolymers in Sicily. To reach this aim, geopolymers have been produced in collaboration with a Sicilian cement industry, through the use of local raw materials (furnace blast slag from Sicilian steelworks and Calabrian kaolinite) and the construction of a pilot plant. The obtained results show, for different scenarios, a considerable reduction of both CO2 emissions and energy consumption, but also a general improvement of the environmental indicators.33 87 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Assessment of Natural Radioactivity and Radiological Risks in River Sediments from Calabria (Southern Italy)
This study was developed to carry out a comprehensive radiological assessment of natural radioactivity for river sediment samples from Calabria, southern Italy, and to define a baseline background for the area on a radiation map. In the studied area, elevated levels of natural radionuclides are expected, due to the outcropping acidic intrusive and metamorphic rocks from which the radioactive elements derive. To identify and quantify the natural radioisotopes, ninety river sediment samples from nine selected coastal sampling points (ten samples for each point) were collected as representative of the Ionian and the Tyrrhenian coastline of Calabria. The samples were analyzed using a gamma ray spectrometer equipped with a high-purity germanium (HPGe) detector. The values of mean activity concentrations of 226Ra, 232Th and 40K measured for the studied samples are (21.3 6.3) Bq kg1, (30.3 4.5) Bq kg1 and (849 79) Bq kg1, respectively. The calculated radiological hazard indices showed average values of 63 nGy h1 (absorbed dose rate), 0.078 mSv y1 (effective dose outdoors), 0.111 mSv y1 (effective dose indoors), 63 Bq kg1 (radium equivalent), 0.35 (Hex), 0.41 (Hin), 0.50 (activity concentration index) and 458 Sv y1 (Annual Gonadal Equivalent Dose, AGED). In order to delineate the spatial distribution of natural radionuclides on the radiological map and to identify the areas with low, medium and high radioactivity values, the Surfer 10 software was employed. Finally, the multivariate statistical analysis was performed to deduce the interdependency and any existing relationships between the radiological indices and the concentrations of the radionuclides. The results of this study, also compared with values of other locations of the Italian Peninsula characterized by similar local geological conditions, can be used as a baseline for future investigations about radioactivity background in the investigated area.40 314 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Contribution of soil compositions, harvested times and varieties on chemical fingerprint of Italian and Turkish citrus cultivars
This paper aims to define the stability over the time of chemical elemental patterns in some citrus varieties of PGI (Protected Geographical Indication) and not PGI Interdonato and Lunario cultivars coming from Italy and Turkey and to set up a range of markers useful to trace their geographical origin. During the 2015–2017 growing seasons, all fruits were collected and subjected to Inductively Coupled Mass spectrom etry (ICP-MS) analysis, in order to determine the multielemental chemical profiles. The chemical variabil ity was calculated for each element by Multi-way analysis of variance. The results highlighted how the measured Cr, Ni, Al, K, Fe and Zn levels mainly depend on the soil composition and the fingerprint allow to trace the geographical origins. Moreover, the stepwise linear discriminant analysis (SLDA) has allowed to correctly classify the 100% of lemon pulps provenances, based on Ni, Al, K, Ca and Na con tents. Finally, our study demonstrates the role played by harvest years, variety and soils composition whose interaction contributed to define the chemical fingerprints.75 4 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Environmental screening for the assessment of potentially toxic elements content in PGI soils from the Mediterranean region (Italy and Turkey)
To provide a contribution to the Thematic Strategy for Soil Protection, here we present the results of a study focused on the potentially toxic elements (PTE) content in agricultural soils’ representative for the Mediterranean region. To reach this aim, samples of 22 Italian (NE Peloritani Mountains, Sicily) and 18 Turkish (Amik Plain, Hatay) soils were collected and analyzed to evaluate their PTE content. The Italian and Turkish sites have been selected because they represent very important cultivation zones. In Amik Plain (Turkey), the dominant crops consist of cotton, wheat, corn and olives, whereas in NE Peloritani Mountains, Sicily (Italy), an appreciate citrus variety, known as the “Interdonato lemon”, guaranteed by Protected Geographical Indication label, is produced. The collected results include: (1) the assessment of PTE levels in soils; (2) the identifcation of the PTE sources; (3) the relationships between PTE contents and soil properties (pH, electrical