Skip to main content
The search returned 4 results
Now showing 1 - 4 of 4
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Thermal weakening of the carbonate basement under Mt. Etna volcano (Italy): Implications for volcano instability

    The physical integrity of a sub-volcanic basement is crucial in controlling the stability of a volcanic edifice. For many volcanoes, this basement can comprise thick sequences of carbonates that are prone to significant thermally-induced alteration. These debilitating thermal reactions, facilitated by heat from proximal magma storage volumes, promote the weakening of the rock mass and likely therefore encourage edifice instability. Such instability can result in slow, gravitational spreading and episodic to continuous slippage of unstable flanks, and may also facilitate catastrophic flank collapse. Understanding the propensity of a particular sub-volcanic basement to such instability requires a detailed understanding of the influence of high temperatures on the chemical, physical, and mechanical properties of the rocks involved. The juxtaposition of a thick carbonate substratum and magmatic heat sources makes Mt. Etna volcano an ideal candidate for our study. We investigated experimentally the effect of temperature on two carbonate rocks that have been chosen to represent the deep, heterogeneous sedimentary substratum under Mt. Etna volcano. This study has demonstrated that thermal-stressing resulted in a progressive and significant change in the physical properties of the two rocks. Porosity, wet (i.e., water-saturated) dynamic Poisson's ratio and wet Vp/Vs ratio all increased, whilst P- and S-wave velocities, bulk sample density, dynamic and static Young's modulus, dry Vp/Vs ratio, and dry dynamic Poisson's ratio all decreased. At temperatures of 800 °C, the carbonate in these rocks completely dissociated, resulting in a total mass loss of about 45% and the release of about 44 wt.% of CO2. Uniaxial deformation experiments showed that high in-situ temperatures (>500 °C) significantly reduced the strength of the carbonates and altered their deformation behaviour. Above 500 °C the rocks deformed in a ductile manner and the output of acoustic emissions was greatly reduced. We speculate that thermally-induced weakening and the ductile behaviour of the carbonate substratum could be a key factor in explaining the large-scale deformation observed at Mt. Etna volcano. Our findings are consistent with several field observations at Mt. Etna volcano and can quantitatively support the interpretation of (1) the irregularly low seismic velocity zones present within the sub-volcanic sedimentary basement, (2) the anomalously high CO2 degassing observed, (3) the anomalously high Vp/Vs ratios and the rapid migration of fluids, and (4) the increasing instability of volcanic edifices in the lifespan of a magmatic system. We speculate that carbonate sub-volcanic basement may emerge as one of the decisive fundamentals in controlling volcanic stability.
      158  23
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Decarbonation and thermal microcracking under magmatic P-T-fCO2 conditions: the role of skarn substrata in promoting volcanic instability

    We present a systematic study on the influence of pressure (0.1–600 MPa), temperature (750– 1200 ◦C), carbon dioxide fugacity (logfCO2 = −4.41 to 3.60) and time (2–12 hr) on the chemical and physical properties of carbonate rock. Our experiments aim to reproduce the conditions at the periphery of magma chamber where carbonate host rock is influenced by, but not readily assimilated by, magma. This permits the investigation of the natural conditions at which circulating fluids/gases promote infiltration reactions typical of metasomatic skarns that can involve large volumes of subvolcanic carbonate basements. Results show that, providing that carbon dioxide is retained in the pore space, decarbonation does not proceed at any magmatic pressure and temperature. However, when the carbon dioxide is free to escape, decarbonation can occur rapidly and is not hindered by a low initial porosity or permeability. Together with carbon dioxide and lime, portlandite, a mineral commonly found in voluminous metasomatic skarns, readily forms during carbonate decomposition. Post-experimental analyses highlight that thermal microcracking, a result of the highly anisotropic thermal expansion of calcite, exerts a greater influence on rock physical properties (porosity, ultrasonic wave velocities and elastic moduli) than decarbonation. Our data suggest that this will be especially true at the margins of dykes or magma bodies, where temperatures can reach up to 1200 ◦C. However, rock compressive strength is significantly reduced by both thermal cracking and decarbonation, explained by the relative weakness of lime + portlandite compared to calcite, and an increase in grain size with increasing temperature. Metasomatic skarns, whose petrogenetic reactions may involve a few tens of cubic kilometres, could therefore represent an important source of volcanic instability.
      216  31
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    The partitioning of trace elements between clinopyroxene and trachybasaltic melt during rapid cooling and crystal growth

