In flight fragmentation reduces bomb size range and hazard during explosive volcanic eruptions
Journal
SCIENTIFIC REPORTS
ISSN
2045-2322
Date Issued
2025-10-22
Author(s)
DOI
10.1038/s41598-025-20900-2
Abstract
Coarse, molten fragments of low-viscosity magma (volcanic bombs) that are ejected during explosive volcanic eruptions represent a source of hazard and a record of past eruptions. After ejection, bombs tend to break up during flight, but how much this affects their dispersal is unclear. Here, we use highspeed and high-definition imaging of three recent explosive eruptions to parameterise the in-flight fragmentation of bombs. We estimate that in-flight fragmentation involves 73% of bombs coarser than ∼ 0.2 m, with bomb-to-bomb collisions and aerodynamic frictional (drag) forces being the main drivers of in-flight fragmentation, depending on eruption style. Drag force increases with increasing bomb velocity and size, selectively fragmenting the coarsest and fastest bombs, acting as a selflimiting factor for the range and energy of falling bombs. These findings pose a quantitative basis for incorporating the in-flight fragmentation processes into the interpretation of volcanic deposits and for modelling hazards from falling bombs. Volcanic bombs are coarse (> 64 mm), variably molten fragments of low-viscosity magma ejected during explosive volcanic eruptions. Volcanic bombs travel along approximately ballistic trajectories, mainly controlled by the ejection velocity and angle acquired at the vent and friction with the surrounding fluid (volcanic gas jet or surrounding atmosphere) 1-5. Ejection angle and velocity being the same, coarser bombs will travel further due to their higher mass-to-surface ratio and corresponding higher inertia-to-friction ratio. In the eruption of relatively hot and low-viscosity mafic magmas, such as basalt, bombs remain mostly fluid during their ballistic transport. This increases the potential for in-flight deformation and fragmentation to alter bomb size, trajectory, and, eventually, the associated hazards and deposit features 5-11. Despite its relevance, however, in-flight bomb break-up is poorly described qualitatively and quantitatively, with a few exceptions 5,12. The fallout of volcanic bombs represents one of the most significant hazards in the range of a few kilometres from the vent of explosively erupting volcanoes, often associated with small and unexpected eruptions 13-15. It affects both visiting tourists and scientists conducting measurements in high-risk zones, with examples from Stromboli and Etna (Italy) and Yasur (Vanuatu) volcanoes 16-19. Bombs have been documented to reach distances of 2-5 km from the vent, and up to 10 km 7,13,17,20-22 Bombs also pose a significant economic threat, damaging infrastructure and buildings 14,17,23,24. Field-and drone-based studies on the dispersal and grain-size distribution of bomb deposits are crucial to understand the dynamics of past eruptions and the definition of hazard maps 7,12,19,22,25-31. Ballistic dispersion modelling is often used for hazard forecast and to infer exit velocity during past explosive eruptions 2,4,26,32-34. Up to now, however, neither modelling or deposit interpretation schemes take into account in-flight bomb fragmentation. Here, we analysed high-speed and high-definition videos of three recent explosive eruptions to qualitatively and quantitatively characterise the in-flight fragmentation of fluidal bombs. Case studies To cover a range of volcanoes and styles in low-viscosity magma explosive activity, four case studies are the focus of this inquiry (Fig. 1). The first two case studies are the fountaining activity (Fig. 1a) and the spattering
