Wang, Xuan
The search returned 9 results
Now showing 1 - 9 of 9
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , First Volcanic Plume Measurements by an Elastic/Raman Lidar Close to the Etna Summit Craters
olcanic emissions represent a well-known hazard mainly for aviation safety that can be reduced with real time observations and characterization of eruptive activity. In order to mitigate risks from volcanic ash, Lidar observations allow to perform immediate and accurate detection of volcanic plumes, quantify volcanic ash concentration in atmosphere and characterize optical properties of volcanic particles, improving modeling of volcanic ash clouds and their potential impact. From 14 to 17 December, 2013, Mt. Etna, in Italy, showed an intense Strombolian activity from the New South East Crater (NSEC). Lidar measurements were performed in Catania, pointing at a thin volcanic plume, clearly visible and dispersed from the summit craters toward the South East. Real-time Lidar observations captured the complex dynamics of the volcanic plume along with the pulsatory nature of the explosive activity and allowed to analyze the geometrical, optical and microphysical properties of the volcanic ash. Both the aerosol backscattering (beta(A)) and the extinction coefficient (alpha(A)) profiles at 355 nm, and their ratio [the Lidar Ratio (LR)] were measured near the volcanic source using an Elastic/Raman Lidar system. Moreover, calibrated particle linear depolarization values (delta(A)) were obtained from Lidar profiles measured in the parallel and cross polarized channels at 355 nm, thus allowing to characterize the particle shape. The beta(A), LR, and delta(A) values were used to estimate the ash concentration (gamma) profiles in the volcanic plume. This is the first study of optical properties of volcanic particles through Elastic/Raman measurements near volcanic summit craters and one of few studies which quantify the impact of weak eruptive activity in atmosphere, demonstrating that ash concentration from this type of activity was lower than the safety concentration threshold established by the International Civil Aviation Organization.374 181 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Spatio-temporal monitoring by ground-based and air- and space-borne lidars of a moderate Saharan dust event affecting southern Europe in June 2013 in the framework of the ADRIMED/ChArMEx campaign
(2017); ; ; ; During the ADRIMED (Aerosol Direct Radiative Impact on the regional climate in the Mediterranean region) special observation period (SOP-1a), conducted in June 2013 in the framework of the ChArMEx (Chemistry-Aerosol Mediterranean Experiment) project, a moderate Saharan dust event swept the Western and Central Mediterranean Basin (WCMB) from west to east during a 9-day period between 16 and 24 June. This event was monitored from the ground by six EARLINET/ACTRIS (European Aerosol Research Lidar Network/Aerosols, Clouds, and Trace gases Research Infrastructure Network) lidar stations (Granada, Barcelona, Naples, Potenza, Lecce and Serra la Nave) and twoADRIMED/ChArMEx lidar stations specially deployed for the field campaign in Cap d’en Font and Ersa, in Minorca and Corsica Islands, respectively. The first part of the study shows the spatio-temporal monitoring of the dust event during its transport over the WCMB with ground-based lidar and co-located AERONET (Aerosol Robotic Network) Sun-photometer measurements. Dust layer optical depths, Ångström exponents, coarse mode fractions, linear particle depolarization ratios (LPDRs), dust layer heights and the dust radiative forcing estimated in the shortwave (SW) and longwave (LW) spectral ranges at the bottom of the atmosphere (BOA) and at the top of the atmosphere (TOA) with the Global Atmospheric Model (GAME), have been used to characterize the dust event. Peak values of the AERONETaerosol optical depth (AOD) at 440 nm ranged between 0.16 in Potenza and 0.37 in Cap d’en Font. The associated Ångström exponent and coarse mode fraction mean values ranged from 0.43 to 1.26 and from 0.25 to 0.51, respectively. The mineral dust produced a negative SWdirect radiative forcing at the BOA ranging from −56.9 to −3.5Wm−2. TheLW radiative forcing at the BOAwas positive, ranging between +0.3 and +17.7 W m-2. The BOA radiative forcing estimates agree with the ones reported in the literature. At the TOA, the SW forcing varied between −34.5 and +7.5 W m−2. In seven cases, the forcing at the TOA resulted positive because of the aerosol strong absorbing properties (0.83 < single-scattering albedo (SSA) < 0.96). The multi-intrusion aspect of the event is examined by means of air- and space-borne lidar measurements, satellite images and back trajectories. The analysis reported in this paper underline the arrival of a second different intrusion of mineral dust observed over southern Italy at the end of the considered period which probably results in the observed heterogeneity in the dust properties.165 7 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Contribution of EARLINET/ACTRIS to the summer 2013 Special Observing Period of the ChArMEx project: monitoring of a Saharan dust event over the western and central Mediterranean
