Skip to main content
The search returned 2 results
Now showing 1 - 2 of 2
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Open Access ,

    Statistical investigation of site ef f ects with emphasis on sedimentary basins, using earthquake and ambient noise recordings

    During the last two decades, three empirical methods for assessing site effects have been widely used: the Standard Spectral Ratio (SSR), the Horizontal-to-Vertical Spectral Ratio from earthquake recordings (HVSR) and the Horizontal-to-Vertical Spectral Ratio from ambient noise recordings (HVN). The SSR is considered the reference empirical method to detect amplification as a function of frequency, while the HVSR and the HVN realistically indicate fundamental frequency but, for the majority of the worldwide examined sites, they cannot give reliable amplification curves as a function of frequency. Given the fact that HVSR and especially HVN can be easily obtained, it is challenging to search for any correlation with SSR amplification functions. We used recordings from 168 sites worldwide, for which all three types of spectral ratios were homogeneously processed (Haghsenas et al., Bull. Earthquake Eng. 2008). On this data set we applied standard multivariate statistical analyses, namely, factor analysis and canonical correlation, to investigate and quantify -where it is possible- any correlation between spectral ratios for a certain number of the examined frequency bins. Results show that the correlation between HVN and HVSR is very good. Moreover, their correlation with broad band SSR can be statistically quantified and receive a satisfactory physical explanation. In addition, we looked for the correlation of SSR, HVSR and HVN collected in sedimentary basins (a subset of the previous database) with geometrical and geophysical parameters. T hese attempts were constrained by the limited amount of reliable in-situ data. Among many, we select 5 parameters: Vs30, Hb, Vs_average/Hb, Hb/W_valley, Hb/W_edge (where Hb is the bedrock’s depth below the station; Vs_average is the average Vs from surface to bedrock; W_valley is 2D-width of the valley; W_edge is the distance from the closest valley’s edge). T he analysis assesses that larger are the first 4 parameters, larger is the low-frequency amplification in HVSR and HVN, and lower the high-frequency contribution. Although additional data would improve our statistical investigation and better establish quantitative correlation between spectral ratios and geophysical or/and geometrical characteristics of sedimentary basins, our results clearly show that statistical correlation between SSR and HVN-HVSR is present and modulated in specific frequency domains. T his study has been performed in the framework of the T oK IT SAK-GR EC project (2006-2010).
      119  242
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Empirical evaluation of microtremor H/V spectral ratio

    The objective of this work is to perform a purely empirical assessment of the actual capabilities of the horizontal-to-vertical (H/V) spectral ratio technique to provide reliable and relevant information concerning site conditions and/or site amplification. This objective has been tackled through the homogeneous (re)processing of a large volume of earthquakes and ambient noise data recorded by different research teams in more than 200 sites located mainly in Europe, but also in the Caribbean and in Tehran. The original recordings were first gathered in a specific database with information on both the sites and recorded events. Then, for all sites close to an instrumented reference, average site-to-reference spectral ratios (“spectral ratio method” (SSR)) were derived in a homogeneous way (window selection, smoothing, signal-to-noise ratio threshold, averaging), as well as H/V ratios (“HVSRE–RF”) on earthquake recordings. H/V ratios were also obtained from noise recordings at each site (either specific measurements, or extracted from pre- or post-event noise windows). The spectral curves resulting from these three techniques were estimated reliable for a subset of 104 sites, and were thus compared in terms of fundamental frequency, amplitude and amplification bandwidth, exhibiting agreements and disagreements, for which interpretations are looked for in relation with characteristics of site conditions. The first important result consists in the very good agreement between fundamental frequencies obtained with either technique, observed for 81% of the analyzed sites. A significant part of the disagreements correspond to thick, low frequency, continental sites where natural noise level is often very low and H/V noise ratios do not exhibit any clear peak. The second important result is the absence of correlation between H/V peak amplitude and the actual site amplification measured on site-to-reference spectral ratios. There are, however, two statistically significant results about the amplitude of the H/V curve: the peak amplitude may be considered as a lower bound estimate of the actual amplification indicated by SSR (it is smaller for 79% of the 104 investigated sites), and, from another point of view, the difference in amplitude exhibits a questioning correlation with the geometrical characteristics of the sediment/basement interface: large SSR/HV differences might thus help to detect the existence of significant 2D or 3D effects.
      271  31