Montanaro, Cristian

Solfatara crater is locatedwithin the Campi Flegrei caldera to the west of Naples (Italy). It is one of the largest fumarolic manifestations known, and the rocks hosting the hydrothermal system are affected by intense hydrothermal alteration. Alteration can result in changes of degassing behavior, and in the formation of a cap rock thereby increasing the probability of phreatic eruptions. Here, we investigate the effects of alunitic (solfataric) alteration on the mineralogy, the physical properties (porosity, density, permeability) and the mechanical properties (strength) of the rocks involved, aswell as its influence on fragmentation and ejection behavior. Our results showthat the pristine mineralogy of deposits fromthe vicinity of the Solfatara cryptodome and from Pisciarelli is almost completely replaced by amorphous silica and alunite. The differences in the degree of alteration among the samples series are reflected in the investigated properties and behavior aswell as in the analysis of the experimentally generated particles. Alunitic alteration increases porosity and permeability,whereas it reduces density, elastic wave velocity and strength leading to higher fragmentation and ejection speeds for the sample series examined in this study. Our results also show that alteration results in the generation of a high fraction of fines (particle sizes b10 μm) during fragmentation, mainly composed of alunite crystals. Due to their potential for inducing chronic disease, dispersion of such material should represent a serious health hazard on a local scale and the evaluation of precautions should be considered.

Steam-driven eruptions, both phreatic and hydrothermal, expel exclusively fragments of nonjuvenile rocks disintegrated by the expansion of water as liquid or gas phase. As their violence is related to the magnitude of the decompression work that can be performed by fluid expansion, these eruptions may occur with variable degrees of explosivity. In this study we investigate the influence of liquid fraction and rock petrophysical properties on the steam-driven explosive energy. A series of fine-grained heterogeneous tuffs from the Campi Flegrei caldera were investigated for their petrophysical properties. The rapid depressurization of various amounts of liquid water within the rock pore space can yield highly variable fragmentation and ejection behaviors for the investigated tuffs. Our results suggest that the pore liquid fraction controls the stored explosive energy with an increasing liquid fraction within the pore space increasing the explosive energy. Overall, the energy released by steam flashing can be estimated to be 1 order of magnitude higher than for simple (Argon) gas expansion and may produce a higher amount of fine material even under partially saturated conditions. The energy surplus in the presence of steam flashing leads to a faster fragmentation with respect to gas expansion and to higher ejection velocities imparted to the fragmented particles. Moreover, weak and low permeability rocks yield a maximum fine fraction. Using experiments to unravel the energetics of steam-driven eruptions has yielded estimates for several parameters controlling their explosivity. These findings should be considered for both modeling and evaluation of the hazards associated with steam-driven eruptions.

The Solfatara area and its fumaroles are the main surface expression of the vigorous hydrothermal activity within the active Campi Flegrei caldera system. At depth, a range of volcanic and structural processes dictate the actual state of the hydrothermal system below the crater. The presence of a large variety of volcanic products at shallow depth (including pyroclastic fallout ash beds, pyroclastic density current deposits, breccias, and lavas), and the existence of a maar-related fault system appears to exert major controls on the degassing and alteration behavior. Adding further to the complexity of this environment, variations in permeability and porosity, due to subsoil lithology and alteration effects, may further influence fluid flow towards the surface. Here, we report results from a field campaign conducted in July 2015 that was designed to characterize the in situ physical (temperature, humidity) and mechanical (permeability, strength, stiffness) properties of the Solfatara crater subsoil. The survey also included a mapping of the surficial hydrothermal features and their distributions. Finally, laboratory measurements (porosity, granulometry) of selected samples were performed. Our results enable the discrimination of four main subsoils around the crater: (1) the Fangaia domain located in a topographic low in the southwestern sector, (2) the silica flat domain on the western altered side, (3) the new crust domain in the central area, and (4) the crusted hummocks domain that dominates the north, east, and south parts. These domains are surrounded by encrusted areas, reworked material, and vegetated soil. The distribution of these heterogeneous subsoils suggests that their formation is mostly related to (i) the presence of the Fangaia domain within the crater and (ii) a system of ring faults bordering it. The subsoils show an alternation between very high and very low permeabilities, a fact which seems to affect both the temperature distribution and surficial degassing. A large range of surface temperatures (from 25 up to 95 °C) has been measured across these surfaces, with the hottest spot corresponding to the mud pools, the area of new crust formation, and the crusted hummocks. In the subsoil, the distribution of temperature is more complex and controlled by the presence of coarser, and more permeable, sandy/pebbly levels. These act as preferential pathways for hot hydrothermal fluid circulation. In contrast, low permeability, fine-grained levels act as thermal insulators that remain relatively cold and hinder fluid escape to the surface. Hot gases reach the surface predominantly along (vertical) fractures. When this occurs, mound-like structures can be formed by a cracking and healing process associated with significant degassing. It is anticipated that the results presented here may contribute to an improved understanding of the hazard potential associated with the ongoing hydrothermal activity within the Solfatara crater. At this site the permeability of the near-surface environment and its changes in space and time can affect the spatial and temporal distribution of gas and heat emission. Particularly, in areas where reduction in permeability occurs, it can produce pore pressure augmentation that may result in explosive events.