(2016-07-30); ; ; ; In the framework of the Chemistry-Aerosol Mediterranean Experiment (ChArMEx; http://charmex.lsce.ipsl.fr/) initiative, a field campaign took place in the western Mediterranean Basin between 10 June and 5 July 2013 within the ADRIMED (Aerosol Direct Radiative Impact on the regional climate in the MEDiterranean region) project. The scientific objectives of ADRIMED are the characterization of the most common ‘Mediterranean aerosols’ and their direct radiative forcing (column closure and regional scale). During 15–24 June a multiintrusion dust event took place over the western and central Mediterranean Basin. Extra measurements were carried out by some EARLINET/ACTRIS (European Aerosol Research Lidar Network /Aerosols, Clouds, and Trace gases Research InfraStructure Network, http://www.actris.net/) lidar stations in Spain and Italy, in particular on 22 June in support to the flight over southern Italy of the Falcon 20 aircraft involved in the campaign. This article describes the physical and optical properties of dust observed at the different lidar stations in terms ofdust plume centre of mass, optical depth, lidar ratio, and particle depolarization ratio. To link the differences found in the origin of dust plumes, the results are discussed on the basis of back-trajectories and air- and space-borne lidars. This work puts forward the collaboration between a European research infrastructure (ACTRIS) and an international project (ChArMEx) on topics of interest for both parties, and more generally for the atmospheric community.153 10 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Volcanic ash concentration during the 12 August 2011 Etna eruption
(2015-03-24); ; ; ; Mount Etna, in Italy, is one of the most active volcanoes in the world and an ideal laboratory to improve volcano ash monitoring and forecasting. During the volcanic episode on 12 August 2011, an eruption column rose up to several kilometers above sea level (asl), and the volcanic plume dispersed to the southeast. From the video-surveillance system, we were able to estimate variations in the column height (peak value of 9.5 ± 0.5km above sea level) with time. We derived the time-varying discharge rate (peak value of 60m3 s 1) and determined the ash concentration using a volcanic ash dispersal model. The modeled ash concentration was compared with lidar measurements using different particle effective radius, and differences are within the error bars. Volcanic ash concentrations range from 0.5 to 35.5 × 10 3gm 3. The comparison highlights that to improve volcanic ash forecasting during volcanic crises it is necessary to take into account the time-varying discharge rate of explosive eruptions.221 15 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , The Ocean Reanalyses Intercom parison Project (ORA - IP)
Uncertainty in ocean analysis methods and deficiencies in the observing system are major obstacles for the reliable reconstruction of the past ocean climate. The variety of existing ocean reanalyses is exploited in a multi-reanalysis ensemble to improve the ocean state estimation and to gauge uncertainty levels. The ensemble-based analysis of signal-to-noise ratio allows the identification of ocean characteristics for which the estimation is robust (such as tropical mixed-layer-depth,upper ocean heat content), and where large uncertainty exists (deep ocean, Southern Ocean, sea-ice thickness, salinity), providing guidance for future enhancement of the observing and data assimilation systems.431 538 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Improvement of ash plume monitoring, modeling and hazard assessment in the MED-SUV project
(2014-04-27); ; ; ; Volcanic ash clouds produced by explosive eruptions represent a strong problem for civil aviation, road transportation and other human activities. Since Etna volcano produced in the last 35 years more the 200 explosive eruptions of small and medium size. The INGV, liable for its volcano monitoring, developed since 2006 a specific system for forecasting and monitoring Etna’s volcanic ash plumes in collaboration with several national and international institutions. Between 12 January 2011 and 31 December 2013 Etna produced forty-six basaltic lava fountains. Every paroxysm produced an eruption column ranging from a few up to eleven kilometers of height above sea level. The ash cloud contaminated the controlled airspace (CTR) of Catania and Reggio Calabria airports and caused tephra