Baron, Ludovic

We present results from a joint inversion of new seismic and recently compiled gravity data to constrain the structure of a prominent geophysical anomaly in the European Alps: the Ivrea Geophysical Body (IGB). We investigate the IGB structure along the West-East oriented Val Sesia profile at higher resolution than previous studies. We deployed 10 broadband seismic stations at 5 km spacing for 27 months, producing a new database of ∼1000 high-quality seismic receiver functions (RFs). The compiled gravity data yields 1 gravity point every 1–2 km along the profile. We set up an inversion scheme, in which RFs and gravity anomalies jointly constrain the shape and the physical properties of the IGB. We model the IGB’s top surface as a single density and shear-wave velocity discontinuity, whose geometry is defined by four, spatially variable nodes between far-field constraints. An iterative algorithm was implemented to efficiently explore the model space, directing the search toward better fitting areas. For each new candidate model, we use the velocity-model structures for both ray-tracing and observed-RFs migration, and for computation and migration of synthetic RFs: the two migrated images are then compared via cross-correlation. Similarly, forward gravity modeling for a 2D density distribution is implemented. The joint inversion performance is the product of the seismic and gravity misfits. The inversion results show the IGB protruding at shallow depths with a horizontal width of ∼30 km in the western part of the profile. Its shallowest segment reaches either 3–7 or 1–3 km depth below sea-level. The latter location fits better the outcropping lower crustal rocks at the western edge of the Ivrea-Verbano Zone. A prominent, steep eastward-deepening feature near the middle of the profile, coincident with the Pogallo Fault Zone, is interpreted as inherited crustal thickness variation. The found density and velocity contrasts of the IGB agree with physical properties of the main rock units observed in the field. Finally, by frequency-dependent analysis of RFs, we constrain the sharpness of the shallowest portion of the IGB velocity discontinuity as a vertical gradient of thickness between 0.8 km and 0.4 km.

Volcanic risk at Vesuvius is one of the highest in the world due to the ~670,000 inhabitants living in the Red Zone, the area exposed to both pyroclastic flows and tephra fallout, to be evacuated before renewal of any eruptive activity. The national emergency plan for Vesuvius builds its risk zonation on a scenario similar to the last sub-Plinian eruption, which occurred in 1631. This study aims at providing new insights on the geometry of the caldera associated with this historical eruption. The impact of past Vesuvius eruptions on present-day soil CO2 concentration has been investigated by means of an extended geochemical survey carried out for identifying the circulation pathways of hydrothermal fluids inside the volcano. We performed 4,018 soil CO2 concentration measurements over the whole Somma-Vesuvius volcanic complex, covering an area of 50 km2. Besides relatively low values, the results show a significant spatial CO2 concentration heterogeneity over Somma-Vesuvius ranging from the atmospheric value (~400 ppm) up to ~24,140 ppm. The summit of Vesuvius shows an area with anomalous CO2 concentrations well matching the crater rim of the 1906 eruption. Along the cone flanks, secondary CO2 anomalies highlight a roughly circular preferential pathway detected along 8 radial profiles at distances between ~840 m and ~1,150 m from the bottom of the present-day crater resulting from the last eruption in 1944. In depth review of the available literature highlights an agreement between this circle-like shaped anomaly and the 1631 sub-Plinian eruption caldera boundary. Indeed, based on the historical chronicles the depression produced by the 1631 eruption had a diameter of 1,686 m, whereas the CO2 circular anomaly indicates a diameter of 1,956 m. Finally, the results were compared with a 3-D density model obtained from a recent gravity survey that corroborates both the literature and the CO2 data in terms of potential buried structure at the base of the Vesuvius cone.

Existing 3-D density models of the Somma-Vesuvius volcanic complex (SVVC), Italy, largely disagree. Despite the scientific and socioeconomic importance of Vesuvius, there is no reliable 3-D density model of the SVVC. A considerable uncertainty prevails concerning the presence (or absence) of a dense body underlying the Vesuvius crater (1944 eruption) that is implied from extensive seismic investigations. We have acquired relative gravity measurements at 297 stations, including measurements in difficult-to-access areas (e.g., the first-ever measurements in the crater). In agreement with seismic investigations, the simultaneous inversion of these and historic data resolves a high-density body that extends from the surface of the Vesuvius crater down to depths that exceed 2 km. A 1.5-km radius horseshoe-shaped dense feature (open in the southwestern sector) enforces the existing model of groundwater circulation within the SVVC. Based on its volcano-tectonic evolution, we interpret volcanic structures that have never been imaged before.

We present the first density model of Stromboli volcano (Aeolian Islands, Italy) obtained by simultaneously inverting land-based (543) and sea-surface (327) relative gravity data. Modern positioning technology, a 1 × 1 m digital elevation model, and a 15 × 15m bathymetric model made it possible to obtain a detailed 3-D density model through an iteratively reweighted smoothness-constrained least-squares inversion that explained the land-based gravity data to 0.09 mGal and the sea-surface data to 5 mGal. Our inverse formulation avoids introducing any assumptions about density magnitudes. At 125 m depth from the land surface, the inferred mean density of the island is 2380 kg m−3, with corresponding 2.5 and 97.5 percentiles of 2200 and 2530 kg m−3. This density range covers the rock densities of new and previously published samples of Paleostromboli I, Vancori, Neostromboli and San Bartolo lava flows. High-density anomalies in the central and southern part of the island can be related to two main degassing faults crossing the island (N41 and N64) that are interpreted as preferential regions of dyke intrusions. In addition, two low-density anomalies are found in the northeastern part and in the summit area of the island. These anomalies seem to be geographically related with past paroxysmal explosive phreato-magmatic events that have played important roles in the evolution of Stromboli Island by forming the Scari caldera and the Neostromboli crater, respectively. © 2014 Elsevier B.V. All rights reserved.

While well logging, a continuous recording of the physical parameters down a borehole, is employed systematically in petroleum exploration, its application in environmental prospections, such as hydrogeology or civil engeering, has been very limited. This deficiency is partly due to the fact that logging probes used in this kind of boreholes are generally not calibrated and the results are more or less qualitative. The purpose of this lecture is to show that it is possible to calibrate these tools in order to obtain quantitative results, to make available to geologists, engineers and technicians engaged in shallow exploration, the information required for effectively applying the well-logging method.