Skip to main content
The search returned 3 results
Now showing 1 - 3 of 3
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Scaling transition in earthquake sources: a possible link between seismic and laboratory measurements

    We estimate the corner frequencies of 20 crustal seismic events from mainshock–aftershock sequences in different tectonic environments (mainshocks 5.7<=MW<=7.6) using the well-established seismic coda ratio technique (MAYEDA et al., 2007; MAYEDA and MALAGNINI, 2010), which provides optimal stability and does not require path or site corrections. For each sequence, we assumed the Brune source model and estimated all the events’ corner frequencies and associated apparent stresses following the MDAC spectral formulation of WALTER and TAYLOR (A revised magnitude and distance amplitude correction (MDAC2) procedure for regional seismic discriminants, 2001), which allows for the possibility of non-self-similar source scaling. Within each sequence, we observe a systematic deviation from the self-similar M0 ~ fc^-3 line, all data being rather compatible with M0 ~ fc ^ -(3+epsilon) c , where epsilon>0 (KANAMORI and RIVERA, 2004). The deviation from a strict self-similar behavior within each earthquake sequence of our collection is indicated by a systematic increase in the estimated average static stress drop and apparent stress with increasing seismic moment (moment magnitude). Our favored physical interpretation for the increased apparent stress with earthquake size is a progressive frictional weakening for increasing seismic slip, in agreement with recent results obtained in laboratory experiments performed on state-of-the-art apparatuses at slip rates of the order of 1 m/s or larger. At smaller magnitudes (MW<5.5), the overall data set is characterized by a variability in apparent stress of almost three orders of magnitude, mostly from the scatter observed in strike-slip sequences. Larger events (MW>5.5) show much less variability: about one order of magnitude. It appears that the apparent stress (and static stress drop) does not grow indefinitely at larger magnitudes: for example, in the case of the Chi–Chi sequence (the best sampled sequence between MW 5 and 6.5), some roughly constant stress parameters characterize earthquakes larger than MW = 5.5. A representative fault slip for MW 5.5 is a few tens of centimeters (e.g., IDE and TAKEO, 1997), which corresponds to the slip amount at which effective lubrication is observed, according to recent laboratory friction experiments performed at seismic slip velocities (V ~ 1 m/s) and normal stresses representative of crustal depths (DI TORO et al. , 2011, and references therein). If the observed deviation from self-similar scaling is explained in terms of an asymptotic increase in apparent stress (MALAGNINI et al., 2014, this volume), which is directly related to dynamic stress drop on the fault, one interpretation is that for a seismic slip of a few tens of centimeters (MW ~ 5.5) or larger, a fully lubricated frictional state may be asymptotically approached.
      240  32
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    How to Invert Multi-Band, Regional Phase Amplitudes for 2-D Attenuation and Source Parameters: Tests Using the USArray

    (2014) ; ; ;
    Phillips, W. S.; LANL
    ;
    Mayeda, K. M.; UC Berkeley
    We inverted for laterally varying attenuation, absolute site terms, moments and apparent stress using over 460,000 Lg amplitudes recorded by the USArray for frequencies between 0.5 and 16 Hz. Corner frequencies of Wells, Nevada, aftershocks, obtained by independent analysis of coda spectral ratios, controlled the tradeoff between attenuation and stress, while independently determined moments from St. Louis University and the University of California constrained absolute levels. The quality factor, Q, was low for coastal regions and interior volcanic and tectonic areas, and high for stable regions such as the Great Plains, and Colorado and Columbia Plateaus. Q increased with frequency, and the rate of increase correlated inversely with 1-Hz Q, with highest rates in low-Q tectonic regions, and lowest rates in high-Q stable areas. Moments matched independently determined moments with a scatter of 0.2 NM. Apparent stress ranged from below 0.01 to above 1 MPa, with means of 0.1 MPa for smaller events, and 0.3 MPa for larger events. Stress was observed to be spatially coherent in some areas; for example, stress was lower along the San Andreas fault through central and northern California, and higher in the Walker Lane, and for isolated sequences such as Wells. Variance reduction relative to 1-D models ranged from 50 to 90 % depending on band and inversion method. Parameterizing frequency dependent Q as a power law produced little misfit relative to a collection of independent, multi-band Q models, and performed better than the omega-square source parameterization in that sense. Amplitude residuals showed modest, but regionally coherent patterns that varied from event to event, even between those with similar source mechanisms, indicating a combination of focal mechanism, and near source propagation effects played a role. An exception was the Wells mainshock, which produced dramatic amplitude patterns due to its directivity, and was thus excluded from the inversions. The 2-D Q plus absolute site models can be used for high accuracy, broad area source spectra, magnitude and yield estimation, and, in combination with models for all regional phases, can be used to improve discrimination, in particular for intermediate bands that allow coverage to be extended beyond that available for high frequency P-to-S discriminants.
      212  40
  • Some of the metrics are blocked by your 
    Item type:Publication, Access status: Restricted ,

    Gradual fault weakening with seismic slip: inferences from the seismic sequences of L'Aquila, 2009 and Northridge, 1994

    We estimate seismological fracture energies from two subsets of events selected from the seismic sequences of L’Aquila (2009), and Northridge (1994): 57 and 16 selected events, respectively, including the main shocks. Following ABERCROMBIE and RICE (2005), we postulate that fracture energy (G) represents the post-failure integral of the dynamic weakening curve, which is described by the evolution of shear traction as a function of slip. Following a direct-wave approach, we compute mainshock-/aftershock-source spectral ratios, and analyze them using the approach proposed by MALAGNINI et al. (this issue, 2014) to infer corner frequencies and seismic moment. Our estimates of source parameters (including fracture energies) are based on best-fit grid searches performed over empirical source spectral ratios. We quantify the source scaling of spectra from small and large earthquakes by using the MDAC formulation of WALTER and TAYLOR (2001). The source parameters presented in this paper must be considered as point source estimates representing averages calculated over specific ruptured portions of the fault area. In order to constrain the scaling of fracture energy with coseismic slip, we investigate two different slip-weakening functions to model the shear traction as a function of slip: (i) a power law, as suggested by ABERCROMBIE and RICE (2005), and (ii) an exponential decay. Our results show that the exponential decay of stress on the fault allows a good fit between measured and predicted fracture energies, both for the main events and for their aftershocks, regardless of the significant differences in the energy budgets between the large (main) and small earthquakes (aftershocks). Using the power-law slip-weakening function would lead us to a very different situation: in our two investigated sequences, if the aftershock scaling is extrapolated to events with large slips, a power law (a la Abercrombie and Rice) would predict unrealistically large stress drops for large, main earthquakes. We conclude that the exponential stress evolution law has the advantage of avoiding unrealistic stress drops and unbounded fracture energies at large slip values, while still describing the abrupt shear-stress degradation observed in high-velocity laboratory experiments (e.g., DI TORO et al., 2011).
      278  22