de Brito, Jorge
Preferred name
de Brito, Jorge
Official Name
de Brito, J
Alternative Name
Brito, J
de Brito, Jorge
Jorge de Brito
J. de Brito
ORCID
The search returned 2 results
Now showing 1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Petrography of construction and demolition waste (CDW) from Abruzzo region (Central Italy)
(2022-01-01); ; ; ; The density, colour and texture, plus mineral and chemical features of 18 ceramic-like CDW samples from the Abruzzo region (Central Italy) were characterised. The concretes, natural stones, tiles, roof-tiles, bricks and perforated bricks are either aphanitic to porphyric. Concretes and natural stones are grey to white and tend to be > 2.0 g/cm3; the masonries are brown to reddish and close to < 2.0 g/cm3. Concrete and natural stone are rich or even exclusively made up of calcite, with high amounts of CaO (>40 wt%) and LOI (volatiles, CO2 + H2O). The masonries are instead calcite-, CaO- (<25 wt%) and LOI-poor (<8 wt%) but enriched in SiO2 (45 to 70 wt%) stabilised as quartz and/or cristobalite, with significant amount of Al2O3 (12 to 20 wt%). S and Cl contents are similar among concrete, bricks and perforated bricks. The petrography of CDW concretes is similar among geographical areas with abundance of limestones used as aggregates. However, in limestone-poor areas CDW are SiO2- and Al2O3-rich, reflecting the prevalent use of masonry and/or silicate-rich construction materials, implying that each geographical area is characterised by peculiar CDW composition. Therefore, the knowledge of mesoscopic, physical and petrographic aspects has to be known for planning adequate sorting methods, promoting upcycling reusing applications. Some of the studied CDW samples are susceptible to release relative high Cr and As content.27 36 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Cement vs aggregates and textures of aggregates in a mortar: Comparative image analysis methods and analytical protocols
The types, abundance and texture of phases are crucial for reconstructing the manufacturing of historical and contemporary construction materials such as mortars. Commonly, these data are obtained on polished mesoscopic and/or thin section surfaces and imaged with several techniques. Here, a thin section from an already well-characterised mortar was analysed to unveil the amount (area%) of cement paste vs aggregates, plus the textural features of the aggregates. The thin section was imaged by a high-resolution scanner (HRS), by transmission optical microscopy (TOM) and scanning electron microscopy (SEM). The single HRS image discriminates only quartz (qz) from cement+af+ss (af: alkali-feldspar, ss: sheetsilicates). The stitched TOM image distinguishes cement from aggregates, i.e. qz+af+ss, whereas the stitched SEM image discriminates cement, pores, qz and af+ss. The amount of cement vs aggregates and the area of the different aggregates determined by SEM is more accurate since it reflects chemical attributes. 2D Fuller curves were constructed considering different types of 2D dimensional parameters extracted from both TOM and SEM digital images. Intermediate dimensional parameters for both TOM and SEM had the best match with the 3D sieving Fuller curve. SEM shows the most detailed and adaptable recognition of cement to aggregate ratio and quantification of aggregate clasts, but it is timeconsuming and expensive. HRS is rapid but only crudely accurate. TOM is more accurate and less expedite than HRS; by contrast, TOM is faster than SEM but unable to distinguish different aggregate clasts with similar optical features.8 35
