Attenuation tomography of the Southern Apennines (Italy)

Abstract

The aim of this study is to improve our knowledge of the attenuation structure in the Southern Apennines using a new amplitude ratio tomography method (Phillips et al., Geophys Res Lett 32(21): L21301, 2005) applied on both direct and coda envelope measurements derived from 150 events recorded by 47 stations of the Istituto Nazionale di Geofisica e Vulcanologia National Seismic Network (Rete Sismica Nazionale Centralizzata). The twodimensional (2-D) analysis allows us to take into account lateral crustal variations and heterogeneities of this region. Using the same event and station distribution, we also applied a simple 1-D methodology, and the performance of the 1-D and 2-D path assumptions is tested by comparing the average interstation variance for the path-corrected amplitudes using coda and direct waves. In general, coda measurement results are more stable than using direct waves when the same methodology is applied. Using the 2-D approach, we observe more stable results for both waves. However, the improvement is quite small, probably because the crustal heterogeneity is weak. This means that, for this region, the 1-D path assumption is a good approximation of the attenuation characteristics of the region. A comparison between Q tomography images obtained using direct and coda amplitudes shows similar results, consistent with the geology of the region. In fact, we observe low Q along the Apennine chain toward the Tyrrhenian Sea and higher values to the east, in correspondence with the Gargano zone that is related to the Apulia Carbonate Platform. Finally, we compared our results with the coda Q values proposed by Bianco et al. (Geophys J Int 150:10–22, 2002) for the same region. The good agreement validates our results as the authors used a completely independent methodology.