Skip to main content
The search returned 30 results
Now showing 1 - 10 of 30
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Characterizing the Sardinia candidate site for the Einstein Telescope

    Due to its unique geophysical features and to the low density population of the area, Sos Enattos is a promising candidate site to host the Einstein Telescope (ET), the third-generation Gravitational Wave Observatory. The geophysical characterization of the Sos Enattos former mine, close to one of the proposed ET corners, started in 2010 with the deployment of seismic and environmental sensors underground. Since 2019 a new extensive array of seismometers, magnetometers and acoustic sensors have been installed in three stations along the underground tunnels, with one additional station at the surface. Beside a new geological survey over a wider area, two boreholes about 270 m deep each were excavated at the other two corners, determining the good quality of the drilled granite and orthogneiss rocks and the absence of significant thoroughgoing fault zones. These boreholes are instrumented with broadband seismometers that revealed an outstanding low level of vibrational noise in the low-frequency band of ET-LF (2-10Hz), significantly lower than the Peterson's NLNM and resulting among the quietest seismic stations in the world in that frequency band. The low seismic background and the reduced number of seismic glitches ensure that just a moderated Newtonian noise subtraction would be needed to achieve the ET target sensitivity. Geoelectrical and active seismic campaigns have been carried out to reveal the features of the subsurface, revealing the presence of small-sized fractured areas with limited water circulation. Finally, temporary arrays of seismometers, magnetometers and acoustic sensors are deployed in the area to study the local sources of environmental noise.
      243  41
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Slope Failures Induced by the December 2002 Eruption at Stromboli Volcano

    We reconstruct the sequence of landslides that occurred soon after the beginning of the December 2002 eruption on the NW flank of Stromboli volcano. Landslides involved the northeastern part of the Sciara del Fuoco (SdF) slope, an old collapse scar filled by products of volcanic activity, producing tsunami waves that severely damaged the coast of the island of Stromboli. Volumes of the mass detached from the subaerial and submarine slope were quantified by comparing preslide and postslide slope surfaces obtained by aerophotogrammetric and bathymetric data, which also allowed, in conjunction with field observations and helicopter surveys, the reconstruction of geometry and kinematics of landslides. According to the reconstructed sequence, 2 d after the beginning of the eruption, the upper part of the NE sector of the SdF slope experienced major displacements (few tens of meters). Movements propagated downslope and affected the nearshore portion of the submerged slope without a rapid sliding of the displaced mass into the sea. The following hours were characterized by a progressive increase of deformations, localized along shear zones extending over two thirds of the subaerial slope. This phase proceeded until a submarine slide about 6 ´ 106 m3 in volume occurred, causing a first tsunami wave. The subaerial mass delimited by the shear zones and unbuttressed at its foot, then slipped into the sea producing a second tsunami wave. The main landslide event (and the minor slumps which followed) removed a volume of about 10 ´ 106 m3 of the infilling deposit, to a thickness of at least 65 m. Hypotheses were formulated on the mechanisms that controlled the different phases of the instability sequence. Since hydraulic and stress/strain conditions progressively changed during the slope evolution, the formulated mechanisms are also based on geotechnical analyses and considerations on the mechanical behavior of volcaniclastic materials. The process that led to the landslide events was initiated by forces exerted by magma intruded into the slope, while further steps of the evolution of slope stability conditions (especially the submarine failure) were controlled by the particular shear behavior of the volcaniclastic material, mainly influenced by grain crushability. In fact, strength progressively decreased as shear strains proceeded, and the intensely sheared saturated material forming the submarine slope may have become susceptible of failure when sudden strain/ stress increments occurred.
      201  33
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,
      179  446
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    High precision photogrammetry for monitoring the evolution of the NW flank of Stromboli volcano during and after the 2002–2003 eruption

