Gambino, Piera
Preferred name
Gambino, Piera
Main Affiliation
ORCID
15 results
Settings
The search returned 15 results
Now showing 1 - 10 of 15
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Slow slip events and flank instability at Mt. Etna volcano (Italy)
(2022-08-05); ; ; ; We analyzed a set of 11 slow slip events occurred during the 2006–2016 period and affecting the GNSS (Global Navigation Satellite System) stations of the unstable flank of Mt. Etna volcano. Observed surface deformation for most of the detected slow slip events, concentrates on the south-eastern edge of the unstable flank while the slow slip events involving the north-eastern edge are less frequent. Such a pattern highlights the existence of two distinct families of events, involving two contiguous sectors of the unstable flank, which occasionally slip together in large slow slip events. The modelled slips also highlight that both contiguous sectors extend ~10–12 km offshore, on areas where active tectonic lineaments such as the ESE (northward of Catania Canyon) and the N102° (along the southern slope of the Riposto Ridge) ones have been recently discovered. Equivalent seismic moments of slow slip events occurred in the last ten years (corresponding to magnitudes in the range 5.4–5.9) are larger than those associated to seismic events observed in the last 200 years, suggesting that most of the deformation affecting the eastern flank occurs aseismically.142 122 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Progetto RETRACE-3D - centRal italy EarThquakes integRAted Crustal modEl - Modello Geologico
(2021-03-29) ;RETRACE-3D, Working Group; ; ; Three-dimensional geological model of the area of the central Apennines affected by the 2016-2018 seismic sequence. The model consists of stratigraphic surfaces (top or basal unconformity of units, or sequences of units, with homogeneous behavior) and main faults of the area. The stratigraphic surfaces are, from the oldest to the most recent: the top of pre-Upper Triassic units, the top of the intra-Triassic units, the top of Calcare Massiccio, the top of the Marne157 97 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Progetto RETRACE-3D - centRal italy EarThquakes integRAted Crustal modEl - Rapporto Finale
(2021-03-29) ;RETRACE-3D, Working Group; ; ; Il progetto RETRACE-3D (centRal italy EarThquakes integRAted Crustal modEl) è volto alla caratterizzazione tridimensionale, geologica e sismotettonica, del volume di crosta terrestre che a partire dal 24 agosto 2016 è stato interessato dai terremoti di Amatrice, Visso e Norcia, e dalla relativa sequenza sismica. Il progetto è il risultato di una collaborazione tra il Dipartimento della Protezione Civile, l’Istituto Nazionale di Geofisica e Vulcanologia (INGV), il Consiglio Nazionale delle Ricerche che partecipa con l’Istituto di Geologia Ambientale e Geoingegneria (CNR-IGAG) e l’Istituto per il Rilevamento Elettromagnetico dell’Ambiente (CNR-IREA) e l’Istituto Superiore per la Protezione e la Ricerca Ambientale (ISPRA), con la collaborazione di Eni e Total, realtà private ma anch’esse parte del Servizio nazionale della Protezione Civile, che hanno messo a disposizione i propri dati di sottosuolo.171 128 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , RETRACE-3D project: a multidisciplinary collaboration to build a crustal model for the 2016-2018 central Italy seismic sequence
The RETRACE-3D project (centRal italy EarThquakes integRAted Crustal model) focused on the revision of all the available geological and geophysical data in the area interested by the 2016-2018 seismic sequence of central Italy, with the final aim to reconstruct a reliable and consistent 3D geological model of that area. It is based on a collaboration, which was framed into a formal agreement, between Dipartimento della Protezione Civile (the Italian Civil Protection Department), Istituto di Geologia Ambientale e Geoingegneria, and Istituto per il Rilevamento Elettromagnetico of the Consiglio Nazionale delle Ricerche, Istituto Nazionale di Geofisica e Vulcanologia, and Istituto Superiore per la Protezione e la Ricerca Ambientale. The agreement purpose was to develop a project aimed at the geological and seismotectonic characterisation of the crustal volume hosting that seismic sequence. We present and discuss the approach, methodology and results of the project. The 3D geological model of the study area is developed in detail down to a depth of about 12 km, and extended to the Moho based on available regional-scale information. The model is available on the RETRACE-3D project website (www.retrace3d.it).3102 359 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Flank sliding: A valve and a sentinel for paroxysmal eruptions and magma ascent at Mount Etna, Italy
