Padova Univ.
2 results
Filters
Settings
The search returned 2 results
Now showing 1 - 2 of 2
- Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , The effects of fault orientation and fluid infiltration on fault rock assemblages at seismogenic depths
(2009); ; ; ;Mittempergher, S.; Padova Univ.Pennacchioni, G.; Padova Univ.The factors controlling the development of different types of fault rock assemblages and, more specifically, the formation of friction melts are still not fully understood. In this study we compared two exhumed strike–slip faults in the Adamello batholith (Southern Alps): the Gole Larghe and the Passo Cercen fault zones, active at 9–11 km depth and temperatures of 250–300 C. Each fault zone consists of hundreds of sub-parallel strands exploiting pre-existing joints. The Gole Larghe fault strikes N105 5 and is dextral; the fault rocks are cataclasites and widespread, centimetre-thick pseudotachylytes. The Passo Cercen fault strikes on average N130 and is formed by multiple fault horizons: fault segments striking N105 –N130 are mainly dextral, whereas faults striking N135 –N140 are mainly sinistral. Microstructural, mineralogical and geochemical investigations show that the fault rocks are cataclasites associated with thick epidote þ K-feldspar þ quartz veins and rare, millimetre-thick pseudotachylytes. Field evidence suggests that in both fault zones, the direction of the maximum horizontal stress s1 was N135 . The Gole Larghe fault strikes at about 30 to s1 and is favourably oriented for reactivation. By contrast, the Passo Cercen fault strikes at low angles to s1 and is unfavourably oriented for reactivation, therefore requiring the development of high pore pressures, as suggested by the occurrence of extensive epidote veining and hydraulic breccias. It is proposed that frictional melting in the Passo Cercen fault zone was inhibited by the development of high pore pressures and low effective normal stresses.165 25 - Some of the metrics are blocked by yourconsent settings
Item type:Publication, Access status: Restricted , Static stress drop associated with brittle slip events on exhumed faults.
We estimate the static stress drop on small exhumed strike-slip faults in the Lake Edison granodiorite of the central Sierra Nevada (California). The subvertical strike-slip faults were exhumed from 4 to 15 km depth and were chosen because they are exposed in outcrop along their entire tip-to-tip lengths of 8–12 m. Slip nucleated on joints and accumulated by crystal-plastic shearing (forming quartz mylonites from early quartz vein filling in joints) and successive brittle faulting (forming epidote-bearing cataclasites). The occurrence of thin, 300 mm wide, pseudotachylytes along some small faults throughout the study area suggests that some, if not all, of the brittle slip on the study area faults may have been seismic. We suggest that the contribution of brittle, cataclastic slip to the total slip along the studied cataclasite-bearing small faults may be estimated by the length of epidote-filled, rhombohedral dilatational jogs (rhombochasms) distributed quasi-periodically along the length of the faults. The interpretation that slip recorded by rhombochasms occurred in single events is based on evidence that (1) epidote crystals are randomly oriented and undeformed within the rhombochasm; (2) cataclasite in principal slip zones does not include clasts of previous cataclasite, and (3) rhombochasm lengths vary systematically along the length of the faults with slip maximum occurring near the fault center, tapering to the fault tips. We thereby constrain both the rupture length and slip. On the basis of these measurements, we calculate stress drops ranging over 90–250 MPa, i.e., one to two orders of magnitude larger than typical seismological estimates for earthquakes, but similar in magnitude to seismological estimates of small (<M2) earthquakes from the San Andreas Fault Observatory at Depth (SAFOD). The slip events described in the present study occurred along small, deep-seated faults, and, given the calculated stress drops and observations that brittle faults exploited joints sealed by quartz-bearing mylonite, we conclude that these were ‘‘strong’’ faults.159 27