    High precision aerial photogrammetry has been used in addition to other geophysical techniques such as bathymetric surveys, geodetic measurements, microseismicity recording, etc., for monitoring slope deformations and the volcanic activity of Stromboli Island (Aeolian Arc, Italy), during the last effusive eruption, which started on December 28, 2002 and soon after the major landslide/ tsunami event of December 30. Qualitative and quantitative description of topographic and morphological changes of the Sciara del Fuoco were possible thanks to a recent preeruption photogrammetric survey performed in 2001; the comparisons of 12 multi-temporal digital terrain models carried out during the period January–June 2003 were used to evaluate the displaced mass by the landslide, the lava accumulation and the erosion processes of the Sciara del Fuoco. After the end of the eruption, four additional photogrammetric surveys were performed between July 2003 and October 2005 to monitor the evolution of the slope and detect potential instability phenomena. The slope appeared significantly modified and continued to evolve, showing marked erosion both on the lower part and toward the craters terrace. Over the same period, the new lava flows showed progressive contraction of the thicker part of the lava pile caused by its cooling and compaction and the possible sliding along the shear surface of the December 2002 deep-seated movement. The present morphology seems to be far from equilibrium and the deformation processes are still ongoing, justifying a continuous monitoring activity to understand the evolution of these instability phenomena.
      170  31
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Analysis of the 2001 lava flow eruption of Mt. Etna from three-dimensional mapping

    The 2001 Etna eruption was characterized by a complex temporal evolution with the opening of seven eruptive fissures, each feeding different lava flows. This work describes a method adopted to obtain the three-dimensional geometry of the whole lava flow field and for the reconstruction, based on topographic data, of the temporal evolution of the largest lava flow emitted from a vent located at 2100 m a.s.l. Preeruption and posteruption Digital Elevation Models (DEM) were extracted from vector contour maps. Comparison of the two DEMs and analysis of posteruption orthophotos allowed us to estimate flow area, thickness, and bulk volume. Additionally, the two-dimensional temporal evolution of the 2100 flow was precisely reconstructed by means of maps compiled during the eruption. These data, together with estimates of flow thickness, allowed us to evaluate emitted lava volumes and in turn the average volumetric flow rates The analysis performed in this paper provided, a total lava bulk volume of 40.1 106 m3 for the whole lava flow field, most of which emitted from the 2100 vent (21.4 106 m3). The derived effusion rate trend shows an initial period of waxing flow followed by a longer period of waning flow. This is in agreement not only with the few available effusion rate measurements performed during the eruption, but also with the theoretical model of Wadge (1981) for the temporal variation in discharge during the tapping of a pressurized source
      458  23
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Towards a satellite-based approach to measure eruptive volumes at Mt. Etna using Pleiades datasets

    Only a few high precision studies of lava and tephra during simultaneous explosive and effusive activity have so far been undertaken. We carried out such measurements by analysis of a unique and homogeneous multi-temporal dataset of highspatial resolution satellite optical images. Digital Elevation Models (DEMs) and orthophotos (with 1- and 0.5-m-pixel resolutions respectively) were extracted from six specifically tasked Pleiades tri-stereo pairs of Mt. Etna volcano, between 2011 and 2016. During this period, frequent effusive and explosive events formed lava flow fields and built up the new south-east crater pyroclastic cone. The volumes of lava fields and proximal pyroclastic deposits were measured by comparing the Pleiades DEMs with an aerial photogrammetric DEM updated in 2007. The volumes of all distal deposits were estimated using lava and tephra partitioning from the literature for an Etnean lava fountain. The dense rock equivalent volume of lava and tephra, calculated to be 248.4 ± 2.1 × 106 m3 in total, corresponds to an average output rate of 0.98 m3/s over the analysed 8-year period (May 2008–May 2016) and to a multi-event eruption rate of 5.53 m3/s for 520 days of activity. The multi-temporal analysis of high-spatial resolution satellite DEMs, here successfully applied to the well-monitored Etna volcano, demonstrated that the tasking of high-spatial resolution satellite images is crucial for fast and effective monitoring during intense volcanic activity (frequent and overlapping eruptive events). This methodology could be used for the monitoring of remote or hazardous volcanoes that are difficult to study by means of repeated field surveys.
      383  341
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Airborne Strapdown Gravity Survey of Sos Enattos Area (NE Sardinia, Italy): Insights into Geological and Geophysical Characterization of the Italian Candidate Site for the Einstein Telescope