Rising magma, dike intrusions, and flank collapse are observed at many volcanoes worldwide, but how they interact is still poorly documented. Extensive synthetic aperture radar interferometry and continuous global positioning system observations captured a sharp dike intrusion at Mount Etna, Italy, during the 2018 paroxysm that triggered a vigorous seaward sliding of the eastern flank connected with brittle failure and deep magmatic resourcing. We propose a feedback process between flank acceleration and magma intrusion that derives from the interaction between the long- and short-term deformation of the volcano. The flank sliding acts as a valve that modulates the emplacement and eruption of magma within the shallow system. Rapid flank acceleration could potentially evolve into sudden collapses and seismic release at shallow depth. In turn, flank slip events could act as a sentinel for changes in magma depth and paroxysmal eruptions at Mount Etna.295 9 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Long-Term Displacement Monitoring of Slow Earthflows by Inclinometers and GPS, and Wide Area Surveillance by COSMO-SkyMed Data
With reference to two slow earthflows in structurally complex clayey formations of the Italian southern Apennines, this paper shows the results of a long-term displacement monitoring using integrated systems of inclinometers and GPS, and their comparison with PSInSAR data. A fixed-in-place and traversal inclinometer system, first installed in 2004, recorded both the shear displacements along the slip bands, and the internal deformations of the landslide masses. A GPS network of permanent stations and benchmarks, installed in 2006–2007 in 23 strategic points of the slope, allowed for the temporal continuity of displacement monitoring. The two long series of data allowed to evaluate the factor scaling of the PSInSAR COSMO-SkyMed data, although the component of the displacement vector along the line of sight (LOS) was small. PSInSAR data allowed for the monitoring extension to houses and rigid structures that acted as reflectors. The joint data analysis allowed for the comprehension of the main features of the landslides’ kinematics.164 172 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Heterogeneous Behavior of the Campotosto Normal Fault (Central Italy) Imaged by InSAR GPS and Strong-Motion Data: Insights from the 18 January 2017 Events
On 18 January 2017, the 2016–2017 central Italy seismic sequence reached the Campotosto area with four events with magnitude larger than 5 in three hours (major event MW 5.5). To study the slip behavior on the causative fault/faults we followed two different methodologies: (1) we use Interferometric Synthetic Aperture Radar (InSAR) interferograms (Sentinel-1 satellites) and Global Positioning System (GPS) coseismic displacements to constrain the fault geometry and the cumulative slip distribution; (2) we invert near-source strong-motion, high-sampling-rate GPS waveforms, and high-rate GPS-derived static offsets to retrieve the rupture history of the two largest events. The geodetic inversion shows that the earthquake sequence occurred along the southern segment of the SW-dipping Mts. Laga normal fault system with an average slip of about 40 cm and an estimated cumulative geodetic moment of 9.29 × 1017 Nm (equivalent to a MW~6). This latter estimate is larger than the cumulative seismic moment of all the events, with MW > 4 which occurred in the corresponding time interval, suggesting that a fraction (~35%) of the overall deformation imaged by InSAR and GPS may have been released aseismically. Geodetic and seismological data agree with the geological information pointing out the Campotosto fault segment as the causative structure of the main shocks. The position of the hypocenters supports the evidence of an up-dip and northwestward rupture directivity during the major shocks of the sequence for both static and kinematic inferred slip models. The activated two main slip patches are characterized by rise time and peak slip velocity in the ranges 0.7–1.1 s and 2.3–3.2 km/s, respectively, and by ~35–50 cm of slip mainly concentrated in the shallower northern part of causative fault. Our results show that shallow slip (depth < 5 km) is required by the geodetic and seismological observations and that the inferred slip distribution is complementary with respect to the previous April 2009 seismic sequence affecting the southern half of the Campotosto fault. The recent moderate strain-release episodes (multiple M~5–5.5 earthquakes) and the paleoseismological evidence of surface-rupturing events (M~6.5) suggests therefore a heterogeneous behavior of the Campotosto fault.661 95 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Transient crustal deformation from karst aquifers hydrology in the Apennines (Italy)
