Department of Physics and Geology, University of Perugia, Perugia, Italy
2 results
Filters
Settings
The search returned 2 results
Now showing 1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Experimental constraints on the rheology, eruption, and emplacement dynamics of analog lavas comparable to Mercury's northern volcanic plains Authors
(2017); ; ; ; We present new viscosity measurements of a synthetic silicate system considered an analogue for the lava erupted on the surface of Mercury. In particular, we focus on the northern volcanic plains (NVP), which correspond to the largest lava flows on Mercury and possibly in the Solar System. High-temperature viscosity measurements were performed at both superliquidus (up to 1736 K) and subliquidus conditions (1569–1502 K) to constrain the viscosity variations as a function of crystallinity (from 0 to 28%) and shear rate (from 0.1 to 5 s 1). Melt viscosity shows moderate variations (4–16 Pa s) in the temperature range of 1736–1600 K. Experiments performed below the liquidus temperature show an increase in viscosity as shear rate decreases from 5 to 0.1 s 1, resulting in a shear thinning behavior, with a decrease in viscosity of ~1 log unit. The low viscosity of the studied composition may explain the ability of NVP lavas to cover long distances, on the order of hundreds of kilometers in a turbulent flow regime. Using our experimental data we estimate that lava flows with thickness of 1, 5, and 10 m are likely to have velocities of 4.8, 6.5, and 7.2 m/s, respectively, on a 5° ground slope. Numerical modeling incorporating both the heat loss of the lavas and its possible crystallization during emplacement allows us to infer that high effusion rates (>10,000 m3/s) are necessary to cover the large distances indicated by satellite data from the MErcury Surface, Space ENvironment, GEochemistry, and Ranging spacecraft.180 223 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Geophysical reconstruction of buried geological features and site effects estimation of the Middle Valle Umbra basin (central Italy)
(2020-02-20); ; ; ; The Middle Valle Umbra (central Italy) is a NW-SE 20 km long and 10 km wide Quaternary extensional basin located in the internal sector of the Apennine chain. This area historically experienced strong earthquakes that caused significant damages to the outstanding historical heritage. The same area has been recently hit by the 2016 seismic sequence of Amatrice-Visso-Norcia. With the aim to reconstruct the buried geological structures of the basin, a multi-technique geophysical approach was performed. An extended campaign of ambient noise measurements was carried out to investigate the subsurface setting, and to identify the main geological units. We performed three 2D passive arrays to analyze two different sites within the basin; their aperture was between 150 and 752 m for one site and of 48 m for the other site, to characterize the geological units in terms of sediment thickness and shear-wave velocity profile. Data collected were processed with f-k and MSPAC analysis to extract dispersion curves with good resolution in a frequency range of 0.5–10 Hz and 4.5–18 Hz for the two sites respectively. Spectral ratios were computed for every single station ambient noise measurement performed and for all the stations of the bigger array. Our final target is to extend these results to the whole valley, in order to retrieve the attitude of the main geological units and propose a reliable reconstruction of the subsurface geometry of the basin. Another point of this work is to evaluate the site response in the middle of the valley through the analysis of the earthquakes recorded by the accelerometric station IT.CSA (belonging to the Italian Civil Protection) and the corresponding recordings of the nearby rock station IT.ASS.458 178
