Thivet, Simon
Preferred name
Thivet, Simon
ORCID
The search returned 3 results
Now showing 1 - 3 of 3
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Standardized analysis of juvenile pyroclasts in comparative studies of primary magma fragmentation; 1. Overview and workflow
Juvenile pyroclasts, especially in the ash size range, provide important information on primary fragmentation processes, i.e., initial explosive magma fragmentation, and on the state of the magma both prior to and at the point of fragmentation and quenching. There exists an extensive body of literature focusing on the quantification of juvenile particle morphology (shape), internal textures, and surface features spanning several decades; however, a standardized method has yet to emerge for comparative studies. No community-wide consensus currently exists (i) regarding the most representative size fraction(s) to be examined, (ii) on sample preparation procedures (such as whether to use whole-particle silhouettes or 2D cross-sections), (iii) on imaging techniques and image acquisition parameters, or (iv) on the optimal morphometric parameters to measure. Lack of a standardized method precludes robust comparison between different studies and laboratories. We propose here a preliminary “best practices” and workflow for characterization of juvenile pyroclasts, for comparative studies of primary fragmentation. If the community follows such a standardized method, it will become possible to accumulate a large volume of consistent data on juvenile pyroclasts from a range of eruption styles, fragmentation mechanisms, and magma compositions. This will ultimately allow deeper insights into the full panoply of magma-to-pyroclast processes that drive particleproducing volcanic eruptions. One or more “fragmentation diagrams” may eventually be developed to allow different types of magmatic and phreatomagmatic explosive eruptions to be distinguished based on their products.163 116 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Real-time tephra-fallout accumulation rates and grain-size distributions using ASHER (ASH collector and sizER) disdrometers
ASHER, a new sensor for the characterization of tephra fallout in real time, was designed and developed for easy field deployment during volcanic eruptions. It can provide information on the accumulation rate of tephra fallout in real time as well as grain-size and settling velocity of falling particles. Particle detection is achieved with a laser barrier, with size and settling velocity being calculated from the amplitude and duration of obscuration peaks. The sampling rate (31,500 Hz), laser thickness (0.5 mm) and operation (ON/OFF state and dual acquisition mode) are adapted to minimize the noise level and allow detection of particles as small as ~100 μm. Additional measurements of weight and level of accumulated material within a removable collector allow broadening of the ASHER operation to accumulation rate from 10−2 to 103 g m-2s-1. Detailed calibration tests were performed in laboratory conditions on single grains of known shape and density along with a high-speed camera to test the capability to measure grain size and terminal velocity, and during two field campaigns at Stromboli and Etna volcanoes to test the operation in the field. Long-term field deployment has shown that combining the optical barrier with an automatic collector allows for a better characterization of tephra fallout, providing an estimate of density, and, therefore, it optimizes sensor operation and minimizes false alerts. Moreover, the low power requirements and onboard processing allows to operate the sensor remotely and solely on solar power in a remote location. Although technical improvements in sensor sensitivity and processing are still possible, the results presented suggest that ground sensors for real-time detection and analysis of tephra could potentially contribute to understanding the dynamics of explosive eruptions and could be successfully integrated into monitoring systems of active volcanoes.47 2 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Validation of an integrated satellite-data-driven response to an effusive crisis: the April–May 2018 eruption of Piton de la Fournaise
Satellite‐based surveillance of volcanic hot spots and plumes can be coupled with modeling to allow ensemble‐based approaches to crisis response. We complete benchmark tests on an effusive crisis response protocol aimed at delivering product for use in tracking lava flows. The response involves integration of four models: MIROVA for discharge rate (TADR), the ASTER urgent response protocol for delivery of high‐spatial resolution satellite data, DOWNFLOW for flow path projections, and PyFLOWGO for flow run‐out. We test the protocol using the data feed available during Piton de la Fournaise’s April–May 2018 eruption, with product being delivered to the Observatoire du Piton de la Fournaise via Google Drive. The response was initialized by an alert at 19:50Z on 27 April 2018. Initially DOWNFLOW‐FLOWGO were run using TADRs typical of Piton de la Fournaise, and revealed that flow at >120 m 3 /s could reach the island belt road. The first TADR (10– 20 m 3 /s) was available at 09:55Z on 28 April, and gave flow run‐outs of 1180–2510 m. The latency between satellite overpass and TADR provision was 105 minutes, with the model result being posted 15 minutes later. An InSAR image pair was completed six hours after the eruption began, and gave a flow length of 1.8 km; validating the run‐out projection. Thereafter, run‐outs were updated with each new TADR, and checked against flow lengths reported from InSAR and ASTER mapping. In all, 35 TADRs and 15 InSAR image pairs were processed during the 35‐day‐long eruption, and 11 ASTER images were delivered.196 123