    We present the variation in trace element partition coefficients measured at the interface between rapidly cooled clinopyroxene crystals and co-existing melts. Results indicate that, as the cooling rate is increased, clinopyroxene crystals are progressively depleted in Si, Ca and Mg counterbalanced by enrichments in Al (mainly tetrahedral Aliv), Na and Ti. Partition coefficients (Ds) for rare earth elements (REE), high field strength elements (HFSE) and transition elements (TE) increase with increasing cooling rate, in response to clinopyroxene compositional variations. The entry of REE into the M2 site is facilitated by a coupled substitution where either Na substitutes for Ca on the M2 site or Aliv substitutes for Si in the tetrahedral site. The latter substitution reflects an increased ease of locally balancing the excess charge at M2 as the number of surrounding Aliv atoms increases. Due to the lower concentration of Ca in rapidly cooled clinopyroxenes, divalent large ion lithophile elements (LILE) on M2 decrease at the expense of monovalent cations. Conversely, higher concentrations of HFSE and TE on the M1 site are facilitated as the average charge on this site increases with the replacement of divalent-charged cations by Alvi. Although crystallization kinetics modify clinopyroxene composition, deviations from equilibrium partitioning are insufficient to change the tendency of a trace element to be compatible or incompatible. Consequently, there are regular relationships between ionic radius, valence of the trace element and D. At both equilibrium and cooling rate conditions, Ds for isovalent cations define parabola-like curves when plotted against ionic radius, consistent with the lattice strain model, demonstrating that the partitioning of trace elements is driven by charge balance mechanisms; cation substitution reactions can be treated in terms of the energetics of the various chargeimbalanced configurations.
      186  41
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Unraveling the solidification path of a pahoehoe "cicirara" lava from Mount Etna volcano

    The solidified surface of a lava flow reflects the viscosity of its molten fraction and the crystal content during flow; crystal-poor basaltic lavas produce pahoehoe fields, whereas crystal-rich ones solidify with aa carapaces. At Mount Etna, volcano aa morphologies are very common, whereas pahoehoe lavas are rare. The latter are locally named “cicirara” due to the presence of centimeter-sized plagioclase phenocrysts much more abundant than in aa lavas. The phenocryst content of “cicirara” lavas contrasts with the low viscosity generally associated with pahoehoe morphology. Therefore, to reconcile the discrepancy between textural and volcanic observations, we have studied the most primitive pahoehoe “cicirara” lava sampled until now. Two samples at 0.5 and 1 m from the bottom of the 2- m thick lava flow were investigated on the basis of their mineral compositional variations and textural features, i.e., size frequency and crystal size distribution (CSD). Results coupled with rheological models indicate that only large phenocrysts of plagioclase (>1 mm) and clinopyroxene have grown before eruption. Thermobarometric models and petrological computations based on the composition of plagioclase and clinopyroxene phenocryst cores highlight that only a small amount (10–15 vol.%) of crystals equilibrated at 12 km of depth. Cumulative size frequency and CSD data also indicate that plagioclase and clinopyroxene phenocryst rims grew heterogeneously and coalesced around their cores at depths <1 km, before eruption. In this view, the “cicirara” lava was erupted with a low crystalline content that favoured the formation of its pahoehoe surface; however, crystals with a size <1 mm (~75 vol.%) solidified at post-eruptive conditions. Our findings underline that the emplacement of high-viscosity aa or low-viscosity pahoehoe lavas is driven by the degree of undercooling imposed by the volatile exsolution rate in the shallowest portion of the Etnean plumbing system. A slow magma ascent rate promotes significant intratelluric degassing and widespread nucleation; consequently, the viscosity of the suspension significantly increases leading to an aa morphology. In contrast, pahoehoe “cicirara” lavas are associated with a rapid rise to the surface of poorly degassed, undercooled magmas.
      209  35