conductivity, organic matter, CaCO3, and clay). Several multivariate statistical methods such as correlation matrix, cluster analysis and main component analysis were applied to individuate the anthropogenic vs natural origin of the PTE sources. The detected PTE levels are in decreasing order Mn>Zn>V>Cr>Cu>Ni>As>Pb>Co>Sb>Se>Cd for the Italian soils, and Mn> Ni>V>Zn>Cr>Cu>Pb>Co>As>Se>Sb>Cd for the Turkish soils. The overall obtained results allowed to defne: (a) a main lithogenic source for PTE detected in the Italian soils, except for Zn which origin is also associated to anthropogenic input; (b) a lithogenic origin for all of the PTE detected for the Turkish soils, with an associate anthropogenic contribution for Cr, Ni, V, Cu and V. The results obtained in this work enhance the knowledge in the individuation of PTE pollution sources in agricultural soils of the European Mediterranean region.54 6 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , A FLIPPED CLASSROOM EXPERIENCE: TOWARDS THE KNOWLEDGE OF NEW ECOFRIENDLY MATERIALS NAMED "GEOPOLYMERS"
Technological advances have impacted almost every facet of modern culture and even in the educational methodologies. As new technologies become available, they are often embraced in educational innovation in an attempt to enhance traditional instruction. To this purpose, the “flipped classroom” is a learning model in which content attainment is shifted forward to outside of class, then followed by teacher-facilitated concept application activities in class. The constructivist approach, realized through an active-learning style of teaching, is more important respect to the order with which the teacher participated in the learning process. In this respect, the goal is to provide an alternative teaching approach on environmental issue. In particular, thanks to active learning (flipped classroom) it is possible to know and to appreciate a new eco-friendly material named to “Geopolymers”. One of the most important environmental advantage that can be attributed to this material is represented by the lower energy requirements for its production. Thus, this material could represent a potential tool able to mitigate the environmental pollution. In this regard, the geopolymers could provide a possible solution to wastes reuse as a resource to scale down the demand for extraction of new resources. This paper looks at some positive aspects of technology and waste treatment, and deals with the production of innovative building materials obtained by waste recycling known as geopolymers. Specifically, it is important to highlight the possibility of using wastes characterized by high silica and aluminum amounts as raw materials, particularly suitable to produce geopolymers by chemical activation with alkali. This is a useful method to improve hazardous-waste management and to reduce health and environmental issues due to the strong capability of make inert hazardous waste. This solution confirms the importance of re-manufacturing, reusing and recycling and, moreover, making a waste a new raw material and helps to move toward a more circular economy where wastes become negligible and further natural resources are used in an efficient and sustainable way. The proposed topic is addressed to students and aims to arouse their interest in the fields of the environmental protection and waste management, but overall it gives the perspective of natural resource preservation, and a most efficient way of their use without depleting the planet’s resources.41 92 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Risk assessment of bottom ash from fuel oil power plant of Italy: mineralogical, chemical and leaching characterization
(2018-02-26); ; ; ; tom ash samples derived from an oil power plant located in Southern Italy. To achieve this purpose, the mineralogical and chemical properties of representative bottom ash samples were investigated through the integrated employment of different analytical techniques, i.e., X-ray powder diffraction, scanning electron microscopy, X-ray fluorescence and atomic absorption spectrometry. The obtained experimental results show that quartz, alunogen, rhomboclase and potassium hydrogen silicate are the major crystalline phases of all the analyzed samples. Furthermore, the revealed main ash constituents are SiO2 and SO3, with low contents of Fe2O3 and Al2O3, and little amounts of CaO, Na2O, K2O, MgO, P2O5 and TiO2. Among the trace elements, very high amounts of heavy metals, i.e., V, Cr, Ni, La, Pb and Mo, were detected. The comparison of the obtained heavy metal abundance data with those reported in the literature highlights significant differences. Leaching test evidenced V, Ni and Cr values that make these ashes a potential contamination source for groundwater quality and for soil, nearby the ash disposal landfills area. All the obtained findings show that these materials are highly harmful for the human health, with a greater extent for the heavy metal concentrations.110 8