fallout on eastern Sicily sometime disrupting the operations of these airports. In order to give prompt and detailed warnings to the Aviation and Civil Protection authorities, ash plumes monitoring at Osservatorio Etneo, the INGV department in Catania, is carried out using multispectral (from visible to infrared) satellite and ground-based video-surveillance images; seismic and infrasound signals processed in real-time, a Doppler RADAR (Voldorad IIB) able to detect the eruption column in all weather conditions and a LIDAR (AMPLE) for retrieving backscattering and depolarization values of the ash clouds. Forecasting is performed running tephra dispersal models using weather forecast data, and then plotting results on maps published on a dedicated website. 24/7 Control Room operators were able to timely nform Aviation and Civil Protection operators for an effective aviation safety management. A variety of multidisciplinary activities are planned in the MED-SUV project with reference to volcanic ash observations and studies. These include: 1) physical and analogue laboratory experiments on ash dispersal and aggregation; 2) integration of satellite data (e.g. METEOSAT, MODIS) and ground- based measurements (e.g., RADAR, LIDAR) of Etna’s volcanic plumes to quantify mass eruption rate, grain-size distribution at source, and ash cloud concentration; 3) improvement of tools and automatic procedures for the short-term forecasting of volcanic ash dispersal by adopting a multi-model and multi-scenario approach; 4) development of short-term forecasting tools able to use direct measurements of the plume and ash cloud in almost real time (now-casting); 5) development of long-term probabilistic ash fallout maps at the supersite volcanoes.236 258 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Monitoring Etna volcanic plumes using a scanning LiDAR
(2012-09-24); ; ; ; In this paper, we use data obtained from LiDAR measurements during an ash emission event on 15 November 2010 at Mt. Etna, in Italy, in order to evaluate the spatial distribution of volcanic ash in the atmosphere. A scanning LiDAR system, located at 7 km distance from the summit craters, was directed toward the volcanic vents and moved in azimuth and elevation to analyse different volcanic plume sections. During the measurements, ash emission from the North East Crater and high degassing from the Bocca Nuova Crater were clearly visible. Fromour analysis we were able to: (1) evaluate the region affected by the volcanic plume presence; (2) distinguish volcanic plumes containing spherical aerosols from those having non-spherical ones; and (3) estimate the frequency of volcanic ash emissions. Moreover, the spatial distribution of ash mass concentration was evaluated with an uncertainty of about 50 %.We found that, even during ash emission episodes characterised by low intensity like the 15 November 2010 event, the region in proximity of the summit craters should be avoided by air traffic operations, the ash concentration being greater than 4×10−3g/m3. The use of a scanning permanent LiDAR station may usefully monitor the volcanic activity and help to drastically reduce the risks to aviation operations during the frequent Etna eruptions.179 33 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Lidar depolarization measurement of fresh volcanic ash from Mt. Etna, Italy
(2012-08-08); ; ; ; A small, portable, polarization lidar system with scanning capability was used to perform range resolved measurements of fresh erupted volcanic plume from Mount Etna in Italy. Measurements were carried out on November 15, 2010 during a volcanic plume emission event by placing the lidar very close to volcano summit craters. Depolarization measurements highlighted that aerosol of different shape and optical properties were emitted by the two involved vents, Bocca Nuova and North-East Craters. In the plume emitted from Bocca Nuova Crater the mean value of aerosol linear depolarization ratio resulted near to zero, corresponding to non depolarizing particles or liquid droplets, while values of (16 2)% and (45 3)% were observed in the ash plume emitted from North-East Crater, in the morning and in the afternoon, respectively. The retrieved values of volcanic aerosol depolarization ratio, aerosol backscattering and lidar-ratio allowed distinguishing the changes in the properties of the emitted aerosol. Furthermore, the ash mass concentration at source was estimated, reaching a maximum value of 24,000 6000 mg m 3, with an additional systematic uncertainty of 50% related to the assumption of an effective radius of 10 mm for ash particles188 25 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Open Access , Realizzazione di una stazione fissa per misure LIDAR sull’Etna
(2011-04-20); ; ; ; Realizzazione di una stazione fissa per misure LIDAR sull’Etna156 170