    (Basel : Molecular Diversity Preservation International, 2025-07-05) ; ; ; ;
    Strapdown gravity systems are increasingly employed in airborne geophysical exploration and geodetic studies due to advantages such as ease of installation, wide dynamic range, and adaptability to various platforms, including airplanes, helicopters, and large drones. This study presents results from an airborne gravity survey conducted over the northeastern sector of Sardinia (Italy), using a high-resolution strapdown gravity ensuring an accuracy of approximately 1 mGal. Data were collected at an average altitude of 1800 m with a spatial resolution of 3.0 km. The survey focused on the Sos Enattos area near Lula (Nuoro province), a candidate site for the Einstein Telescope (ET), a third-generation gravitational wave observatory. The ideal site is required to be geologically and seismically stable with a well-characterized subsurface. To support this, we performed a new gravity survey to complement existing geological and seismic data aimed at characterizing the mid-to-shallow crustal structure of Sos Enattos. Results show that the strapdown system effectively detects gravity anomalies linked to crustal sources down to ~3.5 km, with particular emphasis within the 1–2 km depth range. Airborne gravity data reveal higher frequency anomalies than those resolved by the EGM2008 global gravity model and show good agreement with local terrestrial gravity data. Forward modeling of the gravity field suggests a crust dominated by alternating high-density metamorphic rocks and granitoid intrusions of the Variscan basement. These findings enhance the geophysical understanding of Sos Enattos and support its candidacy for the ET site.
      6  50
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Application of Digital Terrain Model to volcanology

    Three-dimensional reconstruction of the ground surface (Digital Terrain Model, DTM), derived by airborne GPS photogrammetric surveys, is a powerful tool for implementing morphological analysis in remote areas. High accurate 3D models, with submeter elevation accuracy, can be obtained by images acquired at photo scales between 1:5000-1:20000. Multitemporal DTMs acquired periodically over volcanic area allow the monitoring of areas interested by crustal deformations and the evaluation of mass balance when large instability phenomena or lava flows have occurred. The work described the results obtained from the analysis of photogrammetric data collected over the Vulcano Island from 1971 to 2001. The data, processed by means of the Digital Photogrammetry Workstation DPW 770, provided DTM with accuracy ranging between few centimeters to few decimeters depending on the geometric image resolution, terrain configuration and quality of photographs.
      328  1643
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Monitoring Active Volcanos Using Aerial Images and the Orthoview Tool

    In volcanic areas, where it can be difficult to perform direct surveys, digital photogrammetry techniques are rarely adopted for routine volcano monitoring. Nevertheless, they have remarkable potentialities for observing active volcanic features (e.g., fissures, lava flows) and the connected deformation processes. The ability to obtain accurate quantitative data of definite accuracy in short time spans makes digital photogrammetry a suitable method for controlling the evolution of rapidly changing large-area volcanic phenomena. The systematic acquisition of airborne photogrammetric datasets can be adopted for implementing a more effective procedure aimed at long-term volcano monitoring and hazard assessment. In addition, during the volcanic crisis, the frequent acquisition of oblique digital images from helicopter allows for quasi-real-time monitoring to support mitigation actions by civil protection. These images are commonly used to update existing maps through a photo-interpretation approach that provide data of unknown accuracy. This work presents a scientific tool (Orthoview) that implements a straightforward photogrammetric approach to generate digital orthophotos from single-view oblique images provided that at least four Ground Control Points (GCP) and current Digital Elevation Models (DEM) are available. The influence of the view geometry, of sparse and not-signalized GCP and DEM inaccuracies is analyzed for evaluating the performance of the developed tool in comparison with other remote sensing techniques. Results obtained with datasets from Etna and Stromboli volcanoes demonstrate that 2D features measured on the produced orthophotos can reach sub-meter-level accuracy.
      308  567
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Seismic glitchness at Sos Enattos site: impact on intermediate black hole binaries detection efficiency

    Third-generation gravitational wave observatories will extend the lower frequency limit of the observation band toward 2 Hz, where new sources of gravitational waves, in particular intermediate-mass black holes (IMBH), will be detected. In this frequency region, seismic noise will play an important role, mainly through the so-called Newtonian noise, i.e., the gravity-mediated coupling between ground motion and test mass displacements. The signal lifetime of such sources in the detector is of the order of tens of seconds. In order to determine whether a candidate site to host the Einstein Telescope observatory is particularly suitable to observe such sources, it is necessary to estimate the probability distributions that, in the characteristic time scale of the signal, the sensitivity of the detector is not perturbed by Newtonian noise. In this paper, a first analysis is presented, focused on the Sos Enattos site (Sardinia, Italy), a candidate to host the Einstein Telescope. Starting from a long data set of seismic noise, this distribution is evaluated considering both the presently designed triangular ET configuration and also the classical ”L” configuration.
      453  190