The increasing accuracy and spatiotemporal resolution of space geodetic techniques have positively impacted the study of shallow crustal deformation in response to the redistribution of water masses. Measurable deformations have been documented in areas where snow and water variability is large and persists over sufficiently long periods. Here we analyze GPS time series and hydrological data from the Central-Southern Apennines, a tectonically-active region hosting large karst aquifers. We document the occurrence of regional-scale horizontal and vertical transient deformation that is clearly correlated to seasonal and multiyear hydrological variability. These transient signals, which are most strongly observed at GPS sites surrounding the main karst aquifers, modulate long term tectonic deformation. Our results suggest that the karst aquifers in this region experience alternating periods of expansion and contraction in response to increasing/decreasing precipitation and, consequently, higher/lower hydraulic head in the aquifers. Thanks to the availability of a dense continuous GPS network and complementary hydrological datasets, we are able to verify the processes causing the observed deformation. We model the shallow crust in the region as a continuous anelastic solid and use Green's functions for finite strain cuboid sources to estimate the strain rate distribution associated with the GPS observations. We use the Mw 6.1 L'Aquila earthquake, which struck the Central Apennines in 2009 and whose effects are evident in geodetic data, to document the potential effects of moderate earthquakes on karst aquifers and to demonstrate the importance of correctly discerning tectonic from nontectonic signals in geodetic time series. Enhanced understanding of the karst aquifers behavior is of primary interest for improved management of this vital water resource and for a better understanding of the possible interactions between groundwater content and pore pressure variations in the crust and seismicity.190 256 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Geodetic model of the 2016 Central Italy earthquake sequence inferred from InSAR and GPS data
We investigate a large geodetic data set of interferometric synthetic aperture radar (InSAR) and GPS measurements to determine the source parameters for the three main shocks of the 2016 Central Italy earthquake sequence on 24 August and 26 and 30 October (Mw 6.1, 5.9, and 6.5,respectively). Our preferred model is consistent with the activation of four main coseismic asperities belonging to the SW dipping normal fault system associated with the Mount Gorzano-Mount Vettore-Mount Bove alignment. Additional slip, equivalent to aMw~ 6.1–6.2 earthquake, on a secondary (1) NE dipping antithetic fault and/or (2) on a WNW dipping low-angle fault in the hanging wall of the main system is required to better reproduce the complex deformation pattern associated with the greatest seismic event (the Mw 6.5 earthquake). The recognition of ancillary faults involved in the sequence suggests a complex interaction in the activated crustal volume between the main normal faults and the secondary structures and a partitioning of strain release.2452 472 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Coseismic displacement waveforms for the 2016 August 24 Mw 6.0 Amatrice earthquake (central Italy) carried out from high-rate GPS data
We used High-Rate sampling Global Positioning System (HRGPS) data from 52 permanent stations to retrieve the coseismic dynamic displacements related to the 2016 August 24 Mw 6.0 Amatrice earthquake. The HRGPS position time series (named hereinafter "GPSgrams") were obtained with two different analysis strategies of the raw GPS measurements (Precise Point Positioning [PPP] and Double-Difference [DD] positioning approaches using the Gipsy-Oasis II and the TRACK (GAMIT/GLOBK) software, respectively). These GPSgrams show RMS accuracies mostly within 0.3 cm and, for each site, an agreement within 0.5 cm between the two solutions. By using cross-correlation technique, the GPSgrams are also compared to the doubly-integrated strong motion data at sites where the different instrumentations are co-located in order to recognize in the GPSgrams the seismic waves movements. The high values (mostly greater than 0.6) of the cross-correlation functions between these differently-generated waveforms (GPSgrams and the SM displacement time-histories) at the co-located sites confirm the ability of GPS in providing reliable waveforms for seismological applications.2339 233