The recent Eyjafjallajökull (Iceland) eruption strikingly under-lined the vulnerability of a globalized society to the atmospheric dispersal of volcanic clouds from even moderate-size eruptions. Ash aggregation controls volcanic clouds dispersal by prematurely remov-ing fi ne particles from the cloud and depositing them more proxi-mally. Physical parameters of ash aggregates have been modeled and derived from ash fallout deposits of past eruptions, yet aggregate sedimentation has eluded direct measurement, limiting our ability to predict the dispersal of volcanic clouds. Here we use fi eld-based, high-speed video analysis together with laboratory experiments to provide the fi rst in situ investigation and parameterization of the physical fea-tures and settling dynamics of ash aggregates from a volcanic cloud. In May 2010, high-speed video footage was obtained of both ash par-ticles and aggregates settling from the Eyjafjallajökull volcano erup-tion cloud at a distance of 7 km from the vent; fallout samples were collected simultaneously. Experimental laboratory determinations of the density, morphology, and settling velocity of individual ash par-ticles enable their distinction from aggregates. The combination of fi eld and experimental analyses allows a full characterization of the size, settling velocity, drag coeffi cient, and density distributions of ash aggregates as well as the size distribution of their component par-ticles. We conclude that ash aggregation resulted in a tenfold increase in mass sedimentation rate from the cloud, aggravating the ash haz-ard locally and modifying cloud dispersal regionally. This study pro-vides a valuable tool for monitoring explosive eruptions, capable of providing robust input parameters for models of cloud dispersal and consequent hazard forecast

We report combined measurements of petrophysical and geophysical parameters for a 501-mdeep borehole located on the eastern side of the active Campi Flegrei caldera (Southern Italy), namely (i) in situ permeability by pumping tests, (ii) laboratory-determined permeability of the drill core, and (iii) thermal gradients by distributed fiber optic and thermocouple sensors. The borehole was drilled during the Campi Flegrei Deep Drilling Project (in the framework of the International Continental Scientific Drilling Program) and gives information on the least explored caldera sector down to pre-caldera deposits. The results allow comparative assessment of permeability obtained from both borehole (at depth between 422 a 501 m) and laboratory tests (on a core sampled at the same depth) for permeability values of ~10−13 m2 (borehole test) and ~10−15 m2 (laboratory test) confirm the scale-dependency of permeability at this site. Additional geochemical and petrophysical determinations (porosity, density, chemistry, mineralogy and texture), together with gas flow measurements, corroborate the hypothesis that discrepancies in the permeability values are likely related to in-situ fracturing. The continuous distributed temperature profile points to a thermal gradient of about 200 °C km−1. Our findings (i) indicate that scale-dependency of permeability has to be carefully considered in modelling of the hydrothermal system at Campi Flegrei, and (ii) improve the understanding of caldera dynamics for monitoring and mitigation of this very high volcanic risk area.